High-speed deposition of RE123 film with large current capacity by hot-wall type PLD system

We have studied a hot-wall heating system to produce GdBa₂Cu₃O_y (GdBCO) films with large critical currents (I_c) at a high production rate by a pulsed-laser-deposition (PLD) method. GdBCO films fabricated at a production rate of 30 m/h under the optimized conditions, especially a distance of 95 mm between the target and the substrate (T–S), exhibited high critical current densities (J_c) of about 3 MA/cm² and I_c over 300 A at a thickness of 1–2 μm. Furthermore, long GdBCO tapes prepared by repeated depositions at each tape-passing speed of 80 m/h showed uniform I_c distribution along the longitudinal direction, because the hot-wall system enabled to stabilize temperature within a few degrees at 800 °C. A 170 m long tape with I_c over 600 A was successfully fabricated at a production rate of 16 m/h using a laser power of 360 W.     

Jet ejection from droplets near the Leidenfrost temperature

Abstract  

Droplets impinging on a hot surface that is near the Leidenfrost temperature were experimentally investigated. Ejection of jets from the top of the droplet was observed during the transient interaction between the droplet and a hot wall. We term this phenomenon jet ejection from droplets. When the bottom of the droplet initially impacts the hot surface, a jet is to be ejected from the top of the droplet. The jet ejection occurred only at low impact velocities and around the wetting limit temperature. It was not observed when droplets were dropped from large heights or when the surface was at a high temperature.     

Polymerization of Acrylamide in Aqueous Solution of Poly(N‐isopropylacrylamide) at Lower Critical Solution Temperature

Acrylamide (AAm) was found to polymerize in a solution of poly(N‐isopropylacrylamide) (PNIPAAm) in water at around its lower critical solution temperature (LCST) (32°C) without any initiators. This phenomenon was specifically observed in aqueous solutions of the polymers having LCST such as PNIPAAm and poly(methylvinylether) (PMVE). AAm polymerized only when PNIPAAm and AAm were dissolved in water below LCST of PNIPAAm and then the solution was warmed up to the polymerization temperature (40°C). On the other hand, the polymerization of AAm did not proceed when AAm was added into aqueous PNIPAAm solution during and after the phase separation above 32°C. Furthermore the polymerizability of AAm was remarkably affected by the concentration and molecular weight of the PNIPAAm additives. Under the condition of lower PNIPAAm concentration (0.30 mol/L), the increase in the molecular weight of PNIPAAm considerably increased the molecular weight of the resulting PAAm but decreased the yield of PAAm. Under the condition of higher PNIPAAm concentration (0.60 mol/L) the polymerizability was not so affected by the molecular weight of PNIPAAm, while the molecular weight of PAAm formed by using higher molecular weight PNIPAAm was higher than those of PAAm formed by using lower molecular weight PNIPAAm. Moreover, the molecular weight of PAAm formed by the PNIPAAm induced polymerization of AAm was much higher than that of the polymer obtained by the radical polymerization using AIBN in THF or VA‐ 061 in water.     

QSAR and mode of action studies of insecticidal ecdysone agonists†

A series of our SAR and QSAR studies of synthetic moulting hormone agonists, dibenzoylhydrazines (DBH), exhibiting insecticidal/larvicidal activity are reviewed in this article. We prepared a number of analogues where various substituents are introduced into the two benzene rings of DBH and measured their biological activity using various biological systems. Larvicidal activity was against larvae of the rice stem borer Chilo suppressalis and the moulting hormone activity was in terms of the stimulation of N-acetylglucosamine incorporation in a cultured integument system of the same insect species. Binding affinity to the ecdysone receptor was assayed with intact Sf-9 cell lines in which the ADME processes are negligible as well as using receptor proteins obtained by in vitro translation of the responsible cDNA cloned from cell-free preparation of integumentary tissue of C. suppressalis. Variations in the biological activity indices were either correlated between two types of activity or correlated using physicochemical molecular and substituent parameters in terms of the classical QSAR. Comparisons among correlations and with recently revealed X-ray crystallographic findings clearly indicate the physicochemical meaning of parameters significant in the correlation equations to help understanding molecular mechanism of the moulting hormonal action.     

Fully automated reagent peak‐free liquid chromatography fluorescence analysis of highly polar carboxylic acids using a column‐switching system and fluorous scavenging derivatization

In this study, we combined a column‐switching system with a fluorous scavenging derivatization method to develop a fully automated reagent peak‐free LC fluorescence detection protocol for the analysis of highly polar carboxylic acids. In this method, highly polar carboxylic acids were derivatized with fluorescent 1‐pyrenemethylamine in the presence of 1‐ethyl‐3‐(3‐dimethylaminopropyl)carbodiimide and 1‐hydroxy‐1H‐benzotriazole. Residual excess of the unreacted reagent was tagged with 2‐(perfluorooctyl)ethyl isocyanate and then removed selectively using a fluorous column‐switching system placed in front of an analytical reversed‐phase column. The signal of the fluorous‐tagged unreacted reagent was completely absent in the resulting chromatograms; therefore, it did not interfere with the quantification of each acid especially those eluted before 20 min. The detection limits (S/N = 3) for the examined acids were in the range from 4.0 to 22 fmol per injection. We have applied this method to comparative analysis of highly polar carboxylic acids in urine samples obtained from diabetes mellitus type‐II model mice and their control.     

Facile Synthesis of Oxamides by Efficient Trapping of Carbamoyl Lithiums with Isocyanates

Unsymmetrical oxamides are conveniently synthesized in good yields by a new trapping reaction of unstable carbamoyl lithiums with isocyanates.     

Synthesis of Unsaturated Nitriles from Trisubstituted Olefins Via Ene-Type Chlorination

Unsaturated nitriles have been synthesized from trisubstituted olefins via ene-type chlorination and regioselective substitution with cyanide ion followed by double bond migration.     

Photocycloaddition reaction of methyl 2- and 3-chromonecarboxylates with various alkenes

The irradiation of methyl 2- and 3-chromonecarboxylate in the presence of various alkenes afforded cyclobutane type adducts, whose structures were established by X-ray structural analysis. Methyl 2-chromonecarboxylate showed higher photochemical reactivity than methyl 3-chromonecarboxylate, in which endo adducts were yielded as major products.     

Ni‐Catalyzed [4+3+2] Cycloaddition of Ethyl Cyclopropylideneacetate and Dienynes: Scope and Mechanistic Insights

A detailed study of the Ni‐catalyzed [4+3+2] cycloaddition reaction between ethyl cyclopropylideneacetate and dienynes has been conducted, resulting in the development of a new method for the synthesis of compounds containing nine‐membered rings. We studied the reactivity of various dienynes, together with their substituent and conformational effects. The mechanism of the reaction was probed by examining the stoichiometric reactions of the Ni complexes and dienynes.     

Enhanced Magneto‐optical Properties of Semiconductor EuS Nanocrystals Assisted by Surface Plasmon Resonance of Gold Nanoparticles

Remarkable magneto‐optical properties of a new isolator material, that is, europium sulfide nanocrystals with gold (EuS–Au nanosystem), has been demonstrated for a future photo‐information technology. Attachment of gold particles that exhibit surface plasmon resonance leads to amplification of the magneto‐optical properties of the EuS nanocrystals. To construct the EuS–Au nanosystems, cubic EuS and spherical Au nanocrystals have been joined by a variety of organic linkers, that is, 1,2‐ethanedithiol (EDT), 1,6‐hexanedithiol (HDT), 1,10‐decanedithiol (DDT), 1,4‐bisethanethionaphthalene (NpEDT), or 1,4‐bisdecanethionaphthalene (NpDDT) . Formation of these systems was observed by XRD, TEM, and absorption spectra measurements. The magneto‐optical properties of the EuS–Au nanosystem have been characterized by using Faraday rotation spectroscopy. The Faraday rotation angle of the EuS–Au nanosystem is dependent on the Au particle size and interparticle distance between EuS and Au nanocrystals. Enhancement of the Faraday rotation of EuS–Au nanosystems was observed. The spin configuration in the excited state of the EuS–Au nanosystem was also investigated using photo‐assisted electron paramagnetic resonance.