Increase in the Intracellular Bulk Water Content in the Early Phase of Cell Death of Keratinocytes,Corneoptosis, as Revealed by 65 GHz Near-Field CMOS Dielectric Sensor

While bulk water and hydration water coexist in cells to support the expression of biological macromolecules, how the dynamics of water molecules, which have long been only a minor role in molecular biology research, relate to changes in cellular states such as cell death has hardly been explored so far due to the lack of evaluation techniques. In this study, we developed a high-precision measurement system that can discriminate bulk water content changes of ±0.02% (0.2 mg/cm³) with single-cell-level spatial resolution based on a near-field CMOS dielectric sensor operating at 65 GHz. We applied this system to evaluate the temporal changes in the bulk water content during the cell death process of keratinocytes, called corneoptosis, using isolated SG1 (first layer of stratum granulosum) cells in vitro. A significant irreversible increase in the bulk water content was observed approximately 1 h before membrane disruption during corneoptosis, which starts with cytoplasmic high Ca²⁺ signal. These findings suggest that the calcium flux may have a role in triggering the increase in the bulk water content in SG1 cells. Thus, our near-field CMOS dielectric sensor provides a valuable tool to dissect the involvement of water molecules in the various events that occur in the cell.     

A frequency response model in multiquantum well lasers with unequilibrium carrier transport

A carrier transport model to explain the high-frequency response in high-speed MQW lasers is described. The ambipolar approximation, which is unsuitable for dealing with the high-speed carrier dynamics in MQW structures, was not adopted for small-signal analysis. The carrier transport effect can be characterized by four time constants: the electron transport time, _bmn; the hole transport time, _bmp; the electron escape time, _wbn; and the hole escape time, _wbp. The frequency response was interpreted as the sum of the constant response term due to the fast electron current and the roll-off term due to the slow hole transport time. The ratio of the electron contribution to the total response was proportional to the ratio of electron contribution to the total differential gain, , and reciprocally proportional to _n0 = 1 + _bmn/_wbn. The value of was calculated to be about 0.5 for typical MQW lasers. The roll-off frequency is mainly determined by . The ratio _p0 = 1 + _bmp/_wbp affects the resonant frequency and the damping rate in the high-bias condition.     

Hyperspaces of Normed Linear Spaces with the Attouch–Wets Topology

Let Cld _AW (X) be the hyperspace of nonempty closed subsets of a normed linear space X with the Attouch–Wets topology. It is shown that the space Cld _AW (X) and its various subspaces are AR's. Moreover, if X is an infinite-dimensional Banach space with weight w(X) then Cld _AW (X) is homeomorphic to a Hilbert space with weight 2 ^w(X).     

High-repetition-rate 12 fs pulse amplification by a Ti:sapphire regenerative amplifier system

We demonstrate the direct generation of 12 fs pulses from a Ti:sapphire regenerative amplifier system at a 1 kHz repetition rate utilizing properly designed broadband components for chirped-pulse amplification. Optimized designs of a regenerative amplifier with a multilayer gain-narrowing compensator and an adaptive dispersion compensator with a spatial light modulator contribute to the shorter pulse amplification.     

Strong resonance enhancement of a single harmonic generated in the extreme ultraviolet range

We report the demonstration of strong resonance enhancement of a single high-order harmonic in the extreme ultraviolet (XUV) region generated from the interaction of a femtosecond pulse with low-ionized In ablation. A strong 13th harmonic (61.2 nm) of Ti:sapphire laser radiation with output intensity almost two orders of magnitude higher than neighboring harmonics was observed in these studies. The high conversion efficiency of the 13th harmonic (8 x 10(-5)) is attributed to multiple collisions of electron trajectories with the origin due to multiphoton resonance with the In ion.     

Complex impedance spectra of chip inductor using Li–Zn–Cu–Mn ferrite

A multi-layer chip inductor (MCI) was fabricated using polycrystalline Li–Zn–Cu–Mn ferrite and the green-sheet technique, and its complex impedance spectrum was evaluated with the help of numerical calculations. The complex impedance spectra of the MCI component using Ni–Zn–Cu ferrite, which have been widely used for this application, were very sensitive to the residual stress and deviated much from the calculated values; however, it was found that the complex impedance spectrum of the MCI component using Li–Zn–Cu–Mn ferrite is quite well reproduced by calculation, where the complex permittivity and permeability of the polycrystalline ferrite as well as the MCI dimensions, were used. It implied that the magneto-striction effect was negligible in case of MCI using Li–Zn–Cu–Mn ferrite, and that the difference was related to magneto-strictive coefficient of the polycrystalline ferrite. Consequently, utilization of Li–Zn–Cu–Mn ferrite enabled us to easily design the complex impedance of MCI component.     

Fabrication of Spot Size Converters for Optical Chemical Sensors by Distributed-Field-Assisted Ion-Exchange

We propose a new method for fabricating optical waveguides with nonuniform thickness by controlling the electrical field distribution during the field-assisted ion-exchange. We refer to this method as distributed-fild-assisted ion-exchange. The distribution of the intensity of the electrical field was simulated for different electrode configurations, and was compared with experimental diffusion depth distribution of K⁺—Na⁺ exchange in sodalime slide glass. A unique bath was designed for the distributed-field-assisted ion-exchange. Using a three-electrode configuration, we obtained, for instance, a 2 cm-long spot size converter with thickness changes of from 12 μm to 2 μm. This technique can be used to fabricate waveguides for optical chemical sensors.On leave from State Key Laboratory of Transducer Technology, Institute of Electronics, Chinese Academy of Sciences, Beijing, China 100080.     

Hybrid Planar Wiggler with a Period of 2 cm for Higher Harmonic FEL Lasing

A hybrid planar wiggler with a period of 20 mm has been studied as the simplest one which gives the strong field including some higher harmonic components by selecting proper sizes of the ferromagnetic and the permanent magnet. Small gap length of the wiggler and small width of permendur satisfy these conditions to a certain degree.Gain analysis of FEL suggests that for high wiggler field of K>1 1.6, higher harmonic gains are improved primarily due to its strong field, and for low wiggler field of K< 1 1.6, they are mainly due to the modification of the wiggler field distribution.