Unwanted combustion enhancement by C6F12O fire suppressant

Several agents are under consideration to replace CF₃Br for use in suppressing fires in aircraft cargo bays. In a Federal Aviation Administration (FAA) performance test simulating the explosion of an aerosol can, however, the replacements, when added at sub-inerting concentrations, have all been found to create higher pressure rise than with no agent, hence failing the test. Thermodynamic equilibrium calculations as well as perfectly-stirred reactor (PSR) simulations with detailed reaction kinetics, are performed for one of these agents, C₆F₁₂O (Novec 1230), to understand the reasons for the unexpected enhanced combustion rather than suppression. The high pressure rise with added agent is shown to depend on the amount of agent, and can only occur if a large fraction of the available oxidizer in the chamber is consumed, corresponding to stoichiometric proportions of fuel, oxygen, and agent. A kinetic model for the reaction of C₆F₁₂O in hydrocarbon–air flames has been developed. Stirred-reactor simulations predict that at higher agent loadings, the inhibition effectiveness of C₆F₁₂O is relatively insensitive to the overall stoichiometry, and the marginal inhibitory effect of the agent is greatly reduced, so that the mixture remains flammable over a wide range of conditions corresponding to those of the FAA test. The present findings are consistent with and support the earlier analyses for C₂HF₅ and CF₃Br, which were also evaluated in the FAA test.     

Subject Index to Volume 33

This paper reports the investigation of microdroplet sample preparation for phosphate, strontium and rubidium using X-ray fluorescence. Sample filter papers were prepared by drying under several different conditions and the front and the back sides of the filter papers were measured using X-ray fluorescence (XRF), scanning electron microscopy (SEM), X-ray diffraction (XRD), and electron-probe microanalysis (EPMA).

It was reported by Murata and Murokado that the elemental distribution difference between the front and the back sides after drying the filter paper led to erratic data.¹ It has been found that the intensity difference between the front and the back sides was due to the condensation of the material of interest on the surface of the filter papers and the amount of the condensed material on the filter paper was related to the temperature at which the filter paper was dried.

Optimum temperature at which a filter paper is dried and an appropriate internal standard are essential to reproducible measurements.     

A Method for Measuring the Three-Dimensional Refractive-Index Distribution of Single Cells Using Proximal Two-Beam Optical Tweezers and a Phase-Shifting Mach—Zehnder Interferometer

This paper describes a method for measuring the three-dimensional (3D) refractive-index distribution in a single cell. The method can be used to observe the distribution of cell components without fluorescence staining. The two-dimensional optical path length distributions from multiple directions are obtained by non-contact rotation of the cell. These optical path lengths are converted into the line integrals of the refractive index, and the 3D refractive-index distribution is reconstructed by means of computed tomography. The refractive-index distribution in a breast cancer cell can be measured using a phase-shifting Mach—Zehnder interferometer in conjunction with proximal two-beam optical tweezers.     

Control of mixed protonic and electronic conductivity by mixing rare-earth ortho-borates

In order to develop mixed protonic and electronic conductors, we proposed a novel concept for material design that enables to control partial conductivities by fabricating solid solutions of protonic and electronic conductors. In this work, Sr-doped LaBO₃ and Sr-doped CeBO₃ were chosen as model compounds conducting protons and electron holes, respectively. Solid solutions of the above borates, Sr-doped La_1 − xCe_xBO₃, were prepared, and their electrical conductivities were investigated in 8.5 × 10²-4.2 × 10³ Pa of p(H₂O) and 1.0 × 10-1.0 × 10⁵ Pa of p(H₂) at 1073 K. From the experimental results of the gas partial pressure dependences of the conductivities, major charge carrier species were identified as a function of x. It was found that proton was the major charge carrier when x < 0.2 while the contribution of the electron hole conduction became remarkable as x increased above 0.2. The contribution of the electron hole conduction can be interpreted by the percolation model.     

Temperature dependence of the lattice locations of boron implanted in germanium

The β-NMR of the probe atom ¹²B implanted in In-doped germanium was measured as a function of temperature. As a result, three resonances were observed: sharp and broad resonances around the Larmor frequency and a resonance split by the electric quadrupole interaction. It was found that the appearance of the resonances is similar to the case of Si host (Izumikawa et al. Hyperfine Interact. 136/137:559–605, 2001). The quadrupole coupling constant for the split resonance was deduced as ∣eqQ/h∣ = 252(3) kHz under the assumption that it has <111> axial symmetry. And furthermore, assuming that the defect atom jumps thermally between the identical defect sites, the activation energy of the jump was deduced as 0.4 ± 0.1 eV.     

Reduction of acoustic radiation by perforated board and honeycomb layer systems

A perforated system, proposed previously for reducing the radiated sound from a plate at arbitrary frequencies, is applied to three-dimensional problem. Plates are assumed to be supported in a duct of a finite cross-section and excited by a harmonic point force. The sound radiation is investigated from the viewpoint of acoustic power and it is discussed whether the attenuation effect shown previously in the one-dimensional system can be obtained with the three-dimensional system. The effect of support conditions on attenuation characteristics is discussed by using clamped and simply supported circular models. Allowing for the effect, a simply supported rectangular model is studied in detail and its problems are revealed. In order to overcome the problems, a new system including subdivided air cavities in the form of a honeycomb layer instead of a undivided backing cavity is proposed. Each of the honeycomb cells can create local one-dimensional sound fields. Calculated theoretical results are compared to data obtained in a 1/5th scale reverberation chamber. The results for the reduction effect, which are in good agreement, show that the honeycomb layer system can achieve the same reduction of the radiated sound power at arbitrary frequencies as the one-dimensional perforated system.     

Unsupervised Image Segmentation Using Hierarchical Clustering

In the analysis of a medical image database aimed at formulating useful knowledge for image diagnosis requires an unsupervised image processing technique without preconceived knowledge. In this paper, we propose a method for unsupervised image segmentation, which is suitable for finding the features contained in an image. A small region around each pixel is considered as a pattern vector, and the set of pattern vectors acquired from the whole image is classified using the hierarchical clustering technique. In hierarchical clustering, the classification of pattern vectors is divided into two clusters at each node according to the statistical criterion based on the entropy in thermodynamics. Results of the test image generated by the Markov random field (MRF) model and real medical images photomicrographs of a colon tumor are shown.     

Conductance quantization and magnetoresistance in magnetic point contacts

We theoretically study the electron transport through a magnetic point contact (PC) with special attention given to the effect of an atomic scale domain wall (DW). The spin precession of a conduction electron is forbidden in such an atomic scale DW and the sequence of quantized conductances depends on the relative orientation of magnetizations between left and right electrodes. The magnetoresistance is strongly enhanced for the narrow PC and oscillates with the conductance.     

Two-dimensional measurement of laser-induced target movement by face-on interferometry

Initial movement of laser irradiated foil targets has been measured by face-on interferometry with two-dimensional resolution. This interferometric method provides direct and precise information about the initial movement of the rear surface of the target compared with conventional diagnostics. Target movement of 20–500 nm from the original position has been observed.