Fast screening of 88 pharmaceutical drugs and metabolites in whole blood by ultrahigh-performance liquid chromatography–tandem mass spectrometry

Forensic investigations involving acute or lethal intoxication, drug-facilitated sexual assault, driving or workplace impairment frequently require the analysis of fresh or postmortem blood samples to check out a wide variety of pharmaceutical and illicit drugs, even after single-dose consumption. A sensitive and selective ultrahigh-performance liquid chromatography–tandem mass spectrometry (UHPLC–MS/MS) screening method was developed for fast screening of 88 psychoactive drugs and metabolites in blood samples, including the ones most frequently involved in acute intoxications and forensic investigations in Italy. The new method allows short sample processing and analysis time (the whole procedure can be accomplished in less than 30 min) together with the simultaneous monitoring of a large number of pharmaceutical substances. These features represent crucial factors in the approach of acute intoxications, when the patient requires urgent and appropriate therapy. Blood sample treatment was limited to protein precipitation. Two UHPLC–MS/MS runs in positive and negative electrospray ionization modes were performed. The data were acquired at unit mass resolution in the selected reaction monitoring mode. According to international guidelines, linearity range, precision, trueness, detection and quantification limits, recovery, selectivity, specificity, carryover, and matrix effect phenomena were determined. Despite the limited sample purification and the inherent decreased chance of eliminating any potential interference, the present multiresidue screening method proved extremely effective and sensitive, allowing the detection of all tested drugs, even those belonging to structurally different classes of substances. Moreover, the developed method is easily susceptible to further expansion to encompass more drugs, either new or those becoming important for criminal investigation. This protocol was also applied to the analysis of authentic blood samples collected from victims of various crimes in routine casework, whose relevance in forensic investigations is presented in five cases.     

Ionomic profiling of Nicotiana langsdorffii wild-type and mutant genotypes exposed to abiotic stresses

To provide a new insight into the response of plants to abiotic stresses, the ionomic profiles of Nicotiana langsdorffii specimens have been determined before and after exposure to toxic metals (chromium) or drought conditions. The plants were genetically transformed with the rat glucocorticoid receptor (GR) or the gene for Agrobacterium rhizogenes rolC, because these modifications are known to produce an imbalance in phytohormone equilibria and a significant change in the defence response of the plant. Elemental profiles were obtained by developing and applying analytical procedures based on inductively coupled plasma atomic emission and mass spectrometry (ICP–AES/MS). In particular, the removal of isobaric interferences affecting the determination of Cr and V by ICP–MS was accomplished by use of a dynamic reaction cell, after optimization of the relevant conditions. The combined use of ICP atomic emission and mass spectrometry enabled the determination of 29 major and trace elements (Ba, Bi, Ca, Cd, Co, Cr, Cu, Eu, Fe, Ga, K, Li, Mg, Mn, Mo, Na, P, Pb, Pt, Rb, S, Sb, Sn, Sr, Te, V, W, Y, and Zn) in different parts of the plants (roots, stems, and leaves), with high accuracy and precision. Multivariate data processing and study of element distribution patterns provided new information about the ionomic response of the target organism to chemical treatment or water stress. Genetic modification mainly affected the distribution of Bi, Cr, Mo, Na, and S, indicating that these elements were involved in biochemical processes controlled by the GR or rolC genes. Chemical stress strongly affected accumulation of several elements (Ba, Ca, Fe, Ga, K, Li, Mn, Mo, Na, P, Pb, Rb, S, Sn, Te, V, and Zn) in different ways; for Ca, Fe, K, Mn, Na, and P the effect was quite similar to that observed in other studies after treatment with other transition elements, for example Cu and Cd. The effect of water deficit was less evident, mainly consisting in a decrease of Ba, Cr, Na, and Sr in roots.

A multiresidual method based on ion-exchange chromatography with conductivity detection for the determination of biogenic amines in food and beverages

In the present work a sensitive and accurate method by ion chromatography and conductimetric detection has been developed for the determination of biogenic amines in food samples at microgram per kilogram levels. The optimized extraction procedure of trimethylamine, triethylamine, putrescine, cadaverine, histamine, agmatine, spermidine, and spermine from real samples, as well as the separation conditions based on a multilinear gradient elution with methanesulfonic acid and the use of a weak ionic exchange column, have provided excellent results in terms of resolution and separation efficiency. Extended calibration curves (up to 200 mg/kg, r?>?0.9995) were obtained for all the analyzed compounds. The method gave detection limits in the range 23–65 μg/kg and quantification limits in spiked blank real samples in the range 65–198 μg/kg. Recovery values ranged from 82 to 103 %, and for all amines, a good repeatability was obtained with precision levels in the range 0.03–0.32 % (n?=?4). The feasibility and potential of the method were tested by the analysis of real samples, such as tinned tuna fish, anchovies, cheese, wine, olives, and salami.

Layered-double-hydroxide-modified electrodes: electroanalytical applications

Two-dimensional inorganic solids, such as layered double hydroxides (LDHs), also defined as anionic clays, have open structures and unique anion-exchange properties which make them very appropriate materials for the immobilization of anions and biomolecules that often bear an overall negative charge. This review aims to describe the important aspects and new developments of electrochemical sensors and biosensors based on LDHs, evidencing the research from our own laboratory and other groups. It is intended to provide an overview of the various types of chemically modified electrodes that have been developed with these 2D layered materials, along with the significant advances made over the last several years. In particular, we report the main methods used for the deposition of LDH films on different substrates, the conductive properties of these materials, the possibility to use them in the development of membranes for potentiometric anion analysis, the early analytical applications of chemically modified electrodes based on the ability of LDHs to preconcentrate redox-active anions and finally the most recent applications exploiting their electrocatalytic properties. Another promising application field of LDHs, when they are employed as host structures for enzymes, is biosensing, which is described considering glucose as an example.

Comparison of the performance of three ion mobility spectrometers for measurement of biogenic amines

The performance of three different types of ion mobility spectrometer (IMS) devices: GDA2 with a radioactive ion source (Airsense, Germany), UV-IMS with a photo-ionization source (G.A.S. Germany) and VG-Test with a corona discharge source (3QBD, Israel) was studied. The gas-phase ion chemistry in the IMS devices affected the species formed and their measured reduced mobility values. The sensitivity and limit of detection for trimethylamine (TMA), putrescine and cadaverine were compared by continuous monitoring of a stream of air with a given concentration of the analyte and by measurement of headspace vapors of TMA in a sealed vial. Preprocessing of the mobility spectra and the effectiveness of multivariate curve resolution techniques (MCR-LASSO) improved the accuracy of the measurements by correcting baseline effects and adjusting for variations in drift time as well as enhancing the signal to noise ratio and deconvolution of the complex data matrix to their pure components. The limit of detection for measurement of the biogenic amines by the three IMS devices was between 0.1 and 1.2 ppm (for TMA with the VG-Test and GDA, respectively) and between 0.2 and 0.7 ppm for putrescine and cadaverine with all three devices. Considering the uncertainty in the LOD determination there is almost no statistically significant difference between the three devices although they differ in their operating temperature, ionization method, drift tube design and dopant chemistry. This finding may have general implications on the achievable performance of classic IMS devices.     

Synthesis and cytotoxicity evaluation of diastereoisomers and N-terminal analogues of tubulysin-U

Tubulysins are potent anti-mitotic natural compounds and a scalable and efficient synthetic route for generation of its analogues has been developed and extended to the synthesis of diastereoisomers and N-terminal analogues of tubulysin-U. Structure–activity-relationship studies on these synthetic analogues reaffirmed the significance of native stereochemistry of tubulysins for optimal biological activity and cytotoxicity. However, while modification of Tup stereochemistry has only minor effect on the tubulysins cytotoxicity, Tuv stereochemistry is critically important and modification of either Tuv stereocentre produced a dramatic drop in cytotoxicity.     

Efficient Access to Peptidyl‐RNA Conjugates for Picomolar Inhibition of Non‐ribosomal FemXWv Aminoacyl Transferase

Peptidyl–RNA conjugates have various applications in studying the ribosome and enzymes participating in tRNA‐dependent pathways such as Fem transferases in peptidoglycan synthesis. Herein a convergent synthesis of peptidyl–RNAs based on Huisgen–Sharpless cycloaddition for the final ligation step is developed. Azides and alkynes are introduced into tRNA and UDP‐MurNAc‐pentapeptide, respectively. Synthesis of 2′‐azido RNA helix starts from 2′‐azido‐2′‐deoxyadenosine that is coupled to deoxycytidine by phosphoramidite chemistry. The resulting dinucleotide is deprotected and ligated to a 22‐nt RNA helix mimicking the acceptor arm of Ala‐tRNA^Ala by T4 RNA ligase. For alkyne UDP‐MurNAc‐pentapeptide, meso‐cystine is enzymatically incorporated into the peptidoglycan precursor and reduced, and L ‐Cys is converted to dehydroalanine with O‐(mesitylenesulfonyl)hydroxylamine. Reaction of but‐3‐yne‐1‐thiol with dehydroalanine affords the alkyne‐containing UDP‐MurNAc‐pentapeptide. The Cu^I‐catalyzed azide alkyne cycloaddition reaction in the presence of tris[(1‐hydroxypropyl‐1H‐1,2,3‐triazol‐4‐yl)methyl]amine provided the peptidyl‐RNA conjugate, which was tested as an inhibitor of non‐ribosomal FemX_Wv aminoacyl transferase. The bi‐substrate analogue was found to inhibit FemX_Wv with an IC₅₀ of (89±9) pM , as both moieties of the peptidyl–RNA conjugate contribute to high‐affinity binding.     

Steric and Electronic Effects on the Configurational Stability of Residual Chiral Phosphorus‐Centered Three‐Bladed Propellers: Tris‐aryl Phosphane Oxides

A series of tris‐aryl phosphane oxides existing as residual enantiomers or diastereoisomers with substituents on the aryl rings differing in size and electronic properties were synthesized and characterized. Their electronic properties were evaluated on the basis of their electrochemical oxidation and reduction potentials together with those of the corresponding “blade bromides” (i.e., the naphthalene derivatives displaying the same substitution pattern of the tris‐naphthyl phosphane oxide blades, with a bromo substituent where the phosphorus atom is located) determined by CV. The residual stereoisomeric phosphane oxides were isolated in a stereochemically pure state and were found to be highly configurationally stable at room temperature (stereoisomerization barriers of about 27 kcal mol^?1). The chiroptical properties of the residual stereoisomers and the assignments of absolute configuration are discussed. The configurational stability of residual tris‐aryl phosphane oxides was found to be scarcely influenced by the electronic properties of the substituents present on the aromatic rings constituting the blades, while steric effects play the most relevant role. Detailed theoretical calculations are in agreement with the experimental results and also contribute to a rational interpretation of the stereodynamics of these systems.     

A Hybrid Ring‐Opening Metathesis Polymerization Catalyst Based on an Engineered Variant of the β‐Barrel Protein FhuA

A β‐barrel protein hybrid catalyst was prepared by covalently anchoring a Grubbs–Hoveyda type olefin metathesis catalyst at a single accessible cysteine amino acid in the barrel interior of a variant of β‐barrel transmembrane protein ferric hydroxamate uptake protein component A (FhuA). Activity of this hybrid catalyst type was demonstrated by ring‐opening metathesis polymerization of a 7‐oxanorbornene derivative in aqueous solution.     

Pyrrolic Tripodal Receptors for the Molecular Recognition of Carbohydrates: Ditopic Receptors for Dimannosides

Synthetic ditopic receptors, designed for the molecular recognition of dimannosides, have been prepared by bridging two monotopic units effectively recognizing mannosides with linkers of the appropriate size and flexibility, endowed with hydrogen‐bonding groups. Affinities toward the α and β glycosides of the biologically relevant Manα(1–2)Man disaccharide were measured by NMR spectroscopy and isothermal titration calorimetry (ITC) in polar organic media (30–40 % DMF in chloroform). Significant selectivities and affinities in the micromolar range were observed in most cases, with two newly designed receptors being the most effective receptors of the set, together with a distinct preference of the dimannosides for the (S) enantiomer of the receptor in all cases. A 3D view of the recognition mode was elucidated by a combined NMR spectroscopic/molecular modeling approach, showing the dimannoside included in the cleft of the receptor. Compared to the monotopic precursors, the ditopic receptors showed markedly improved recognition properties, proving the efficacy of the modular receptor design for the recognition of disaccharides.