Autoionization mediated by electron transfer

Electron-electron coincidence spectra of Ar-Kr clusters after photoionization have been measured. An electron with the kinetic energy range from 0 to approximately 1 eV is found in coincidence with the Ar 3s cluster photoelectron. The low kinetic energy electron can be attributed to an Ar + Kr+ + Kr+ final state which forms after electron transfer mediated decay. This autoionization mechanism results from a concerted transition involving three different atoms in a van der Waals cluster; it was predicted theoretically, but hitherto not observed.     

Underwound DNA under tension: structure, elasticity, and sequence-dependent behaviors

DNA melting under torsion plays an important role in a wide variety of cellular processes. In the present Letter, we have investigated DNA melting at the single-molecule level using an angular optical trap. By directly measuring force, extension, torque, and angle of DNA, we determined the structural and elastic parameters of torsionally melted DNA. Our data reveal that under moderate forces, the melted DNA assumes a left-handed structure as opposed to an open bubble conformation and is highly torsionally compliant. We have also discovered that at low forces melted DNA properties are highly dependent on DNA sequence. These results provide a more comprehensive picture of the global DNA force-torque phase diagram.     

Laser induced mixing in multilayered Ti/Ta thin film structures

The possibility of interlayer mixing in a Ti/Ta multilayer system, induced by laser irradiation, was the main purpose of these experiments. Ti/Ta multilayer system, consisting of ten alternating Ti and Ta thin films and covered by slightly thicker Ti layer, was deposited on Si (100) wafers to a total thickness of 205 nm. Laser irradiation was performed in air by picoseconds Nd:YAG laser pulses in defocused regime with fluences of 0.057 and 0.11 J cm^?2. Laser beam was scanned over the 5?×?5 mm surface area with different steps along y-axes. Structural and compositional characterisation was done by auger electron spectroscopy, X-ray photoelectron spectroscopy, atomic force microscopy, and scanning electron microscopy. Laser processing at lower fluence caused only oxidation of the top Ti layer, despite of the number of applied laser pulses. Interlayer mixing was not observed. Application of laser pulses at fluence of 0.11 J cm^?2 caused partial and/or complete ablation of deposited layers. In partially ablated regions considerable mixing between Ti and Ta films was registered.     

Propagation of surface plasmon polaritons through gradient index and periodic structures

We study propagation of surface electromagnetic waves along a metallic surface covered by various layered dielectric structures. We show that strong radiative losses, typical for scattering of a surface wave, can be considerably suppressed when a single dielectric step is substituted by gradient index or periodic layered structure.     

Hot-electron-driven enhancement of spin-lattice coupling in Gd and Tb 4f ferromagnets observed by femtosecond x-ray magnetic circular dichroism

Femtosecond x-ray magnetic circular dichroism was used to study the time-dependent magnetic moment of 4f electrons in the ferromagnets Gd and Tb, which are known for their different spin-lattice coupling. We observe a two-step demagnetization with an ultrafast demagnetization time of 750 fs identical for both systems and slower times which differ sizeably with 40 ps for Gd and 8 ps for Tb. We conclude that spin-lattice coupling in the electronically excited state is enhanced up to 50 times compared to equilibrium.     

Shrimp-shape domains in a dissipative kicked rotator

Some dynamical properties for a dissipative kicked rotator are studied. Our results show that when dissipation is taken into account a drastic change happens in the structure of the phase space in the sense that the mixed structure is modified and attracting fixed points and chaotic attractors are observed. A detailed numerical investigation in a two-dimensional parameter space based on the behavior of the Lyapunov exponent is considered. Our results show the existence of infinite self-similar shrimp-shaped structures corresponding to periodic attractors, embedded in a large region corresponding to the chaotic regime.     

Application of continuous flow and alternative energy devices for 5-hydroxymethylfurfural production

Dehydration of fructose and glucose in dipolar, aprotic solvents leads to formation of 5-hydroxymethylfurfural. Conditions for continuous flow reactions using a cartridge-based reactor system and a stop-flow microwave reactor were established showing very good product yields and selectivity without the limitation of a batch process such as upscaling and precise temperature monitoring and control. A maximum product HPLC yield of 90.3% under cartridge-based heating and 85.6% under microwave heating could be achieved using mild and quick reaction conditions. Formation of levulinic acid as a by-product could not be detected under the optimized reaction conditions.     

Intensive 2-phenylethanol production in a hybrid system combined of a stirred tank reactor and an immersed extraction membrane module

Bioconversion of l-phenylalanine to 2-phenylethanol using Saccharomyces cerevisiae is connected with the growth of biomass strongly limited by product inhibition. Therefore, fermentation can proceed only at low conversions of l-phenylalanine with very low yield of the desired product, which allows reaching the maximum concentration of 2-phenylethanol, 4 g L^?1, in an ordinary batch, fed-batch, or chemostat bioreactor. To minimize capital and operating costs in the bioproduction of chemical specialties where the product inhibits the bioreaction, using a hybrid system based on the application of membrane extraction integrated in the bioreactor to remove the product is a suitable solution. Integration can be done by an external module for membrane extraction or, as a more efficient solution, by an extraction membrane module immersed directly in the bioreactor. Such a hybrid system can be used to remove 2-phenylethanol from the fermentation media and thus to overcome the product inhibition of the biotransformation process. In this paper, a hybrid system consisting of a stirred tank bioreactor (3.5 L) and an immersed extraction hollow fiber membrane module was studied. In the proposed system, the kinetics of 2-phenylethanol extraction from a water solution with and without biomass in the bioreactor to alkanes at different operational conditions was measured. Extraction kinetics was compared with the predictions obtained by a mathematical model. In the hybrid system, two extractive biotransformation experiments were performed and compared with that without product removal. Experimental data were also mathematically predicted with good accuracy between the simulation and the experiment.     

Supercritical CO2 Extraction of Triterpenoids from Chaga Sterile Conk of Inonotus obliquus

Triterpenoids are among the bioactive components of Chaga, the sterile conk of the medicinal fungus Inonotus obliquus. Supercritical fluid extraction of Chaga triterpenoids was carried out with supercritical CO₂, while a modified Folch method was used as a comparison. Three temperature-pressure combinations were tested varying between 314–324 K (40–50 °C) and 281–350 bars, using time- and volume-limited extractions. Six triterpenoids were identified with GC-MS and quantified with GC-FID: ergosterol, lanosterol, β-sitosterol, stigmastanol, betulin, and inotodiol. The Folch extraction resulted in recovery of trametenolic acid, which was not extracted by supercritical CO₂. Inotodiol was the major triterpenoid of all the extracts, with a yield of 87–101 mg/100 g and 139 mg/100 g, for SFEs and the Folch method, respectively. The contents of other major triterpenoids, lanosterol and ergosterol, varied in the ranges 59–63 mg/100 g and 17–18 mg/100 g by SFE, respectively. With the Folch method, the yields were 81 mg/100 g and 40 mg/100 g, respectively. The highest recovery of triterpenoids with SFE in relation to Folch was 56% and it was obtained at 324 K (50 °C) and 350 bar, regardless of extraction time or volume of CO₂. The recoveries of lanosterol and stigmastanol were unaffected by SFE conditions. Despite the lower yield, SFE showed several advantages including shorter extraction time and less impact on the environment. This work could be a starting point for further studies on green extraction methods of bioactive triterpenoids from Chaga.