Application of Polymer-Embedded Tris(2,2′ Bipyridine-Ruthenium(II) to Photodetection of Oxygen

A Nafion film containing tris(2,2′-bipyridine)ruthenium(II) as a luminescence probe was applied to photodetection of oxygen in a gas by utilizing the luminescence quenching by dioxygen. The linear Stern-Volmer plots of the emission intensity with respect to the oxygen concentration allowed quantitative determination of the oxygen. From the emission decay studied by a single-photon counting method, it was concluded that the quenching of the excited state Ru complex by oxygen proceeds by a conventional dynamic mechanism.     

Polymer-Supported Bases. 10. Synthesis of Phosphatidylcholines Using Polymer-Supported or Free Acylimidazoles

Dipalmitoylphosphatidylcholine was synthesized in a good yield by the reaction of L-α-glycerophosphorylcholine with 1-palmitoylimidazole in the presence of DBU. Polymer-supported 1-palmitoylimidazole moiety also could be used as the acylating reagent, though the yield of the choline was moderate.     

Review Article: Fructooligosaccharides Enzymatic Preparation and Biofunctions

I. INTRODUCTION

Recently the study of oligosaccharides has been extensively pursued in Japan after the findings of the remarkable biofunctions and usefulness of fructooligosac-charides for human health, improving the intestinal microflora and importance in livestock nutrition.     

NLO‐active maleimide copolymers with ­high glass transition temperatures

We synthesized some novel rigid NLO‐active maleimide copolymers bearing DR‐1 moieties ( PMPD , PHSD and PHND ). All copolymers exhibited high T_g's (190～197 °C), good solubilities for common solvents and excellent film‐forming properties. Dependence of film thickness on the d₃₃ value for the poled copolymer films induced by corona poling was investigated and it was demonstrated that in less than thickness of 0.3 µm decrease of the thickness gives rise to remarkable increase in the d₃₃ value. The poled copolymer films exhibited large d₃₃ values (270 × 10^?9 esu (film thickness 0.13 µm) for PMPD , 290 × 10^?9 esu (0.12 µm) for PHSD and 350 × 10^?9 esu (0.08 µm) for PHND ) as well as large r₃₃ values (51.0 pmV^?1 for PMPD and 60.4 pmV^?1 for PHND ) which are significantly large compared to the value of LiNbO₃ (31 pmV^?1) as a typical EO material. The d₃₃ values of the poled copolymers were kept constant even after standing 1000h at 80 °C, although a small decrease was observed at an initial stage. Further, the d₃₃ values did not change up to ca. 123 °C upon heating at the rate of 10 °C/min in all cases. Copyright © 2002 John Wiley & Sons, Ltd.     

Error of Atomic Charges Derived from Electrostatic Potential

The purpose of this article is to show that CHELP, CHELPG, and Merz and Kollman undergo error for the charge on atoms of HCOO^– (H₂O) _n for n = 1 6. We also demonstrate that the CHELP, CHELPG, and Merz and Kollman show error for the tendency toward change in the charges on carbons for CH₃NH⁺ ₃ (CH₃)₂NH⁺ ₂ (CH₃)₃NH⁺ (CH₃)₄N⁺.     

Stereoselective synthesis of 2-methylenepyrrolizidines by tandem cyclization of N-propargylaminyl radicals

Tandem cyclization of N-propargylaminyl radicals, generated by N-chlorination of (E)-alk-4-enylamines 2a-d and 2f followed by treatment with tributyltin radical, afforded 2-methylenepyrrolizidines 3a-d and 3f in a highly stereoselective manner. A similar radical cyclization of (Z)-N-propargyl-1-methyl-5-phenylpent-4-enylamine (2e) gave pyrrolizidine 3b having the same stereochemistry as that obtained from the E isomer 2b.     

Methyl torsional potentials of rotational isomers of m-methylanisole studied by spectral hole-burning spectroscopy

Laser-induced fluorescence (LIF) excitation spectra of m-methylanisole in a supersonic jet were measured. Two series of progressions were observed in the spectrum, originating at 36048 and 36115 cm⁻¹, which were successfully assigned to the transitions to the methyl internal rotational vibronic levels of the two isomers, i.e. cis and trans isomers, with the aid of hole-burning spectrum measurements and quantum-chemical calculations. The progression for the trans isomer was observed up to the 6a₁ band, while only the 3a₁ band in addition to the 0a₁ and 1e bands was observed for the cis isomer. This finding can be explained by the conformational change upon the electronic excitation; the 60° rotation of the methyl torsional angle takes place for the trans isomer but not for the cis isomer.     

Infrared spectroscopic study of the interactions of nylon‐6 with water

We studied the interactions of nylon‐6 with water by following the Fourier transform infrared spectra of a hydrated thin film during dehydration. Very small changes in the spectra caused by the interactions were clearly revealed by the application of spectral subtraction. The water was found to interact with amide groups to form hydrogen bonds with non‐hydrogen‐bonded or free C?O and NH groups in the amorphous portion in the first hydration sphere. This was deduced from an analysis of minus and plus peaks appearing around the absorptions of the NH stretching, amide I band, and amide II bands in the difference spectra between the spectra during dehydration and the one at the most dehydration. The interactions of the amide groups with water were significantly stronger than the hydrogen bond between CO and NH in the crystalline portion, according to the magnitude of the frequency shift of relevant bands. Water, as the interacting counterpart, showed a distorted OH stretching absorption with two close peaks at about 3450 cm^?1. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1722–1729, 2003     

High resolution capillary gas chromatographic hydrocarbon-type analysis of naphtha and gasoline

A slightly modified, commercially available high resolution capillary gas chromatograph and a PC-based data processing system running proprietary software (“PONA”) have been employed in the development of a system for petroleum type analysis which would be equivalent or superior to the FIA (fluorescent indicator adsorption) method in terms of ease of use and the speed, variety, and accuracy of the analytical data produced. The system is capable of performing identification and quantitation of most of the individual components in a complex gasoline sample consisting of more than 230 components and can report weight percentage and/or volume percentage for each component as well as types by carbon number (e.g., isoparaffins, normal paraffins, olefins, naphthenes, aromatic compounds) within a ca. 70 minute analysis cycle. Precolumn sulfonation to trap olefins and aromatic compounds has been used as an complementary technique to the basic mass spectrometric identification of components of interest. The estimation of correction factors for weight percentage (or volume percentage) calculation are also discussed. Comparisons are made between this system and others, and the results indicate that the proposed method supersedes the conventional method employing FIA.     

A microsensor for adenosine-5′-triphosphate pH-sensitive field effect transistors

The sensor for adenosine-5′-triphosphate (ATP) is based on H⁺-ATPase immobilized via a polyvinylbutyral resin on a pH-sensitive field effect transistor. A linear relationship was obtained between the initial rate of change of the differential gate output voltage and the logarithm of the ATP concentration over the range 0.2–1.0 mM ATP. The optimum pH was 9.0 at 40°C but pH 7.0 was preferred for routine measurements. Only slight responses were obtained for 1 mM glucose, creatinine or urea. The ATP-sensing system exhibited a response to 1 mM ATP for at least 18 days.