Evaluation of different quantitative approaches for the determination of noneasily ionizable molecules by different atmospheric pressure interfaces used in liquid chromatography tandem mass spectrometry: Abamectin as case of study

The liquid chromatography tandem mass spectroscopy residue determination of compounds without any acidic or basic centers such as abamectin has been investigated. Several approaches regarding the interface used and adduct formation have been compared. The low acidity of the hydroxyl groups only made deprotonation feasible using the atmospheric pressure chemical ionization (APCI) interface. To obtain sufficient sensitivity for residue analysis, the Ion Sabre APCI interface was necessary. However, the sensitivity attained was lower than for monitoring adducts in positive ion mode. Using electrospray ionization, different adducts with Na+, NH4+, and Li+ were tested and compared. The best results were obtained for the ammoniated adduct in electrospray ionization (ESI) because of its high sensitivity and the presence of several product ions with similar abundance. The highest sensitivity was reached using an in-source fragment as precursor ion, leading to a limit of detection (LOD) of 2 microg/L with low relative standard deviation. The relatively high abundance of other transitions allowed abamectin confirmation at concentrations close to the LOD (6 microg/L). Alkali ions were found to be a suitable alternative to determine and confirm abamectin at residue levels. The [M + Na]+ also presented various product ions with similar abundance, which allowed confirmation at LOD levels. However, this LOD was found to be almost four times higher than with [M + NH4]+ because of the poor sensitivity of the transitions obtained. Although the use of Li+ facilitated the fragmentation of the adduct [M + Li]+, with similar sensitivity to [M + NH4]+, this fragmentation preferentially generated only one product ion, which did not allow confirmation at concentration levels lower than 15 microg/L. The use of APCI for monitoring adducts was also feasible, but with less sensitivity. The sensitivity increased with the Ion Sabre APCI, although it was still five times lower than with ESI. Other adduct formers such as Co2+ and Ni2+ also were tested with unsatisfactory results.     

Mechanism for basic hydrolysis of N-nitrosoguanidines in aqueous solution

A kinetic study was carried out on the hydrolysis of two N-nitrosoguanidines, 1-nitroso-1-methyl-3-tolylsulfonylguanidine (TSGNO) and 1-nitroso-1-methyl-3-benzoylguanidine (BCGNO). We observed an absence of buffer catalysis using H(2)PO(4)(-)/HPO(4)(2)(-), H(3)BO(3)/H(2)BO(3)(-), and HCO(3)(-)/CO(3)(2)(-) regulators and a complex dependency of the rate constant on the pH. We discovered the existence of three simultaneous reaction paths: spontaneous decomposition of the neutral form of the N-nitrosoguanidine, decomposition of the monoanion, and decomposition through the form of the dianion. The analysis of the kinetic data has allowed us to obtain the acidity constant for the formation of the monoanion of the N-nitrosoguanidine, with values of p = 11.5. The reaction rate for the process through the monoanion, k(2), decreases as the acidity increases. The application of the principle of nonperfect synchronization shows that the basicity and reactivity do not correlate when there exists a possibility of stabilization of the negative charge by resonance. This behavior is consistent with the mechanism E1cB whereby the stabler the negative charge, the slower the elimination reaction. When dealing with the case of the elimination through the neutral form we observe that the reaction rate increases together with the capacity of stabilization of the positive charge on the nitrogen atom adjacent to the imino group. For the reaction through the dianion we used a maximum value of k(3) = 10(10) s(-)(1) to estimate the value of p for the formation of the dianion of the N-nitrosoguanidine, obtaining values of p < 24.     

Influence of lanthanum exchange on the catalytic properties of HY zeolite in cyclohexene transformation

Cyclohexene transformation was used as test reaction to study the effect of lanthanum exchange on the catalytic behavior of HY zeolite cracking catalysts. Lanthanum has an overall positive effect increasing both acitivity and stability of HY zeolite and maximum selectivity towards isomerization products is obtained at higher conversion.

---

HY. , , HY. .

     

Hydrolysis of new phthalimide-derived esters catalyzed by immobilized lipase

The last step of the production of four phthalimide-derived acids, designed to act as antiasthma drugs, was performed by enzymatic hydrolysis of the respective methyl or ethyl esters. The esters 4-ethyl-[2-(1,3-dioxo-1,3-dihydro-2-isoindoylyl)]-phenoxyacetic methyl ester (PHT-MET), 4-ethyl-[2-(1,3-dioxo-1,3-dihydro-2-isoindoylyl)]-phenoxyacetic ethyl ester, 4-(1,3-dioxo-1,3-dihydro-2-isoindoylyl)-phenoxyacetic ethyl ester, and 2-(1,3-dioxo-1, 3-dihydro-2-isoindoylyl)-phenoxyacetic ethyl ester were hydrolyzed by immobilized lipase. The enzymatic reaction could be used only to produce the desired 4-substituted compounds. The best result that was found to hydrolysis of PHT-MET, and, therefore, that ester was selected for optimization experiments in a three-phase system. Reactions were performed with solid biocatalyst (Lipozyme® RM IM), organic solvent phase (ethyl acetate), and aqueous phase (saturated Na₂CO₃ solution). To optimize the reaction conditions, an experimental design optimization procedure was used. The variables studied were the amount of enzyme, the temperature, and the volume of the aqueous solution. Time course experiments were then performed for different initial enzyme concentrations (0.5, 0.9, and 1.4 U_H/mL of solvent). The optimized reaction conditions found were 20 mg of Lipozyme (0.9 U_H/mL_solvent) and 5.0 mL of Na₂CO_3(sat) at 40°C for 6 h.     

210Pb fluxes in sediment layers sampled from Northern Patagonia lakes

Unsupported ²¹⁰Pb fluxes were determined from sediment core inventories in lakes located in Northern Patagonia, Argentina. Total ²¹⁰Pb, ²²⁶Ra, associated with supported ²¹⁰Pb, and ¹³⁷Cs specific activity profiles were measured by gamma-ray spectrometry. Unsupported ²¹⁰Pb fluxes showed very low values when compared to other regions, with a 12 fold variation, ranging from 4 to 48 Bq m^–2.y^–1. The linear correlation observed between the ²¹⁰Pb fluxes and¹³⁷Cs cumulative fluxes in sediment cores sampled from water bodies within a zone with similar precipitation demonstrated that both radioisotopes behave in the same manner in these systems concerning the processes occurred from fallout to sediment deposition, and that there are no appreciable local or regional sources of unsupported ²¹⁰Pb. Positive correlation of ²¹⁰Pb fluxes with organic matter contents of the uppermost sediment core layers was also observed.     

Synthesis and Thermal Study of Magnesium Complexes with 8-hydroxyquinolinate Derivatives

Magnesium ion was reacted with 5,7-dibromo-, 5,7-dichloro-, 7-iodo-and 5-chloro-7-iodo-8-hydroxyquinoline, in acetone/ammonium hydroxide medium under constant stirring to obtain (I) Mg[(C₉H₄ONBr₂)₂]·2H₂O; (II) Mg[(C₉H₄ONCl₂)₂]·3H₂O; (III) Mg[(C₉H₅ONI)₂]·2H₂O and (IV)Mg[(C₉H₄ONICl)₂]·2.5H₂O complexes. The compounds were characterized by elemental analysis, IR spectra, ICP, TG-DTA and DSC. Through thermal decomposition residues were obtained and characterized, by X-ray diffractometry, as a mixture of hexagonal MgBr₂ and cubic MgO to the (I) compound at 850°C; cubic MgO to the (II), (III) and (IV) compounds at750, 800 and 700°C, respectively. This revised version was published online in July 2006 with corrections to the Cover Date.     

Temperature dependence of second critical micelle concentration of dodecyldimethylbenzylammonium bromide in aqueous solution

The specific conductivity of dodecyldimethylbenzylammonium bromide (C12BBr) in aqueous solutions, in the temperature range of 15 to 40 °C, has been measured as a function of molality. The two breaks which were found on the conductivity against molality plots were attributed to the critical micelle concentration, cmc, and second critical micelle concentration, 2^nd cmc, respectively. The ratio of the slopes, S, of the three linear fragments on the plots, S2/S1 and S3/S1, was attributed to the degree of ionization of the micelles at cmc and 2^nd cmc respectively. It was shown that the values of the 2^nd cmc estimated above 27 °C are only apparent due to thermal disintegration of the micelles. In the temperature range of 15 to 27 °C, the values of the 2^nd cmc increase gradually and the plot of the 2^nd cmc against temperature is concave. The ratio of 2^nd cmc/cmc for C12BBr at 25 °C amounts to 15 and appears to be high compared to the literature values for other surfactants. For comparative purposes the cmc and 2^nd cmc values were also estimated conductometrically for decyldimethylbenzylammonium bromide (C10BBr) at 25 °C. The 2^nd cmc value for this surfactant is higher compared to the value for the C12 homologue by a factor of 2.6.The standard Gibbs free energies of micellization at cmc and at the 2^nd cmc were estimated from the experimental data for both surfactants at 25 °C.     

Molecular imprinting made easy

A simple method of molecular imprinting is presented that uses a single cross-linking monomer N,O-bismethacryloyl ethanolamine (NOBE) along with template, initiator, and solvent. This formulation eliminates the need for additional functional monomers and empirical optimization of relative ratios of functional monomers, cross-linkers, and template. In fact, utilization of NOBE alone often provides molecularly imprinted polymers (MIPs) with higher performance than MIPs incorporating functional monomer (e.g., methacrylic acid).     

Linear free-energy relationships and the density functional theory: an analog of the hammett equation

Density functional theory has been applied to describe electronic substituent effects, especially in the pursuit of linear relationships similar to those observed from physical organic chemistry experiments. In particular, analogues for the Hammett equation parameters (sigma, rho) have been developed. Theoretical calculations were performed on several series of organic molecules in order to validate our model and for comparison with experimental results. The trends obtained by Hammett-like relations predicted by the model were found to be in qualitative agreement with the experimental data. The results obtained in this study suggest the applicability of similar correlation analysis based on theoretical methodologies that do not make use of empirical fits to experimental data can be useful in the study of substituent effects in organic chemistry.     

Application of Graphite-Epoxy Composite Electrodes in Differential Pulse Anodic Stripping Voltammetry of Heavy Metals

An analytical study on the use of graphite-epoxy composite (GEC) electrodes for differential pulse anodic stripping voltammetry (DPASV) of heavy metals is presented. This study is accompanied by microscopic observations of the electrode surface before and after the stripping step in comparison to glassy carbon electrode. GEC electrodes show much better accumulation properties and consequently acceptable behaviour which makes them suitable as working electrodes in the DPASV of heavy metals. Lead determination in real water samples in a batch system as well as some preliminary results in a flow-through system are presented. The detection limits in batch measurements were 100ppb for Cd, 10pb for lead and 50ppb for copper. The detection limit for lead in the flow-through system was similar to that in the batch. The results obtained show that these low cost and easy to prepare materials can be of interest in future research concerning stripping techniques of heavy metals and other analytes.