Determination of mineral balances in sheep offered feed with added cadmium and zinc

The optimum conditions for microwave digestion of herbage and faeces to determine mineral concentrations were obtained by varying sample mass, reagent and heating programme, and it was confirmed that the resulting element concentrations were the same as for certified reference material. The effects of feeding cadmium to sheep at a level that is typical of polluted regions (1 mg/kg) for ten days were investigated, as well as the possible amelioration of cadmium effects by adding 30 mg/kg Zn to the diet. Cadmium in the feed increased the cadmium balance and produced several mineral disturbances, in particular a reduction in sodium balance which is typical of renal tubular disorders. Including zinc in the diet as well as cadmium reduced the cadmium balance to a level similar to that of sheep that did not receive cadmium or zinc, which suggests that the zinc status is critical in determining whether cadmium in feed increases the cadmium balance in sheep. Received: 1 August 1997 / Revised: 8 December 1997 / Accepted: 10 December 1997     

Non-chromatographic screening procedure for arsenic speciation analysis in fish-based baby foods by using electrothermal atomic absorption spectrometry

A procedure for the speciation analysis of arsenic in fish-based baby foods is presented. Inorganic arsenic, methylarsonic acid (MA), dimethylarsinic acid (DMA) and arsenobetaine (AB) were determined by electrothermal atomic absorption spectrometry (ETAAS) using suspensions prepared in a 0.01 mol L⁻¹ tetramethylammonium hydroxide (TMAH) solution. Speciation is based on the use of three different chemically modified ETAAS atomizers to obtain the analytical signals. Using a palladium salt as the chemical modifier, the signal corresponding to the total arsenic concentration is obtained. When palladium is replaced by Ce(IV), the signal is solely due to inorganic arsenic (III and V) + MA. If no signal is obtained in this latter case, it is possible to distinguish between DMA and AB using a zirconium coated atomizer. The signal obtained in this way is due solely to DMA, and the concentration of AB can be obtained by the difference with the total arsenic content. Determinations by ETAAS require the use of the standard additions method. The limits of detection for the determination of AB, DMA and inorganic arsenic (+MA) are 15, 25 and 50 ng g⁻¹ expressed as arsenic, respectively. These detection limits are good enough for the procedure to be appropriate for the rapid determination of these compounds, avoiding extraction processes and/or chromatographic separations. Data for commercial samples, as well as for four standard reference materials, are given.     

Time-dependent local-to-normal mode transition in triatomic molecules

Time-evolution of the vibrational states of two interacting harmonic oscillators in the local mode scheme is presented. A local-to-normal mode transition (LNT) is identified and studied from temporal perspective through time-dependent frequencies of the oscillators. The LNT is established as a polyad-breaking phenomenon from the local standpoint for the stretching degrees of freedom in a triatomic molecule. This study is carried out in the algebraic representation of bosonic operators. The dynamics of the states are determined via the solutions of the corresponding nonlinear Ermakov equation and a local time-dependent polyad is obtained as a tool to identify the LNT. Applications of this formalism to H₂O, CO₂, O₃ and NO₂ molecules in the adiabatic, sudden and linear regime are considered.     

β-Caryophyllene: A Therapeutic Alternative for Intestinal Barrier Dysfunction Caused by Obesity

Obesity is an excessive accumulation of fat that exacerbates the metabolic and inflammatory processes. Studies associate these processes with conditions and dysregulation in the intestinal tract, increased concentrations of lipopolysaccharides (LPSs) in the blood, differences in the abundance of intestinal microbiota, and the production of secondary metabolites such as short-chain fatty acids. β-Caryophyllene (BCP) is a natural sesquiterpene with anti-inflammatory properties and with the potential purpose of fighting metabolic diseases. A diet-induced obesity model was performed in 16-week-old C57BL/6 mice administered with BCP [50 mg/kg]. A reduction in the expression of Claudin-1 was observed in the group with a high-fat diet (HFD), which was caused by the administration of BCP; besides BCP, the phyla Akkermansia and Bacteroidetes decreased between the groups with a standard diet (STD) vs. HFD. Nevertheless, the use of BCP in the STD increased the expression of these phyla with respect to fatty acids; a similar effect was observed, in the HFD group that had a decreasing concentration that was restored with the use of BCP. The levels of endotoxemia and serum leptin increased in the HFD group, while in the HFD + BCP group, similar values were found to those of the STD group, attributing the ability to reduce these in conditions of obesity.     

Role of grain boundary energetics on the maximum strength of nanocrystalline Nickel

Numerical simulations are used to investigate the competing grain boundary and dislocation mediated deformation mechanisms in nanocrystalline Ni with grain sizes in the range 4-32 nm. We present a 3D phase field model that tracks the evolution of individual dislocations and grain boundaries. Our model shows that the transition from Hall-Petch to inverse Hall-Petch as the grain size is reduced cannot be characterized only by the grain size, but it is also affected by the grain boundary energetics. We find that the grain size corresponding to the maximum yield stress (the transition from Hall-Petch strengthening with decreasing grain size to inverse Hall-Petch) decreases with increasing grain boundary energy. Interestingly, we find that for grain boundaries with high cohesive energy the Hall-Petch maximum is not observed for grains in the range 4-32 nm.     

Simultaneous Determination of Antimony(III) and Molybdenum(VI) by Adsorptive Stripping Voltammetry Using Quercetin as Complexing Agent

A sensitive and selective voltammetric method for simultaneous determination of Sb(III) and Mo(VI) using Quercetin (Q) as complexing agent is described. Optimal conditions were found to be: pH 3.7, C_Q=6.0 µmol L^?1 and E_acc=?0.10 V. The LOD (3σ) for Sb(III) are 0.076 and 0.040 µg L^?1, whereas for Mo(VI) are 0.086 and 0.048 µg L^?1 with t_acc of 60 and 120 s, respectively. The method was validated using synthetic sea water (ASTM D665) and was applied to the determination of Sb(III) and Mo(VI) in natural waters with satisfactory results.     

Synthesis and Kinetic Study of Hydroxy/Fluoroapatite Solid Solution Formation by Decomposition of a Ca‐EDTA Complex

Fluoroapatite/hydroxyapatite (FA/HA) solid solutions were synthesized through the decomposition of a Ca(EDTA) complex in presence of phosphate and fluoride ions. Fluorine content and morphology depend on initial pH value. Phase identification, fluorine content, crystallinity and morphology of the obtained products were studied via chemical analysis, FTIR, SEM, XRD, and EDS. The kinetic study shows a catalytic dependence on pH value. The values of k₀, k_H+ and k_OH are reported.     

Biosorption of cadmium,copper, lead and zinc by inactive biomass of<Emphasis Type="Italic"> Pseudomonas Putida</Emphasis>

The accumulation of Cd(II), Cu(II), Pb(II) and Zn(II) at mg L(-1) concentration levels by inactive freeze-dried biomass of Pseudomonas Putida has been investigated. These metals could be efficiently removed from diluted aqueous solutions. A contact time of 10 min was sufficient to reach equilibrium. The pH has a strong effect on metal biosorption and the optimal pH values were 6.0, 5.0-6.0, 6.0-6.5 and 7.0-7.5 for Cd(II), Cu(II), Pb(II) and Zn(II) respectively. Under these conditions there was 80% removal for all metals studied. The process of biosorption can be described by a Langmuir-type adsorption model. This model accounts for 98% of the data variance. The K(A) and q(max) parameters for each metal are strongly correlated (at confidence levels greater than 98%) with the metal acidity, quantified by the constant of the corresponding M(OH)(+) complex, thus confirming previous assertions by other authors.