An investigation of the Al2O3-CdSe interface in accumulation

The Al₂O₃−CdSe interface of a thin-film transistor is investigated in the frequency range 30 Hz-30 kHz under weak depletion and accumulation. The surface states are, most likely, located in the insulator Al₂O₃ with a concentration varying from 4·10¹⁸ to 10¹⁹ cm⁻³ eV⁻¹. The surface states have a negligible influence on the thin-film transistor operation.     

Randomized greedy matching

We consider a randomized version of the greedy algorithm for finding a large matching in a graph. We assume that the next edge is always randomly chosen from those remaining. We analyze the performance of this algorithm when the input graph is fixed. We show that there are graphs for which this Randomized Greedy Algorithm (RGA) usually only obtains a matching close in size to that guaranteed by worst-case analysis (i.e., half the size of the maximum). For some classes of sparse graphs (e.g., planar graphs and forests) we show that the RGA performs significantly better than the worst-case. Our main theorem concerns forests. We prove that the ratio to maximum here is at least 0.7690…, and that this bound is tight.     

Sharp estimates in terms of moduli of smoothness for compound cubature rules

Summary In 1980 Dahmen-DeVore-Scherer introduced a modulus of continuity which turns out to reflect invariance properties of compound cubature rules effectively. Accordingly, sharp error bounds are derived, the existence of relevant counterexamples being a consequence of a quantitative resonance principle, established previously.     

The frequency scale of speech intonation.

In intonation research, prominence-lending pitch movements have either been described on a linear or on a logarithmic frequency scale. An experiment has been carried out to check whether pitch movements in speech intonation are perceived on one of these two scales or on a psychoacoustic scale representing the frequency selectivity of the auditory system. This last scale is intermediary between the other two scales. Subjects matched the excursion size of prominence-lending pitch movements in utterances resynthesized in different pitch registers. Their task was to adjust the excursion size in a comparison stimulus in such a way that it lent equal prominence to the corresponding syllable in a fixed test stimulus. The comparison stimulus and the test stimulus had pitches running parallel on either the logarithmic frequency scale, the psychoacoustic scale, or the linear frequency scale. In one-half of the experimental sessions, the test stimulus was presented in the low register, while the comparison stimulus was presented in the high register, and, conversely, for the other half of the sessions. The result is that, in all cases, stimuli are matched in such a way that the average excursion sizes in different registers are equal on the psychoacoustic scale.     

Possible Loss and Recovery of Gibbsianness¶During the Stochastic Evolution of Gibbs Measures

We consider Ising-spin systems starting from an initial Gibbs measure ν and evolving under a spin-flip dynamics towards a reversible Gibbs measure μ≠ν. Both ν and μ are assumed to have a translation-invariant finite-range interaction. We study the Gibbsian character of the measure νS(t) at time t and show the following: (1) For all ν and μ, νS(t) is Gibbs for small t. (2) If both ν and μ have a high or infinite temperature, then νS(t) is Gibbs for all t > 0. (3) If ν has a low non-zero temperature and a zero magnetic field and μ has a high or infinite temperature, then νS(t) is Gibbs for small t and non-Gibbs for large t. (4) If ν has a low non-zero temperature and a non-zero magnetic field and μ has a high or infinite temperature, then νS(t) is Gibbs for small t, non-Gibbs for intermediate t, and Gibbs for large t. The regime where μ has a low or zero temperature and t is not small remains open. This regime presumably allows for many different scenarios. Received: 26 April 2001 / Accepted: 10 October 2001     

Luminescent properties of Ce in MSO4 (M: Ca, Sr and Ba) and the effect of Na co-doping

The optical properties of Ce³⁺ in CaSO₄, SrSO₄ and BaSO₄ are reported. The Ce³⁺ ion shows 4f⁰5d¹→²F_5/2,²F_7/2 luminescence in all three sulphates. Co-doping with Na⁺ does not change the local surrounding of the Ce³⁺ ion, but enhances the amount of Ce³⁺ ions built in. Under optical excitation, besides the typical Ce³⁺ doublet emission in the ultraviolet spectral region, band emission around 445 nm was observed. This band emission was not assigned to emission from a Ce³⁺ centre, but to emission from an impurity-trapped exciton. Under X-ray excitation, both Ce³⁺ emission and an emission band around 380 nm was observed. This band was assigned to emission from a self-trapped exciton.     

Simple, expedient methods for the determination of water and electrolyte contents of cellulose solvent systems

The concentrations of water, W, and electrolytes present in solutions of LiCl in N,N-dimethylacetamide, LiCl/DMAc, and of tetrabutylammonium fluoride. x-hydrate in DMSO, TBAF.xW/DMSO can be accurately and expediently determined by three independent methods, UV–vis, FTIR and EMF measurement. The first relies on the use of solvatochromic probes whose spectra are sensitive to solution composition. It is applicable to W/LiCl/DMAc solutions but not to TBAF.xW/DMSO, because the charge-transfer complex bands of the probes are suppressed by strong interactions with the latter electrolyte. Integration of ν_OH band of water may be employed in order to determine [W], hence [electrolyte] by weight difference. EMF measurement uses ion-selective electrodes in order to determine [electrolyte], hence [W] by weight difference. Results of the latter method were in excellent agreement with those of FTIR. The reason for the failure of Karl Fischer titration is addressed, and the relevance of the results obtained to functionalization of cellulose under homogenous solution conditions is briefly commented on.     

3D-TOFSIMS characterization of black spots in polymer light emitting diodes

The occurrence and formation of black spots areas in PolyLED devices has been studied by time-of-flight SIMS (TOFSIMS). The composition, shape and position of the black spots is visualised by three-dimensional (3D)-TOFSIMS depth-profiling. It has been established that the formation of non-emissive spots is due to the growth of aluminium oxide clusters at the AlBa/polymer interface. Electron injection in the black spots is lost by the resulting local increase of the resistivity of the cathode.