Applications of intelligent methods in various types of heat exchangers: a review

Journal of Thermal Analysis and Calorimetry - Heat exchangers are applicable in different industries and technologies, and their performance is influenced by different parameters. In addition to...     

Ultralow-noise mode-locked laser with coupled optoelectronic oscillator configuration

We describe simultaneous generation of ultralow-noise optical pulses and microwave signal with a mode-locked fiber laser in a coupled optoelectronic oscillator configuration. We demonstrate 9.2-GHz optical and microwave signals with the measured phase noise of -140 dBc/Hz at 10-kHz offset frequency. We show that the mode-locked laser in the photonic oscillator serves as a high-Q filter and is responsible for the observed low phase noise.     

Vertically coupled whispering-gallery-mode resonator waveguide

We theoretically describe a novel configuration of a vertically coupled whispering-gallery-mode resonator waveguide. The waveguide is formed as a chain of doughnut-shaped low-contrast ripples on the surface of a vertical cylinder made from an optically transparent material. One can manipulate the properties of the waveguide by changing the shape of the resonators and the separation distance between them. Application of the structure as an optical delay line is discussed.     

Ultraviolet-assisted frequency trimming of optical microsphere resonators

We have demonstrated the engineering of a precise shift in the resonance frequency of high-Q (10(8))whispering-gallery modes in microspheres of germanium-doped silica with UV irradiation. With 600 mW of 351-nm radiation from an Ar-ion laser, 18-GHz permanent frequency shifts were obtained for modes of 1550-nm wavelength, enough to tune a resonance over a full free spectral range.     

Selective kinetic spectrophotometric determination of copper at nanograms per milliliter level

A sensitive and selective kinetic method is proposed for the determination of nanogram amounts of copper. The method is based on the catalytic effect of copper on the reduction of Ponceau S by sodium sulfide in an alkaline media. The rate of the reaction is monitored spectrophotometrically at 560 nm. The method allows determination of copper concentrations in the range 2-400 ng ml(-1) with a relative standard deviation of approximately 2%. The proposed method, which is highly selective to copper, has been applied satisfactory to its determination in real samples.     

Microtorus: a high-finesse microcavity with whispering-gallery modes

We demonstrate a 165-mu;m oblate spheroidal microcavity with a free spectral range of 383.7 GHz (3.06 nm), a resonance bandwidth of 23 MHz (quality factor Q approximately 10(7)) at 1550 nm, and finesse F>/=10(4) . The highly oblate spheroidal dielectric microcavity combines a very high Q factor, typical of microspheres, with a vastly reduced number of excited whispering-gallery modes (by 2 orders of magnitude). The very large free spectral range in this novel microcavity-a few hundred gigahertz instead of a few gigahertz as in typical microspheres-is desirable for applications in spectral analysis, narrow-linewidth optical and rf oscillators, and cavity QED.     

An efficient synthesis of 2,2′-arylmethylene bis-(3-hydroxy-5,5-dimethyl-2-cyclohexene-1-one) and 1,8-dioxooctahydroxanthenes using ZnO and ZnO-acetyl chloride

<正>2,2'-Arylmethylene bis(3-hydroxy-5,5-dimethyl-2-cyclohexene-1-one) 4l-s produced from reaction between dimedone with various aldehydes in acetonitrile using ZnO as a catalyst;whereas in the presence of ZnO-acetyl chloride catalysts the reaction is limited to give only 1,8-dioxo-octahydroxanthenes 3a-k in very good yields.     

SE‐30 Graphite Composite Electrode: An Alternative for the Development of Electrochemical Biosensors

A new graphite composite electrode was constructed by mixing graphite powder with chromatography stationary phase, SE‐30, as the binder. The electrochemical behavior of the new electrode has been evaluated and compared with that of traditional carbon paste electrode (CPE). The proposed electrode provides a remarkable increase in the rate of electron transfer of biomolecules such as nicotinamide adenine dinucleotide (NADH), cysteine, ascorbic acid and catechol and shows a low surface fouling effects. The electrode shows highly promising results when used as an amperometic sensor for biocompounds such as NADH.