Development of a rapid and specific assay for detection of busulfan in human plasma by high-performance liquid chromatography/electrospray ionization tandem mass spectrometry

A sensitive and specific assay for detection of busulfan in human plasma was developed. The assay is based on rapid isolation of busulfan by liquid-liquid extraction with ethyl acetate, and detection by high-performance liquid chromatography with electrospray ionization and tandem mass spectrometry. 1,6-Bis(methanesulfonyloxy)hexane, a synthesized analogue of busulfan, was used as the internal standard (IS). The acquisition was performed in the multiple reaction monitoring mode; busulfan and the IS were detected with no interferences from plasma matrix. The method was linear over the range 5-2500 ng mL(-1), with r2 > 0.99 and a run time of only 3.5 min. The intra- and inter-assay precisions were in the ranges 2.1-11.9% and 3.2-10.1%, respectively, and the intra- and inter-assay accuracies were 92.2-107.6% and 94.7-104.1%, respectively. The absolute recoveries were 82.0% (20 ng mL(-1)), 90.6% (1000 ng mL(-1)) and 80.0% (2000 ng mL(-1)) for busulfan, and 89.1% for the IS (1000 ng mL(-1)). The limits of detection and quantification were 2 and 5 ng mL(-1), respectively. The validated method was successfully applied to analyze plasma samples obtained from six adults receiving doses of 1 mg kg(-1) in a conditioning regimen prior to bone marrow transplantation. A marked intra-patient variation in busulfan concentrations during the steady state was observed, which limits the application of pharmacokinetic modeling and suggests that continuous therapeutic monitoring is necessary for adequate individualized dosing. In this regard, the present assay brings important advantages relative to other methods described in the literature, i.e., it is highly specific and simple to perform, with a rapid chromatographic run time (3.5 min), and the whole procedure can be completed in 4-5 h, which would permit dose corrections after the third dose allowing earlier and better dosing adjustments towards the target level of busulfan.     

Viability of the antigen determines whether DNA or urocanic acid act as initiator molecules for UV-induced suppression of delayed-type hypersensitivity

UV radiation suppresses the immune response, and UV-induced immune suppression contributes to UV-induced photocarcinogenesis. For UV-induced immune suppression to occur, electromagnetic energy (i.e. UV radiation) must be converted to a biological signal. Two photoreceptors have been identified in the skin that serves this purpose, epidermal DNA and trans-urocanic acid (UCA). Although compelling evidence exists to support a role for each pathway (UV-induced DNA damage or photoisomerization of UCA) in UV-induced immune suppression, it is not clear what determines which photoreceptor pathway is activated. To address this question, we injected UV-irradiated mice with a monoclonal antibody with specificity for cis-UCA or applied liposomes containing DNA repair enzymes to the skin of UV-irradiated mice. The effect that each had on UV-induced suppression of delayed-type hypersensitivity was measured. We asked whether the light source used (FS-40 sunlamps vs solar-simulated UV radiation) altered whichever pathway of immune suppression was activated. Different doses of UV radiation and the viability of the antigen were also considered. Neither the dose of UV nor the light source had any influence on determining which pathway was activated. Rather, we found that the viability of the antigen was the critical determinant. When live antigens were used, UV-induced immune suppression was blocked with monoclonal anti-cis-UCA but not with T4 endonuclease V-containing liposomes. The reverse was observed when formalin-fixed or killed antigens were used. Our findings indicate that antigen viability dictates which photoreceptor pathway predominates after UV exposure.     

Evaluation of capillary isoelectric focusing in glycerol-water media with a view to hydrophobic protein applications

Capillary isoelectric focusing (CIEF) separations are usually performed with neutral coated fused-silica capillaries in aqueous anticonvective media. Glycerol, a very viscous solvent (eta = 945 mPa x s at 25 degrees C), known to help stabilize any kind of proteins and solubilize hydrophobic ones, was tested as an alternative to using commercial gels. Viscosity and electroosmotic mobility were measured as a function of gel or glycerol content in water, and a 30:70 v/v glycerol-water medium appeared as a good compromise for performing CIEF in a bare fused-silica capillary without imposing too high a viscosity. To demonstrate the feasibility of this new CIEF system, a standard mixture of nine model proteins was separated according to their pI with a good agreement between experimental and literature aqueous pIs. Moreover, better resolution was achieved with this system than with the conventional aqueous CIEF system, as two of the model proteins could not be separated in the latter system. Glycerol-water CIEF in bare silica capillary was next applied to the separation of horse radish peroxidase, a complex mixture of protein isoforms. The good concordance with the separation obtained by the conventional CIEF system indicated the adequacy of this new system. Finally, as anticipated from the results obtained for the separation of bacteriorhodopsin, a membrane protein, glycerol-water CIEF performed in bare silica capillary appears to be a promising alternative to conventional aqueous CIEF for hydrophobic protein characterization, under their native form.     

Modification of the Cp′ ring in the ferrocifen precursor and its influence on the recognition by the estrogen receptor

A synthetic pathway giving access to diphenyl ethylene organometallic derivatives possessing the ferrocifen precursor skeleton modified in the Cp′ ring is described. It relies on reaction of the (η⁵-propionylcyclopentadienyl) (η⁶-benzene)iron(II) salt 7 with substituted cyclopentadienyl anions or their heteroanalogs followed by the McMurry coupling reaction with 4,4′-dihydroxybenzophenone. Using this approach pentamethylcyclopentadienyl and 3,4-dimethylphospholyl analogs of ferrocifen precursor (10 and 11) have been synthesized. Even with the presence of the bulky and containing phosphorus η⁵-ligands these compounds are still recognized by the two subtypes of estrogen receptor(ERα and ERβ).     

Non-aqueous capillary electrophoresis of the positional isomers of a sulfated monosaccharide

A non-aqueous capillary electrophoresis (NACE) method coupled to indirect absorbance detection has been developed for the separation of the three positional isomers of monosulfated fucose. The optimized electrolyte was composed of 12 mM ethanolamine, 2 mM trimesic acid buffer in a methanol-ethanol (1:1, v/v) mixture. As the retained electrolyte entails no separating agent other than the pH buffer, the NACE separation of the positional isomers has been ascribed mainly to selective ion-pairing with the electrolyte counter-ion and the possibility of a selective solvation effect in the alcohol mixture. In the absence of pure isomeric standards, peak identification was completed by MS and NMR spectroscopy and selective enzymatic desulfation. This method should be of interest for the structure elucidation of monosulfated fucose-based polysaccharides and for the screening of sulfoesterase of unknown activity.     

ULTRAVIOLET LIGHT-INDUCED FREE RADICAL FORMATION IN SKIN: AN ELECTRON PARAMAGNETIC RESONANCE STUDY

It has been suggested that ultraviolet light induces free radical formation in skin, leading to photoaging and cancer. We have demonstrated by electron paramagnetic resonance that the ascorbate free radical is naturally present in unexposed skin at a very low steady state level. When a section of SKH-1 hairless mouse skin in an EPR cavity is exposed to UV light (4,500 J m⁻²−1, Xe lamp, 305 nm cutoff and IR filters), the ascorbate free radical signal intensity increases. These results indicate that UV light increases free radical oxidative stress, consistent with ascorbate's role as the terminal, small-molecule antioxidant. The initial radicals produced by UV light would have very short lifetimes at room temperature; thus, we have applied EPR spin trapping techniques to detect these radicals. Using α-[4-pyridyl 1-oxide]-N- tert -butyl nitrone (POBN), we have for the first time spin trapped a UV light-produced carbon-centered free radical from intact skin. The EPR spectra exhibited hyperfine splittings that are characteristic of POBN/alkyl radicals, a^N= 15.56 G and a^H= 2.70 G, possibly generated from membrane lipids as a result of β-scission of lipid alkoxyl radicals. Iron can act as a catalyst for free radical oxidative reactions; chronic exposure of skin to UV radiation causes increased iron deposition. Using our spin trapping system, we have shown that topical application of the iron-chelator, Desferal, to a section of skin reduces the UV light-induced POBN adduct radical signal. These results provide direct evidence for free radical generation and a role for iron in UV light-induced dermatopathology. We suggest that iron chelators can serve as photoprotective agents by preventing these oxidations.     

Electric field induced electron transfer at the adsorbate-surface interface. Effect of the type of metal surface

The ab initio two-state model for electron transfer induced by an external electric field has been applied to the chloride oxidation on Cu, Rh, Pd, Ag, Pt and Au (001) surface models. The two electronic states involved in the model represent physical situations where the electron transferred from the chloride anion to the metal surface lies either on the halide or on the metal substrate. The model assumes that electron transfer takes place when these two states become degenerate and this is achieved by applying an external electric field. Two different situations representing either ultrahigh vacuum or electrochemical conditions have been considered. For the former the present study shows that electric field necessary to achieve degeneracy of the two electronic states is directly related to the metal surface work function whereas for the latter, it is found to be rather insensitive to the metal surface.     

Determination of lead in seawater by inductively coupled plasma optical emission spectrometry after separation and pre-concentration with cocrystallized naphthalene alizarin

An analytical method for separation and pre-concentration of lead in seawater for determination by inductively coupled plasma optical emission spectrometry has been investigated. Lead was retained in the solid phase (0.5 g) composed of co-precipitated naphthalene and alizarin red. The solid phase quantitatively sorbs Pb(II) at pH 8–9, and the metal was eluted using 5.0 ml of 2 mol l⁻¹ nitric acid. The effect of NaCl, KCl, BaCl₂, CaCl₂, Na₂SO₄, MgCl₂ and Na₃PO₄ on the sorption of Pb(II) in the solid phase was studied. A set of solutions containing varying amounts of electrolytes (0.5; 1.0; 3.0 and 5.0% m/v) with Pb (50 μg) was prepared and the recommended procedure applied. The Na₃PO₄ was found to interfere; the other electrolytes did not interfere up to 5% m/v. A pre-concentration factor of 40 was obtained in this analytical procedure. The limit of detection and limit of quantification for Pb(II) were 53 and 176 μg l⁻¹, respectively. Lead was determined in seawater samples collected in Salvador city, Bahia, Brazil. The precision, expressed as R.S.D., was 1.8–4.6%, and the recovery of lead added to seawater samples was 95–97%.     

Field evaluations of the VDmax approach for substantiation of a 25 kGy sterilization dose and its application to other preselected doses

The International and European standards for radiation sterilization require evidence of the effectiveness of a minimum sterilization dose of 25 kGy but do not provide detailed guidance on how this evidence can be generated. An approach, designated VD_max, has recently been described and computer evaluated to provide safe and unambiguous substantiation of a 25 kGy sterilization dose. The approach has been further developed into a practical method, which has been subjected to field evaluations at three manufacturing facilities which produce different types of medical devices. The three facilities each used a different overall evaluation strategy: Facility A used VD_max for quarterly dose audits; Facility B compared VD_max and Method 1 in side-by-side parallel experiments; and Facility C, a new facility at start-up, used VD_max for initial substantiation of 25 kGy and subsequent quarterly dose audits. A common element at all three facilities was the use of 10 product units for irradiation in the verification dose experiment.

The field evaluations of the VD_max method were successful at all three facilities; they included many different types of medical devices/product families with a wide range of average bioburden and sample item portion values used in the verification dose experiments. Overall, around 500 verification dose experiments were performed and no failures were observed. In the side-by-side parallel experiments, the outcomes of the VD_max experiments were consistent with the outcomes observed with Method 1.

The VD_max approach has been extended to sterilization doses >25 and <25 kGy; verification doses have been derived for sterilization doses of 15, 20, 30, and 35 kGy. Widespread application of the VD_max method for doses other than 25 kGy must await controlled field evaluations and the development of appropriate specifications/standards.     

Screening for selected toxic elements in urine by sequential-scanning inductively-coupled plasma atomic emission spectrometry

A rapid screening method for nine elements (Se, As, Cr, Zn, Cd, Pb, Ni, Mn, and Cu) in human urine is described. A sequential-scanning inductively-coupled plasma atomic emission spectrometer, incorporating a cross-flow nebulizer, was used. Internal standardization with yttrium compensated for the differences between the aqueous calibration standards and the undiluted urine specimens. Accuracy was evaluated with aqueous (NBS SRM 1643a, EPA 378-13, and EPA 476-3) and urine (NBS SRM 2670 and Fisher Urichem Level II) reference and control materials. Detection limits for the system were evaluated from analyses of normal urine materials found to contain low levels of the elements investigated.