FTIR spectroscopic study on crystallization process of poly(ethylene-2,6-naphthalate)

In situ Fourier transform infrared (FTIR) measurements were carried out to elucidate conformation changes occurring during the isothermal melt crystallization of poly(ethylene-2,6-naphthalate) (PEN). Based on the band assignments for the components of the amorphous, α-crystal form, and β-crystal form of PEN in film samples, the in situ data was analyzed in terms of the amorphous- and crystal-trans conformations. It was observed at a higher isothermal crystallization temperature that the formation of amorphous-trans conformations precedes the growth of crystals. © 1997 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 35: 2741–2747, 1997     

Imaging of a pH-sensitive polymer brush on a porous membrane using atomic force microscopy in aqueous solution

Poly(methacrylic acid) was grafted on a nanoporous polycarbonate membrane using the glow-discharge method. Atomic force microscopy showed that the pore size is dependent upon pH in such a way that a low pH the graft chains are protonated and contracted to open the pore, whereas at high pH, the graft chains became extended, thus reducing the pore size. Water permeation through the graft membrane is regulated by the pH value. The permeation rate is low at high pH value and high at low pH. This phenomenon corresponds to the pore size.     

Identification of Shiga toxins in Shiga toxin-producing Escherichia coli using immunoprecipitation and high-performance liquid chromatography-electrospray ionization mass spectrometry

We developed a rapid and reliable identification method for Shiga toxins in Shiga toxin-producing Escherichia coli (STEC) using immunoprecipitation and high-performance liquid chromatography-electrospray ionization mass spectrometry (HPLC-ESI-MS). Polyclonal antisera specific for Shiga toxin 1 (Stx1) and Shiga toxin 2 (Stx2) were raised in rabbits so as to be used for the immunoprecipitation. The immunoprecipitaion was carried out by mixing sample solutions with 50 microl each of the antisera to Stx1 and Stx2 followed by allowing the mixed solutions to stand for 30 min. The quantity required to obtain the immunoprecipitate was more than 0.5 microg of Shiga toxins. HPLC-ESI-MS analysis of the resulting immunoprecipitates provided accurate molecular weight information on Shiga toxins, leading to direct evidence for the presence of these toxins. It requires at most two days to perform our procedure from toxin extraction to measurement of HPLC-ESI-MS whereas the previous method using isolation procedures required about two weeks to complete. The usefulness of the present method has been demonstrated by identifying Stx1, Stx2 and a variant of Stx2 (Stx2e) in the immunoprecipitates prepared from STEC strains.     

Zirconium-mediated intramolecular ester transfer reaction: synthesis of alpha-substituted gamma-aminobutyric acid (GABA) derivatives

[reaction: see text]. The zirconium-mediated intramolecular ester transfer reaction of N-alkenyl carbamate derivatives proceeded to give alpha-substituted gamma-aminobutyric acid (GABA) derivatives in good to excellent yields. Quenching experiments of the reaction mixture with iodine or O2 indicated the presence of a cyclopropane intermediate. The resulting iodide was converted to 2-substituted pyrrolidine-3-carboxylate and/or alpha-alkylidene-gamma-aminobutyric acid derivatives in a stereospecific manner.     

Characterization and quantitation of clarithromycin polymorphs by powder X-ray diffractometry and solid-state NMR spectroscopy

Characterization of clarithromycin polymorph was performed by solid-state cross polarization and magic angle spinning (CP/MAS) 13C-NMR spectroscopy. Two polymorphs, form II and form I, of clarithromycins indicated characteristic resonances of C1 carbonyl carbon at 176.2 and 175.2 ppm, respectively. Since each peak of C1 carbon was well separated in the spectrum of the two polymorphs, we performed quantitative analysis of the polymorphic fraction from the peak area of these peaks. The peak area of form I was found to linearly increase with an increase of its content, with a correlation coefficient of above 0.99. Solid-state NMR was found to be a useful technique to determine the characteristics of the polymorphic forms.     

Use of Aggregation‐Induced Emission for Selective Detection of Phase Transformation during Evaporative Crystallization of Hexaphenylsilole

Crystallization of organic molecules is quite complicated because the crystallization process is governed by weak intermolecular interactions. By exploiting aggregation‐induced emission (AIE), we attempted to realize the selective detection of phase transformation during the evaporative crystallization of hexaphenylsilole (HPS), which shows different fluorescent colors in the amorphous and crystalline phases. No fluorescence emission was observed in the HPS solution immediately after dropping on the glass substrate due to the non‐radiative deactivation induced by intramolecular rotational or vibrational motion, suggesting that HPS exists as a monomer in solution. As time elapsed after dropping, green emission first appeared, which changed to blue after solvent evaporation, because of phase transformation from the amorphous state to the crystalline state. This phenomenon supports not only the two‐step nucleation model involving an intermediate such as a liquid‐like cluster prior to nucleation but also the real‐time detection of Ostwald's rule of stages during evaporative crystallization.     

Disulfide‐Unit Conjugation Enables Ultrafast Cytosolic Internalization of Antisense DNA and siRNA

Development of intracellular delivery methods for antisense DNA and siRNA is important. Previously reported methods using liposomes or receptor‐ligands take several hours or more to deliver oligonucleotides to the cytoplasm due to their retention in endosomes. Oligonucleotides modified with low molecular weight disulfide units at a terminus reach the cytoplasm 10 minutes after administration to cultured cells. This rapid cytoplasmic internalization of disulfide‐modified oligonucleotides suggests the existence of an uptake pathway other than endocytosis. Mechanistic analysis revealed that the modified oligonucleotides are efficiently internalized into the cytoplasm through disulfide exchange reactions with the thiol groups on the cellular surface. This approach solves several critical problems with the currently available methods for enhancing cellular uptake of oligonucleotides and may be an effective approach in the medicinal application of antisense DNA and siRNA.     

Synthesis and Characterization of α,ω‐Heterofunctional Poly(ethylene oxide) Macromonomers

A novel α,ω‐heterofunctional poly(ethylene oxide) (PEO) macromonomer possessing methacryloyl and thienyl end groups was prepared by ring‐opening polymerization of ethylene oxide initiated by potassium thienylethoxide and termination of the living PEO ends with methacryloyl chloride. Incorporation of methacryloyl and thienyl groups was confirmed by free‐radical and oxidative polymerization processes, respectively, and by means of ¹H NMR analysis.

     

Electrolytic synthesis of ammonia in molten salts under atmospheric pressure

Ammonia was successfully synthesized by using a new electrochemical reaction with high current efficiency at atmospheric pressure and at lower temperatures than the Haber-Bosch process. In this method, nitride ion (N3-), which is produced by the reduction from nitrogen gas at the cathode, is anodically oxidized and reacts with hydrogen to produce ammonia at the anode.