Precise determination of Mg/Fe ratios applicable to terrestrial olivine samples using Raman spectroscopy

The relationship between Mg# [ = 100 Mg/(Mg + Fe) in mol] and the Raman shift was analyzed precisely for olivine [(Mg, Fe)₂SiO₄] samples with Mg# between 100 and 62.8. Two prominent peaks at 826–820 cm⁻¹ (peak 1) and 858–849 cm⁻¹ (peak 2) and three subordinate peaks at 883–881 cm⁻¹ (peak 3), 920–914 cm⁻¹ (peak 4), and 967–951 cm⁻¹ (peak 5) were observed to shift monotonously to lower wavenumbers with decreasing Mg#. The ΔMg#( = Mg#_ref − Mg#) versus Δν(= ν_ref − ν) can be linearly regressed for each peak as ΔMg# = A Δν, where ν is a peak wavenumber of olivine with Mg# ranging from 100 to 62.8, and ν_ref is that of olivine with a reference value of Mg#, namely, Mg#_ref. We set Mg#_ref as 100 (i.e.pure forsterite Mg₂SiO₄) whereas A is a regression parameter (5.789, 4.294, 12.34, 6.348, and 2.09, respectively,for peaks 1, 2, 3, 4, and 5). This equation enables us to avoid small inter‐laboratory differences of wavenumber calibration. The equation for peak 2 yields estimations of Mg# in geologically satisfactory precision, ± 1 Mg# (1σ) in the Mg# range of 100–62.8. Copyright © 2011 John Wiley & Sons, Ltd.     

Infrared reflection absorption study of carbon monoxide adsorption on Pd/Cu(1 1 1)

Pd-Cu bimetallic surfaces formed through a vacuum-deposition of Pd on Cu(1 1 1) have been discussed on the basis of carbon monoxide (CO) adsorption: CO is used as a surface probe and infrared reflection absorption (IRRAS) spectra are recorded for the CO-adsorbed surfaces. Low energy electron diffraction (LEED) patterns for the bimetallic surfaces reveal six-fold symmetry even after the deposition of 0.6 nm. The lattice spacings estimated by the separations of reflection high-energy electron diffraction (RHEED) streaks increase with increasing Pd thickness. Room-temperature CO exposures to the bimetallic surfaces formed by the Pd depositions less than 0.3 nm thickness generate the IRRAS bands due to the three-fold-hollow-, bridge- and linear-bonded CO to Pd atoms. In particular, on the 0.1 nm-thick Pd surface, the linear-bonded CO band becomes apparent at an earlier stage of the exposure. In contrast, the bridge-bonded CO band dominates the IRRAS spectra for CO adsorption on the 0.6 nm-thick Pd surface, at which the lattice spacing corresponds to that of Pd(1 1 1). A 90 K-CO exposure to the 0.1 nm-thick Pd surface leads to the IRRAS bands caused not only by CO-Pd but also by CO-Cu, while the Cu-related band is almost absent from the spectra for the 0.3 nm-thick Pd surface. The results clearly reveal that local atomic structures of the outermost bimetallic surface can be discussed by the IRRAS spectra for the probe molecule.     

Wetting of liquid droplets on two parallel filaments

Droplet wetting on two parallel filaments may assume a barrel-shaped morphology or a liquid bridge depending upon the filament diameter and spacing, droplet volume, and contact angle. This paper is aimed to examine the dependency of droplet wetting length upon the above parameters. In the process, morphology of either a barrel-shaped droplet or a liquid bridge sitting on two parallel filaments is determined numerically by using surface finite element method (SFEM). Variation of wetting length with contact angle is examined at varying droplet volume, filament spacing, and droplet morphology. It is found that the droplet wetting length increases with decreasing filament spacing ratio as well as contact angle while it also increases with the growth of droplet volume. The dependency of wetting length upon contact angle behaves sensitive to filament spacing in the case of stable liquid bridges, while it exhibits nearly constant sensitivity to the contact angle in the case of barrel-shaped droplets. The quantitative relations yielded in this study can be considered as characteristic curves applicable for a variety of droplet-on-filament systems, particularly useful to wetting property characterization of filaments, micro liquid delivery, biological cell manipulation, etc.     

Electronic control of spin alignment in pi-conjugated molecular magnets

Intramolecular spin alignment in pi-conjugated molecules is studied theoretically in a model of a Peierls-Hubbard chain coupled with two localized spins. By means of the exact diagonalization technique, we demonstrate that a spin singlet (S=0) to quartet (S=3/2) transition can be induced by electronic doping, depending on the chain length, the positions of the localized spins, and the sign of the electron-spin coupling. The calculated results provide a theoretical basis for understanding the mechanism of spin alignment recently observed in a diradical donor molecule.     

Improved direct measurement of the parity-violation parameter Ab using a mass tag and momentum-weighted track charge

We present an improved direct measurement of the parity-violation parameter A(b) in the Z boson-b-quark coupling using a self-calibrating track-charge technique applied to a sample enriched in Z-->bb events via the topological reconstruction of the B hadron mass. Manipulation of the Stanford Linear Collider electron-beam polarization permits the measurement of A(b) to be made independently of other Z-pole coupling parameters. From the 1996-1998 sample of 400,000 hadronic Z decays, produced with an average beam polarization of 73.4%, we find A(b)=0.906+/-0.022(stat)+/-0.023(syst).     

Measurement of branching fractions for B-->eta(c)K(*) decays

We report measurements of branching fractions for charged and neutral B-->eta(c)K decays where the eta(c) meson is reconstructed in the K(0)(S)K+/-pi(-/+), K+K-pi(0), K(*0)K-pi(+), and pp; decay channels. The neutral B0 channel is a CP eigenstate and can be used to measure the CP violation parameter sin(2phi(1). We also report the first observation of the B0-->eta(c)K(*0) mode. The results are based on an analysis of 29.1 fb(-1) of data collected by the Belle detector at KEKB.     

Comparison of detectability limits for elemental mapping by EF-TEM and STEM-XEDS

The analytical sensitivity in terms of the signal-to-noise ratio (SNR) was investigated for elemental mapping by a transmission electron microscope equipped with an energy filter (EF-TEM) and a scanning transmission electron microscope with an X-ray energy dispersive spectrometer (STEM-XEDS). To compare the detectability limits of the elemental maps by the two techniques, homogeneous Cu-0.98+/-0.34 wt% Mn and Cu-4.93+/-0.49 wt% Mn thin specimens were used. Elemental maps can be considered as either an image or a spectrum. Therefore, the detectability limits of the elemental maps were characterized by the spectral SNR. To evaluate the detectability limits of the elemental maps with statistical confidence limits such as 1 sigma, 2 sigma and 3 sigma, the SNR values were reviewed from the statistical point of view. In STEM-XEDS mapping, the spectral SNR values improve as the specimen thickness increases since the signal intensity increases. Conversely, the spectral SNR in EF-TEM mapping is maximized at a certain thickness and then reduces as the thickness increases. To compare the two mapping techniques with regard to the analytical sensitivity, a method to estimate the minimum mass fraction (MMF) from measured signal and background intensities was developed. In this experimental approach, the MMF value can be evaluated by selecting the appropriate SNR value corresponding to the statistical confidence limits. In comparing the estimated MMF values from the two mapping approaches, EF-TEM mapping can be more sensitive than STEM-XEDS mapping up to specimen thicknesses <20-30 nm in the 1 sigma confidence limit and < approximately 50 nm in the 3 sigma limits. However, as the specimen thickness increases, the XEDS maps provide better detectability limits in the Cu-Mn dilute alloy specimens.     

Observation of time-dependent CP violation in B0 --> eta'K0 decays and improved measurements of CP asymmetries in B0 --> phiK0, KS0KS0KS0 and B0 --> J/psiK0 decays

We present improved measurements of CP-violation parameters in B(0) --> phiK(0), eta(')K(0), KS(0)KS(0)KS(0) decays based on a sample of 535 x 10(6) BB pairs collected at the Upsilon(4S) resonance with the Belle detector at the KEKB energy-asymmetric e(+)e(-) collider. We obtain sin2phi1(eff)=+0.64+/-0.10(stat)+/-0.04(syst) for B(0) --> eta(')K(0), +0.50+/-0.21(stat)+/-0.06(syst) for B(0) --> phiK(0), and +0.30+/-0.32(stat)+/-0.08(syst) for B(0) --> KS(0)KS(0)KS(0) decays. We have observed CP violation in the B(0) --> eta(')K(0) decay with a significance of 5.6 standard deviations. We also perform an improved measurement of CP asymmetries in B(0) --> J/psiK(0) decays and obtain sin2phi1=+0.642+/-0.031(stat)+/-0.017(syst).     

Charged particle radiotherapy at the Hyogo Ion Beam Medical Center: Characteristics,technology and clinical results

The Hyogo Ion Beam Medical Center was constructed in 2001 as the world’s first charged particle radiotherapy center where both proton and carbon-ion radiotherapy can be performed. From April 2001 to February 2007, more than 1,400 patients with a variety of cancers were treated. Most of the tumors except for prostate cancer were considered hard to cure with standard treatments such as surgery or conventional x-ray radiotherapy. The clinical results obtained so far are very encouraging, mainly due to the excellent dose localization to the tumor and strong cell killing effects of protons and carbon-ions. The good indications are localized tumors including skull base tumors, head and neck tumors, cancers of the lung, the liver, and the prostate, and bone and soft tissue sarcomas. Charged particle radiotherapy will significantly improve the quality of life of cancer patients and promote their speedy return to normal lives or work if it is used for early stage cancer.     

Coadsorption of water and CO molecules on Ru(0 0 1) at high CO coverages: comparisons with a Ru(0 0 1) electrode surface

The coadsorption of carbon monoxide (CO) and water molecules on a Ru(0 0 1) surface has been studied by infrared spectroscopy, LEED and STM. At high CO coverage phases, a 2×2-(2CO+D₂O) structure was observed on both UHV and electrode surfaces. Electrode potential dependent structures from CO and water adlayers on an electrode surface were reproduced on a UHV surface by controlling molecular orientations of the first layer and second over-layer water molecules. At lower CO coverages, a CO band center showed coverage dependent shift down to 1444 cm⁻¹ due to an electron transfer from a lone pair of a water molecule to CO 2π^*.