Study of vibrational energy localization and redistribution in hydrogen peroxide H2O2 at low energy

Vibrational energy localization and/or redistribution in hydrogen peroxide H2O2 is studied at about 4000 cm(-1) above the quantum mechanical ground state using the ab initio potential energy surface of Koput, Carter, and Handy [J. Phys. Chem. A 102, 6325 (1998)]. In this work, the recently derived canonical perturbation procedure for floppy molecules serves two purposes. First, from the quantum mechanical point of view, it is shown that the energies of the lowest 130 states are reproduced with an average error smaller than 1.5 cm(-1) by a two-dimensional Hamiltonian, which is a function of the torsion and OO-stretch coordinates and momenta, while the other four degrees of freedom contribute only through powers of good quantum numbers. Moreover, the canonical perturbation procedure is also used in classical mechanics calculations, in order to define meaningful local modes, for which the ingoing and outgoing energy flows are monitored. Almost all the individual trajectories launched on the ab initio surface display the same behavior, that is, the superposition of (a) rapid (few hundreds of femtoseconds) and quasiperiodic energy exchanges between the two OH stretches and between the torsion and OO-stretch, and (b) slower (few to several picoseconds) but erratic-looking energy flows between all degrees of freedom. When averaging over large numbers of trajectories with the same local mode energies at time t=0, one observes instead a smooth and irreversible energy flow between all degrees of freedom, which usually thermalize in the range of several tens of picoseconds, that is, on time scales larger than the 5 ps period associated with the quantum density of states.     

Development of a capillary electrophoretic method for the separation of diastereoisomers of a new human immunodeficiency virus protease inhibitor

A capillary electrophoretic (CE) method was developed for the separation of diastereoisomers of a new human immunodeficiency virus (HIV) protease inhibitor TMC114. In total 16 isomers of this drug have been synthesized (eight pairs of enantiomers). We succeeded in the separation of the eight diastereoisomers, but no enantiomers could be separated. Because of the high similarity and water-insolubility of these isomers, the separation is a real challenge. Different CE modes were tried out: capillary zone electrophoresis (CZE), nonaqueous capillary electrophoresis (NACE), micellar electrokinetic capillary chromatography (MEKC), and microemulsion electrokinetic capillary chromatography (MEEKC). Only MEEKC offered resolution of these compounds.     

Physico-chemical characterization of nanofiltration membranes.

This study presents a methodology for an in-depth characterization of six representative commercial nanofiltration membranes. Laboratory-made polyethersulfone membranes are included for reference. Besides the physical characterization [molecular weight cut-off (MWCO), surface charge, roughness and hydrophobicity], the membranes are also studied for their chemical composition [attenuated total reflectance Fourier spectroscopy (ATR-FTIR) and X-ray photoelectron spectroscopy (XPS)] and porosity [positron annihilation spectroscopy (PAS)]. The chemical characterization indicates that all membranes are composed of at least two different layers. The presence of an additional third layer is proved and studied for membranes with a polyamide top layer. PAS experiments, in combination with FIB (focused ion beam) images, show that these membranes also have a thinner and a less porous skin layer (upper part of the top layer). In the skin layer, two different pore sizes are observed for all commercial membranes: a pore size of 1.25-1.55 angstroms as well as a pore size of 3.20-3.95 angstroms (both depending on the membrane type). Thus, the pore size distribution in nanofiltration membranes is bimodal, in contrast to the generally accepted log-normal distribution. Although the pore sizes are rather similar for all commercial membranes, their pore volume fraction and hence their porosity differ significantly.     

Investigation of the formation process of MCs+-molecular ions during sputtering

In secondary ion mass spectrometry, the detection of MCs+ clusters (with M an element of the specimen) under a Cs bombardment is frequently used for the quantification of major elements. Despite some very good results obtained by this method, some problems still remain. In order to gain some more insight into these problems, the formation mechanism of the MCs+ clusters is investigated using a Monte Carlo model. It is shown that the majority of the constituent particles of the formed clusters are initially first or second neighbor atoms at the surface and that the velocity distribution of the MCs+ clusters becomes broader and peaked at higher velocities with increasing surface binding energy of the M atom. In addition, it is demonstrated that the interaction potential between the M and Cs+ particle has no influence on the velocity distribution of the MCs+ clusters. On the other hand, the cluster formation probability, defined as the probability that a sputtered M and Cs+ particle will form a MCs+ cluster, is extremely sensitive to this interaction potential. It is also shown that the cluster formation probability decreases with increasing surface binding energy. Finally, a good correspondence is obtained between the calculated and experimental velocity distributions of MCs+ clusters sputtered from different monoatomic materials. As a consequence, the Monte Carlo model and the discussed results can be validated.     

Crystallization and second harmonic generation in thermally poled niobium borophosphate glasses

Crystallization of glasses with compositions (1−x)(0.95 NaPO₃+0.05 Na₂B₄O₇)+xNb₂O₅, x=0.4, 0.43, 0.45, 0.48 was investigated by differential scanning calorimetry and X-ray powder diffraction. Crystallization of two phases was observed in the glasses with x=0.43-0.48. First phase is a sodium niobate with the structure of tetragonal tungsten bronze () and second phase is Na₄Nb₈P₄O₃₂ (). The crystallization of sodium niobate is correlated with increasing of nonlinear optical efficiency reported for thermally poled glasses with x>0.4. The results of Raman spectroscopy show the formation of three-dimensional (3D) niobium oxide framework in the glasses with increase of niobium concentration. This framework is supposed to have tetragonal tungsten bronze structure and to be responsible for nonlinear optical properties of the glass. Second harmonic generation signals of as prepared and crystallized glass after thermal poling are compared. The nucleation and crystallization do not improve the NLO properties of the glasses under study.     

Metabonomics: the use of electrospray mass spectrometry coupled to reversed-phase liquid chromatography shows potential for the screening of rat urine in drug development

The application of liquid chromatography/mass spectrometry (LC/MS) followed by principal components analysis (PCA) has been successfully applied to the screening of rat urine following the administration of three candidate pharmaceuticals. With this methodology it was possible to differentiate the control samples from the dosed samples and to identify the components of the mass spectrum responsible for the separation. These data clearly show that LC/MS is a viable alternative, or complementary, technique to proton NMR for metabonomics applications in drug discovery and development.     

Amidinoethylation—a new reaction—IV : The amidinoethylation of alcohols: a facile synthesis of 3-alkoxy-N,N'-substituted-propanamidines

The amidinoethylation of alcohols takes place by the addition of sodium alkoxides 2 (R¹ = Me, Et) to the CC double bond of a variety of N,N'-substituted-propenamidines 1 (Method A). This illustrates the activation of the CC double bond by the conjugated amidine function and provides a new class of Michael acceptors for alcohols. However, this activation is poorer than with other nucleophiles or Michael acceptors. The amidinoethylation makes available 3-alkoxy-N,N'-substituted-amidines not easily accessible by other classical methods. However, it is demonstrated that the general N,N'-substituted-amidine synthesis via the nitrilium salts can also apply to nitrile compounds having an alkoxygroup present on the molecule (method B). Since the cyanoethylation of alcohols (4) is a very fast and facile reaction the method B is the preferred strategy for the synthesis of 3-alkoxy-N,N'-substituted-propanamidines 3.     

Oxidation reactions of an anionic gallium(I) N-heterocyclic carbene analogue with group 16 compounds

The reactivity of an anionic gallium(I) heterocycle, [K(tmeda)][:Ga([N(Ar)C(H)]2)], Ar = C6H3Pr(i)2-2,6, towards sources of elemental chalcogens and diorgano-dichalcogenides has been investigated and comparisons drawn with the reactivity of the valence isoelectronic N-heterocyclic carbene class of ligand. The reactions of the heterocycle with N2O or (Te)PEt3 yielded the dimeric, dianionic gallium(III) complexes, [K(L)]2[(mu-E)Ga([N(Ar)C(H)]2)]2, E = O, L = tmeda; E = Te, L = THF. Treatment of [K(tmeda)][:Ga([N(Ar)C(H)]2)] with the diphenyl dichalcogenides, PhEEPh, E = Se or Te, gave the one dimensional polymer, [K[(PhSe)2Ga([N(Ar)C(H)]2)]]infinity and the monomeric complex, [K(OEt2)3][(PhTe)2Ga([N(Ar)C(H)]2)], respectively. The X-ray crystal structures of the four complexes are reported.     

Determination of manganese in brain samples by slurry sampling graphite furnace atomic absorption spectrometry

A simple procedure for the determination of manganese in different sections of human brain samples by graphite furnace atomic absorption spectrometry has been developed. Brain sections included cerebellum, hypothalamus, frontal cortex, vermix and encephalic trunk. Two sample preparation procedures were evaluated, namely, slurry sampling and microwave-assisted acid digestion. Brain slurries (2% w/v) could be prepared in distilled, de-ionized water, with good stability for up to 30 min. Brain samples were also digested in a domestic microwave oven using 5 ml of concentrated HNO₃. A mixed palladium+magnesium nitrate chemical modifier was used for thermal stabilization of the analyte in the electrothermal atomizer up to pyrolysis temperatures of 1300 °C, irrespective of the matrix. Quantitation of manganese was conducted in both cases by means of aqueous standards calibration. The detection limits were 0.3 and 0.4 ng ml⁻¹ for the slurry and the digested samples, respectively. The accuracy of the procedure was checked by comparing the results obtained in the analysis of slurries and digested brain samples, and by analysis of the NIST Bovine Liver standard reference material (SRM 1577a). The ease of slurry preparation, together with the conventional set of analytical and instrumental conditions selected for the determination of manganese make such methodology suitable for routine clinical applications.     

Synthesis of a simplified bryostatin C-ring analogue that binds to the CRD2 of human PKC-alpha and construction of a novel BC-analogue by an unusual Julia olefination process

[structure: see text] The synthesis of two truncated bryostatin analogues 2 and 3 is described. High-field NMR measurements on the C-ring analogue 3 in C(2)H(3)CN containing 25% (2)H(2)O have shown that it binds to the CRD2 of human PKC-alpha at virtually the same position as phorbol-13-acetate (PA) and bryostatin 1 (1). NMR titration studies have also revealed that 3 binds to the CRD2 with a potency similar in magnitude to PA but much less potently than 1.