Thienopyrrolizines: New condensed triheterocyclic systems

Cyclization of 3-(1-pyrrolyl)thiophene-2-carboxamide derivatives of methyl 3-(1-pyrrolyl)-2-thiophenecarboxylate afforded imminium salts and resulted in the formation of thieno[2,3-b]pyrrolizine derivatives.     

Mass spectrometry of 3,4-dihydroquinazolin-4-ones of pharmaceutical interest. Part 3 . Electron ionization mass spectra of 2-substituted-3-(5′-pyrazolyl)-4(3H)-quinazolinones

The fragmentation reactions induced by electron impact of eighteen title compounds has been investigated with the aid of low beam energy spectra (14 eV, nom. value), metastable ion detection, high resolution measurements and labelling experiments. The loss of the 4-carbonyl oxygen together with the 3-substituent, which constitutes a characteristic fragmentation route of 3-aryl and 3-heteroaromatic substituted-4(3H)-quinazolinones, is again observed, but the presence of a carboxyethyl group at the 4′-position of the pyrazole ring is responsible of an anomalous loss of 47 daltons from the molecular ion. Lastly, a comparison with the previously described behaviour of 3-(5′-isoxazolyl) derivatives was carried out.     

Depolymerization of water soluble coal polymer from subbituminous coal and lignite by lignin peroxidase

Coal polymers, water soluble at pH 3.5, were prepared from North Dakota lignite and German subbituminous coal in 35–61% yield. Gel permeation chromatography showed a major component of relatively narrow molecular weight range >75,000. The material did not dialyze through a 12,000-14,000 MW cutoff membrane under several conditions. Minor amounts of smaller fragments were present, but monomeric components were not detected. Incubation of soluble polymer with lignin peroxidase ofPhanerochaete chrysosporium caused substantial disappearance of the high molecular weight polymer and formation of smaller amounts of both higher and lower molecular weight components, but not of monomeric compounds. Addition of veratryl alcohol enhanced depolymerization. Coal polymer competitively inhibited veratryl alcohol oxidation by lignin peroxidase.

     

1H-NMR,Ultraviolet and infrared spectra of some (Z)-α-(phenyl)-β-(2-furyl), -(2-pyrrolyl) and -(N-methyl-2-pyrrolyl)acrylonitriles

The ¹H-nmr data of some (Z)-α-(p-substituted-phenyl)-β-(2-furyl), -(2-pyrrolyl), and -(N-methyl-2-pyrrolyl)-acrylonitriles have been investigated to indicate the preferred conformation and to establish the conformational preferences of the β-heterocyclic ring. The ultraviolet spectra have been discussed in order to obtain information about the chromophores responsible for the absorption. The infrared spectra have been analyzed for the identification of the main absorption frequencies of cyano and ethylenic groups and to assign the characteristic absorption bands to specific normal vibrations of the heteroaromatic nuclei.     

Routine determination of major anions in atmospheric aerosols by capillary electrophoresis

Capillary electrophoresis (CE) with indirect UV detection utilizing a pyromellitate-based electrolyte was used for the routine analysis of major anions in atmospheric aerosols collected on filters with high-volume (Hi-Vol) samplers. The long-term reliability of the CE system was checked over an 8-month period during which over 2900 samples were analyzed. In addition, approximately 1100 samples were analyzed in parallel by ion chromatography (IC). It has been shown that acceptable analytical performance can be routinely obtained. The agreement between the CE and IC results is good, generally better than 20% at concentrations larger than 1 mg l⁻¹.     

Dynamics and energetics of the self-assembly of a hydrophobically modified polyelectrolyte: Naphthalene-labeled poly(acrylic acid)

Steady-state and time-resolved fluorescence studies were performed on aqueous solutions of poly(acrylic acid) hydrophobically modified with two very different levels of naphthalene (Np). It is demonstrated that unique information on association phenomena involving hydrophobe-modifed polymers can be obtained from an extended fluorescence study by using data for a less-modified polymer as a reference. For the more highly modified polymer, the presence of excited-state (as well as ground-state) dimers in addition to monomer emission due to locally excited naphthalene gives evidence for hydrophobic association between naphthalene groups. This association becomes, as expected, much less important at higher pH due to the electrostatic repulsion between different chain segments. However, it is noted that even at high pH there is a significant self-association. The coexistence of static and dynamic quenching phenomena of the Np monomer label was also revealed in the time-resolved fluorescence data. The data are compatible with the existence of two types of monomers and one excimer and suggest that the essential contribution to the monomer emission comes from isolated chromophores, whereas excimer formation arises from both a dynamic route (excited Np chromophores able to produce a dynamic excimer) and a static route (excitation of ground-state Np dimers). At room temperature, the dissociative reaction, excimer-to-monomer, can be neglected, and thus the rate constant for excimer formation and decay could be obtained with and without considering the influence of preformed dimers. Temperature has shown to induce different behavior in the polymer photophysics. In the case of the less-labeled polymer, the decays were found to be single-exponential with the fluorescence lifetime decreasing with increasing temperature. From the temperature dependence of the steady-state fluorescence data, the activation energy for excimer formation and the binding energy of the excimer were evaluated at different pH values, through the Stevens-Ban-type plots of the excimer-to-monomer intensity ratio. With the time-resolved data, measured in the temperature range of 5-60 degrees C, it was possible to extract the intrinsic activation energies for excimer formation. The thermodynamic driving force for the intrapolymeric association was found to be dependent on a balance between hydrophobic and electrostatic interactions, which are dependent on the pH, temperature, and hydrophobic content of the polymer.     

Determination of complex formation constants by phase sensitive alternating current polarography: Cadmium-polymethacrylic acid and cadmium-polygalacturonic acid

The use of phase sensitive alternating current polarography (ACP) for the evaluation of complex formation constants of systems where electrodic adsorption is present has been proposed. The applicability of the technique implies the previous selection of the phase angle where contribution of capacitive current is minimized. This is made using Multivariate Curve Resolution by Alternating Least Squares (MCR-ALS) in the analysis of ACP measurements at different phase angles. The method is checked by the study of the complexation of Cd by polymethacrylic (PMA) and polygalacturonic (PGA) acids, and the optimal phase angles have been ca. −10° for Cd-PMA and ca. −15° for Cd-PGA systems. The goodness of phase sensitive ACP has been demonstrated comparing the determined complex formation constants with those obtained by reverse pulse polarography, a technique that minimizes the electrode adsorption effects on the measured currents.     

Thermal degradation of copolymers of styrene with dicarboxylic acids - II: Copolymers obtained by radical copolymerisation of styrene with maleic acid or fumaric acid

Thermal degradation processes in copolymers of styrene with two stereoisomers of 1,2-ethylenedicarboxylic acids (i.e. maleic acid (the cis-isomer) and fumaric acid (the trans-isomer)) have been studied by mass spectrometry, FTIR and TG measurements. The influence of the chemical composition on thermal degradation of copolymers with acid by non-isothermal thermogravimetric analysis (TG) was also studied. The stereo-configuration of carboxyl groups in copolymers was analysed by potentiometric titration. It was found that copolymers degrade in two main complex stages. The initial step in the decomposition involves the formation of cyclic five-membered anhydrides. The presence of trans configuration of carboxyl groups hinders the formation of cyclic anhydrides and shifts the decomposition to higher temperatures, making decarboxylation competitive. At higher temperatures anhydride decomposition takes place and finally the degradation of main chains occurs.     

Characterization of cocoa butters and other vegetable fats by pyrolysis-mass spectrometry

Pyrolysis Mass Spectrometry (Py-MS) was used for the discrimination of cocoa butters from other vegetable fats. Mass spectra ranging from 50 amu to 250 amu were analyzed by principal component analysis (PCA) and with neural nets. The application of neural nets leads to a good discrimination between the two classes. Detailed analysis of the nets revealed that only the first 60 masses were used within the net. The use of PCA requires a careful selection of the number of masses included in the calculation. Canonical variance analysis was applied to determine the significant masses. Optimal performance of PCA was observed only using the first 22 significant masses. Most of these masses were different from the ones used by the neural net. It seems that the mass spectra obtained by Py-MS contain sufficient information for the discrimination of pure cocoa butter from other vegetable fats, but none of the methods seems to be able to extract all information available. Neural net provides a very robust method for this task and no prior data selection was necessary. Received: 13 May 1996 / Revised: 7 August 1996 / Accepted: 7 August 1996     

Determination of thallium and lead in cadmium salts by anodic stripping voltammetry with addition of surfactants to suppress the cadmium peaks

Conditions have been found which make possible the determination of thallium and/or lead in cadmium and its salts without preliminary separation. The electrochemical activity of the cadmium, which usually interferes in the determination of thallium, is inhibited by the addition of 0.01% of polyethylene glycol of M.W. 4000. Thallium is determined by electrolysis at ?0.74 V vs. SCE, in 0.1M EDTA solution: 10^?1M thallium can be determined in the presence of 0.1M cadmium, while copper and lead at 10^?2M and 10^?5M respectively do not interfere. Lead is determined in 0.1M acetic acid containing 0.1% cetyltrimethylammonium bromide (CTAB). The addition of CTAB shifts the cadmium peak, as well as the optimum deposition potential for cadmium, to more negative values, making it possible to determine lead in the presence of cadmium as long as the deposition potential lies in the range between ?0.50 and ?0.56 V vs. SCE. Lead can be determined in the presence of ten times as much thallium.