High Performance Liquid Chromatographic Analysis of Pharmaceuticals Using Oil-In-Water Microemulsion Eluent and Monolithic Column

Novel and efficient separations of pharmaceutical substances were achieved using oil-in-water microemulsion eluent and a conventional C18 packing with a flow rate of 1 mL/min⁻¹. Attempts to decrease analysis time was limited due to the high viscosity of the microemulsion which generated relatively high back-pressures. Monolithic columns gave 3-fold lower back-pressures and allowed flow rates of 4 mL/min⁻¹. with the same microemulsion mobile phase which permitted rapid separations to be achieved. Separation of a test-mix of paraben preservatives was achieved in both isocratic and gradient mode in less than 1 min. The monolith-microemulsion combination was applied to rapidly quantitatively analyse two formulated products with excellent linearity, accuracy and repeatability. Quantitative analysis times were under 90 seconds. Successful quantitation of both nicotine lozenges and naprosyn tablets was performed using this approach.     

Evaluation of cellulase preparations for hydrolysis of hardwood substrates

Seven cellulase preparations from Penicillium and Trichoderma spp. were evaluated for their ability to hydrolyze the cellulose fraction of hardwoods (yellow poplar and red maple) pretreated by organosolv extraction, as well as model cellulosic substrates such as filter paper. There was no significant correlation among hydrolytic performance on pretreated hardwood, based on glucose release, and filter paper activity. However, performance on pretreated hardwood showed significant correlations to the levels of endogenous β-glucosidase and xylanase activities in the cellulase preparation. Accordingly, differences in performance were reduced or eliminated following supplementation with a crude β-glucosidase preparation containing both activities. These results complement a previous investigation using softwoods pretreated by either organosolv extraction or steam explosion. Cellulase preparations that performed best on hardwood also showed superior performance on the softwood substrates.     

Scattering Behavior of Restructured Aggregates: A Simulation Study

Simulations of diffusion-limited cluster-cluster aggregation (DLCA) with no restructuring, full restructuring, and partial restructuring have been performed. The scattering patterns produced from these aggregates have been simulated using the Rayleigh-Gans-Debye approximation. Pure DLCA aggregates produced a scattering pattern with the slope of the fractal region being about -1.8. In contrast, the slope of the fractal region of the scattering pattern for fully restructured aggregates was about -2.1, indicating an increase in fractal dimension. Partial restructuring at large length scales produced an upward turn in the scattering pattern at low qr(o), while at high qr(o) the fractal section of the pure DLCA aggregate was retained. This last result was expected and is consistent with the results and postulations of several other workers. This simulation shows that the type of scattering pattern often obtained from orthokinetic or sheared aggregation can be produced by restructuring of aggregates at large length scales. Copyright 2001 Academic Press.     

On assignment of fundamental vibrational modes of hypophosphite anion and its deuterated analogue

Results of ab initio and density functional theory calculations on the structure and vibrational frequencies of hypophosphite anion indicate earlier experimental assignments of the fundamental vibrational modes are correct while the recent reassignments of several modes proposed by Bickley et al. are inconsistent with the calculated results.     

Intermolecular coupling in nanometric domains of light-harvesting dendrimer films studied by photoluminescence near-field scanning optical microscopy (PL NSOM)

Near-field scanning optical microscopy (NSOM) has been used to investigate the photophysical characteristics of first- to fourth-generation (G1 to G4) light-harvesting dendrimer thin films containing coumarin-343 and coumarin-2 as the core and peripheral chromophores, respectively. Thin film photoluminescence (PL) spectra exhibit a significant red shift in the lower generations (G1, G2, and G3) as compared to their respective solution PL spectra, implying the formation of excimers. Spatially resolved PL NSOM images exhibit pronounced nanoscopic domains in G1, which become more homogeneous in higher generations due to site-isolation of the core chromophore. G4 exhibits complete site-isolation for these light-harvesting dendrimer films.     

Chiral induction in self-assembled helicates: CHIRAGEN type ligands with ferrocene bridging units

The aim of this work was the preparation of enantiomerically pure bis(pinene-bipyridine) ligands containing the ferrocenyl moiety. Several such ligands (1-3) were synthesized and completely characterized. These molecules can be diastereoselectively deprotonated at the acidic methylene group of the pinene moiety using a strong and sterically hindered base such as LDA. Subsequent reaction of the formed anion with alkyl halides yield the family of C(2)-symmetric enantiopure compounds (1a-c). Copper(I), silver(I), or zinc(II) complexes with several ligands (C1-C8) were prepared and structurally characterized in the solid state and in solution. Self-assembled helical species are formed in several cases. It became evident that the chiral groups present in the ligand do not completely determined the helical configuration of the assemblages. Diastereoselectivity is thus not complete with this type of ligands, contrary to other, similar ligands studied before.     

Deactivation of silica surfaces with a silanol-terminated polysiloxane; structural sharacterization by inverse gas chromatography and solid-state NMR

Retention gape deactivated with Silicone OV-1701-OH show good chromatographic performance and remarkable stability against water induced stationary phase degradrdation. In an attempt to better understand the findamentals off the deactivation process using silanol terminated polysiloxanes, a fumed silica was deactivated with Silicon OV-1701-OH. In contrast to fused silic capillaries, fumed silica (Aerosil A-200) can be studied by ²⁹Si cross-polarization magic-angle-spinning (CPMAS) NMR, thus serving as a model substrate for fused silica. Retention data from inverse gas chromatography at infinite dilurion and ²⁹Si CP MAS NMR data of five Aerosil phases, differing in residual silanol surface concentration, are correlated with the aim of validating this approach for stationary phase characterization. A comparatively detailed model of the deactivating polymer layer that explains the observed absorption activities is deduced. Surface silanols are shown to play a key role in the polymer layer, the structure of which is of primary importance for the absorption behavior after deactivation. Contrary to common belief, the absolute silanol surface concentration after deativation is only of secondary importance for the overall absorption activity. High silanol surface concentrations enhance degradation of the polysiloxane chains into small cyclic fragments as well as subsequent absorption and immobolization to the silica substrate surface. The mobility of linear polysiloxane chains in the kHz regime (as determined bby NMR cross-polarization dynamics) appears to determine the extent which the residual silanols are accessible for analytes. It is therefore anticipated that there is an optimum silanol surface concentration of fused silica surfaces to be deactivated with silanol terminated polysiloxanes; it should be lazrge enough to adsord polymer fragments, but not large to avoid excessive residual silanol activity.     

Does alpha-fluorination affect the structural trans-influence and kinetic trans-effect of an alkyl ligand? Molecular structures of Pd(TMEDA)(CH(3))(R(F)) and a kinetic study of the trans to cis isomerization of Pt(TMEDA)(CH(3))(2)I(R(F)) [R(F) = CF(2)CF(3), CFHCF(3), CH(2)CF(3)

Reaction of Pd(TMEDA)(CH(3))(2) [TMEDA = tetramethylethylenediamine] with fluoroalkyl iodides R(F)I affords a series of square planar Pd(II) complexes Pd(TMEDA)(CH(3))(R(F)) [R(F) = CF(2)CF(3) (9), CFHCF(3) (10), CH(2)CF(3) (11)], presumably by oxidative addition followed by reductive elimination of CH(3)I. The solid-state structures of each compound have been determined by single crystal X-ray diffraction studies, allowing the effect of increasing alpha-fluorination on the structural trans-influence of alkyl ligands to be examined. In these compounds there is no significant difference observed in the trans-influence of the three fluorinated alkyl ligands toward the trans-N atom, although a significant cis-influence on the neighboring methyl ligand is apparent. Oxidative addition of the same series of fluoroalkyl ligands to the corresponding Pt(TMEDA)(CH(3))(2) affords octahedral Pt(IV) complexes trans-Pt(TMEDA)(CH(3))(2)(R(F))I [R(F) = CF(2)CF(3) (12), CFHCF(3) (13), CH(2)CF(3) (14)] as the kinetic products. In each case, subsequent isomerization to the corresponding all cis-isomers is observed; in the case of 13, the stereocenter at the alpha-carbon results in two diastereomeric cis-isomers, which are formed at different rates. The molecular structures of 13 and its more stable all cis-isomer 16b have been crystallographically determined. Kinetic studies of the trans-cis isomerization reactions show the mechanism to involve a polar transition state, presumably involving iodide dissociation, followed by rearrangement of the cation, and iodide recombination. High dielectric solvents increase the rate, but solvent coordinating ability has no effect. Dissolved salts (LiI, LiOTf) show normal accelerative salt effects, with no inhibition in the case of added iodide, consistent with the formation of an intimate ion pair intermediate. The kinetic parameters show that the trans-effects of fluoroalkyl ligands in these compounds follow the order expected from the relative sigma-donor properties of the ligands, with CF(2)CF(3) < CFHCF(3) < CH(2)CF(3).     

Plutonium process control using an on-line gamma monitor for uranium,plutonium, and Americium

An On-Line Gamma Monitor profiles the concentration of uranium, plutonium, and americium in waste and product streams of the anion exchange process used to purify plutonium at Los Alamos. The Monitor employs passive gamma Spectrometry to measure the 59.5-KeV and 129-KeV gamma rays of²⁴¹Am and²³⁹Pu, respectively. Because the uranium impurity in typical process streams has no gamma ray suitable for passive measurement, a novel radiotracer technique is used. Uranium-237, always present in plutonium processed at Los Alamos as a minor alpha-decay daughter of²⁴¹Pu, has a 6.8-day half-life and 208-KeV gamma energy, which make it an ideal radiotracer for macro amounts of uranium in the process. The On-Line Gamma Monitor is used routinely to provide Los Alamos operators with continuous, real-time process control information.