Formation and recovery of a cell sheet by a particle monolayer with the surface roughness

We studied the topographical effect of roughness displayed by a closely packed particle monolayer on formation of a cell monolayer (cell sheet). Particle monolayers were prepared by Langmuir-Blodgett deposition using particles, which were 527nm (SA053) and 1270nm (SA127) in diameter. Human umbilical vein endothelial cells (HUVECs) were seeded at a high density (2.0 x10(5)cells/cm(2)) onto particle monolayers. It was found that cells gradually became into contact with adjacent cells on the SA053 monolayer and the formed cell sheet could be readily detached from the particle monolayer by gentle pipetting. On the other hand, cells adhering onto the tissue culture polystyrene (TCPS) and the SA127 particle monolayer were difficult to peel off. At a low cell seeding density (5.0x10(4)cells/cm(2)), pre-coating with bovine plasma fibronectin (FN) allowed cell growth on an SA053 particle monolayer, and a confluent monolayer was able to be peeled as a cell sheet from the particle monolayer just by pipetting. By immunostaining of human fibronectin, we found that fibronectin was secreted and concentrated onto the substrate side of a cell sheet. The obtained cell sheet adhered and grew on the TCPS again within 20min.     

Catalytic enantioselective organozinc addition toward optically active tertiary alcohol synthesis

A highly enantioselective organozinc (R₂Zn) addition to a series of aldehydes and ketones was developed based on conjugate Lewis acid–Lewis base catalysis. Optically active secondary and tertiary alcohols were obtained in high yields with high enantioselectivities without Ti(IV) compounds. Bifunctional chiral 3,3′‐diphosphoryl‐BINOL ligands were designed and prepared through a phospho‐Fries rearrangement as a key step. On the other hand, bifunctional chiral phosphoramide ligands were designed and prepared from L ‐valine. Mechanistic studies were performed by X‐ray analyses of Zn(II) cluster and chiral ligands, a ³¹P NMR experiment on Zn(II) complexes, and stoichiometric reactions with some chiral or achiral Zn(II) complexes to propose a transition state assembly that includes monomeric active intermediates. © 2008 The Japan Chemical Journal Forum and Wiley Periodicals, Inc. Chem Rec 8: 143–155; 2008: Published online in Wiley InterScience ( www.interscience.wiley.com ) DOI 10.1002/tcr.20146     

Anion conductive block poly(arylene ether)s: synthesis, properties, and application in alkaline fuel cells

Anion conductive aromatic multiblock copolymers, poly(arylene ether)s containing quaternized ammonio-substituted fluorene groups, were synthesized via block copolycondensation of fluorene-containing (later hydrophilic) oligomers and linear hydrophobic oligomers, chloromethylation, quaternization, and ion-exchange reactions. The ammonio groups were selectively introduced onto the fluorene-containing units. The quaternized multiblock copolymers (QPEs) produced ductile, transparent membranes. A well-controlled multiblock structure was responsible for the developed hydrophobic/hydrophilic phase separation and interconnected ion transporting pathway, as confirmed by scanning transmission electron microscopic (STEM) observation. The ionomer membranes showed considerably higher hydroxide ion conductivities, up to 144 mS/cm at 80 °C, than those of existing anion conductive ionomer membranes. The durabilities of the QPE membranes were evaluated under severe, accelerated-aging conditions, and minor degradation was recognized by (1)H NMR spectra. The QPE membrane retained high conductivity in hot water at 80 °C for 5000 h. A noble metal-free direct hydrazine fuel cell was operated with the QPE membrane at 80 °C. The maximum power density, 297 mW/cm(2), was achieved at a current density of 826 mA/cm(2).     

A clinical trial for therapeutic drug monitoring using microchip-based fluorescence polarization immunoassay

Microchip analysis is a promising method for therapeutic drug monitoring. This led us to evaluate a microchip-based fluorescence polarization immunoassay (FPIA) system for point-of-care testing on patients being treated with theophylline. The sera were collected from 20 patients being treated with theophylline. Fluorescence polarization was measured on the microchip and theophylline concentrations in serum were obtained. Regression analysis of the correlations was done between the results given by the microchip-based FPIA and the conventional cloned enzyme donor immunoassay (CEDIA), and between the results given by the microchip-based FPIA and the conventional particle-enhanced turbidimetric inhibition immunoassay (PETINIA). We successfully carried out a quantitative analysis of theophylline in serum at values near its therapeutic range in 65 s. The results obtained by the microchip-based FPIA correlated well with CEDIA and PETINIA results; the correlation coefficients (R ²) were 0.986 and 0.989, respectively. The FPIA system is a simple and rapid method for point-of-care testing of drugs in serum, and its accuracy is the same as the conventional CEDIA and PETINIA. It is essential to use real samples from patients and to confirm good correlations with conventional methods for a study on the realization of microchip.     

Adaptive lambda square dynamics simulation: An efficient conformational sampling method for biomolecules

A novel, efficient sampling method for biomolecules is proposed. The partial multicanonical molecular dynamics (McMD) was recently developed as a method that improved generalized ensemble (GE) methods to focus sampling only on a part of a system (GEPS); however, it was not tested well. We found that partial McMD did not work well for polylysine decapeptide and gave significantly worse sampling efficiency than a conventional GE. Herein, we elucidate the fundamental reason for this and propose a novel GEPS, adaptive lambda square dynamics (ALSD), which can resolve the problem faced when using partial McMD. We demonstrate that ALSD greatly increases the sampling efficiency over a conventional GE. We believe that ALSD is an effective method and is applicable to the conformational sampling of larger and more complicated biomolecule systems. © 2013 Wiley Periodicals, Inc.     

Generation of ynolates via reductive lithiation using flow microreactors

A new method has been developed for the generation and subsequent reaction of ynolates in a micro flow reactor system. This new procedure allowed for ynolates to be prepared at 0 °C or ambient temperature within 1 min via a reductive lithiation reaction, whereas the corresponding batch processes generally require low temperature control and extended reaction times of up to 1 h. The resulting ynolates were applied to the olefination of carbonyl compounds, with the reactions reaching completion in a much shorter reaction time in the continuous flow reactor than the batch reactor. These results highlight the practical utility of the ynolate reaction, and represent the first reported example of the use of lithium naphthalenide in a flow microreactor, which would contribute to progress of the flash chemistry.     

Synthesis of (-)-epibatidine and its derivatives from chiral allene-1,3-dicarboxylate esters

(-)-Epibatidine, an excellent candidate of non-opioidal anesthesia, was formally synthesized in short steps from di-(l)-menthyl (R)-allene-1,3-dicarboxylate that was facilely prepared as a single isomer by means of crystallization-induced asymmetric transformation from a diastereomer mixture of (R)- and (S)-allene-1,3-dicarboxylates. Taking advantage of the chiral synthesis, derivatives of (-)-epibatidine were also prepared for targeting diagnostic agents that could bind nicotinic acetylcholine receptors (nAChRs) in the mammalian central nerve system.     

Where is the Oxygen? Structural Analysis of α‐Humulene Oxidation Products by the Crystalline Sponge Method

Crystal structures of α‐humulene, a cyclic sesquiterpene, and its oxidized subproducts, were analyzed by the crystalline sponge method. Regio‐ and stereochemistry, including absolute configuration when a chiral oxidant was applied, and the stable conformations of all the scaffold‐related compounds were successfully determined for samples on a 5–50 μg scale.     

Design of Ratiometric Fluorescent Probes Based on Arene–Metal‐Ion Interactions and Their Application to CdII and Hydrogen Sulfide Imaging in Living Cells

Non‐coordinative interactions between a metal ion and the aromatic ring of a fluorophore can act as a versatile sensing mechanism for the detection of metal ions with a large emission change of fluorophores. We report the design of fluorescent probes based on arene–metal‐ion interactions and their biological applications. This study found that various probes having different fluorophores and metal binding units displayed significant emission redshift upon complexation with metal ions, such as Ag^I, Cd^II, Hg^II, and Pb^II. X‐ray crystallography of the complexes confirmed that the metal ions were held in close proximity to the fluorophore to form an arene–metal‐ion interaction. Electronic structure calculations based on TDDFT offered a theoretical basis for the sensing mechanism, thus showing that metal ions electrostatically modulate the energy levels of the molecular orbitals of the fluorophore. A fluorescent probe was successfully applied to the ratiometric detection of the uptake of Cd^II ions and hydrogen sulfide (H₂S) in living cells. These results highlight the utility of interactions between arene groups and metal ions in biological analyses.