Determination of fluoride in complex liquid matrices by electrothermal atomic absorption spectrometry with in-furnace oxygen-assisted ashing

A new chemical method is reported for the determination of total fluoride in complex liquids and suspensions, such as fruit juices, urine, serum and blood. It is based on the formation of the A1F radical in a graphite furnace afterin situ oxygen-assisted ashing of the untreated sample. The absorbance of this radical is measured at 227.45 nm. The method is relatively easy to use and provides a low detection limit (14 ng/ml) and reasonable reproducibility (5–10%).     

Thienopyrrolizines: New condensed triheterocyclic systems

Cyclization of 3-(1-pyrrolyl)thiophene-2-carboxamide derivatives of methyl 3-(1-pyrrolyl)-2-thiophenecarboxylate afforded imminium salts and resulted in the formation of thieno[2,3-b]pyrrolizine derivatives.     

Mass spectrometry of 3,4-dihydroquinazolin-4-ones of pharmaceutical interest. Part 3 . Electron ionization mass spectra of 2-substituted-3-(5′-pyrazolyl)-4(3H)-quinazolinones

The fragmentation reactions induced by electron impact of eighteen title compounds has been investigated with the aid of low beam energy spectra (14 eV, nom. value), metastable ion detection, high resolution measurements and labelling experiments. The loss of the 4-carbonyl oxygen together with the 3-substituent, which constitutes a characteristic fragmentation route of 3-aryl and 3-heteroaromatic substituted-4(3H)-quinazolinones, is again observed, but the presence of a carboxyethyl group at the 4′-position of the pyrazole ring is responsible of an anomalous loss of 47 daltons from the molecular ion. Lastly, a comparison with the previously described behaviour of 3-(5′-isoxazolyl) derivatives was carried out.     

Depolymerization of water soluble coal polymer from subbituminous coal and lignite by lignin peroxidase

Coal polymers, water soluble at pH 3.5, were prepared from North Dakota lignite and German subbituminous coal in 35–61% yield. Gel permeation chromatography showed a major component of relatively narrow molecular weight range >75,000. The material did not dialyze through a 12,000-14,000 MW cutoff membrane under several conditions. Minor amounts of smaller fragments were present, but monomeric components were not detected. Incubation of soluble polymer with lignin peroxidase ofPhanerochaete chrysosporium caused substantial disappearance of the high molecular weight polymer and formation of smaller amounts of both higher and lower molecular weight components, but not of monomeric compounds. Addition of veratryl alcohol enhanced depolymerization. Coal polymer competitively inhibited veratryl alcohol oxidation by lignin peroxidase.

     

1H-NMR,Ultraviolet and infrared spectra of some (Z)-α-(phenyl)-β-(2-furyl), -(2-pyrrolyl) and -(N-methyl-2-pyrrolyl)acrylonitriles

The ¹H-nmr data of some (Z)-α-(p-substituted-phenyl)-β-(2-furyl), -(2-pyrrolyl), and -(N-methyl-2-pyrrolyl)-acrylonitriles have been investigated to indicate the preferred conformation and to establish the conformational preferences of the β-heterocyclic ring. The ultraviolet spectra have been discussed in order to obtain information about the chromophores responsible for the absorption. The infrared spectra have been analyzed for the identification of the main absorption frequencies of cyano and ethylenic groups and to assign the characteristic absorption bands to specific normal vibrations of the heteroaromatic nuclei.     

Synthesis of 5-Substituted 1,3-Dimethylpyrazolo[4,3-e][1,2,4]triazines

A novel method for the synthesis of a new series of 5-substituted 1,3-dimethyl pyrazolo[4,3-e][1,2,4]triazines is described. The new synthetic strategy is based on the classical Bischler 1,2,4-benzotriazine synthesis. This approach involves the preparation of 5-hydrazinopyrazole from 5-chloro-1,3-dimethyl-4-nitropyrazole followed by acylation and nitro group reduction to form the corresponding 4-amino-3-(acylhydrazino)pyrazoles. Intramolecular oxidative cyclization of the latter derivatives, using polyphosphoric acid, produced the respective target pyrazolotriazines.     

Routine determination of major anions in atmospheric aerosols by capillary electrophoresis

Capillary electrophoresis (CE) with indirect UV detection utilizing a pyromellitate-based electrolyte was used for the routine analysis of major anions in atmospheric aerosols collected on filters with high-volume (Hi-Vol) samplers. The long-term reliability of the CE system was checked over an 8-month period during which over 2900 samples were analyzed. In addition, approximately 1100 samples were analyzed in parallel by ion chromatography (IC). It has been shown that acceptable analytical performance can be routinely obtained. The agreement between the CE and IC results is good, generally better than 20% at concentrations larger than 1 mg l⁻¹.     

Characterization of cocoa butters and other vegetable fats by pyrolysis-mass spectrometry

Pyrolysis Mass Spectrometry (Py-MS) was used for the discrimination of cocoa butters from other vegetable fats. Mass spectra ranging from 50 amu to 250 amu were analyzed by principal component analysis (PCA) and with neural nets. The application of neural nets leads to a good discrimination between the two classes. Detailed analysis of the nets revealed that only the first 60 masses were used within the net. The use of PCA requires a careful selection of the number of masses included in the calculation. Canonical variance analysis was applied to determine the significant masses. Optimal performance of PCA was observed only using the first 22 significant masses. Most of these masses were different from the ones used by the neural net. It seems that the mass spectra obtained by Py-MS contain sufficient information for the discrimination of pure cocoa butter from other vegetable fats, but none of the methods seems to be able to extract all information available. Neural net provides a very robust method for this task and no prior data selection was necessary. Received: 13 May 1996 / Revised: 7 August 1996 / Accepted: 7 August 1996     

Determination of thallium and lead in cadmium salts by anodic stripping voltammetry with addition of surfactants to suppress the cadmium peaks

Conditions have been found which make possible the determination of thallium and/or lead in cadmium and its salts without preliminary separation. The electrochemical activity of the cadmium, which usually interferes in the determination of thallium, is inhibited by the addition of 0.01% of polyethylene glycol of M.W. 4000. Thallium is determined by electrolysis at ?0.74 V vs. SCE, in 0.1M EDTA solution: 10^?1M thallium can be determined in the presence of 0.1M cadmium, while copper and lead at 10^?2M and 10^?5M respectively do not interfere. Lead is determined in 0.1M acetic acid containing 0.1% cetyltrimethylammonium bromide (CTAB). The addition of CTAB shifts the cadmium peak, as well as the optimum deposition potential for cadmium, to more negative values, making it possible to determine lead in the presence of cadmium as long as the deposition potential lies in the range between ?0.50 and ?0.56 V vs. SCE. Lead can be determined in the presence of ten times as much thallium.     

Charge transfer across a polymer gel/liquid interface: determination of ionophores

An electrochemical method for the determination of the ionophores monensin and lasalocid was developed, based on the polarization of an agar gel/nitrobenzene electrolyte interface. The measured current corresponding to the facilitated ion transfer across this interface is directly proportional to the concentration of an ionophore dissolved in the organic phase. Using cyclic voltammetry in a three-electrode system the detection limit for both ionophores is about 3 × 10^?5 M.