Transport of gases in aromatic polyesters: Correlation with WAXD studies

Polymer packing density can be conveniently measured by either density-based measurements (direct or estimated free volume) or wide-angle X-ray diffraction (WAXD) spectra. Previously reported diffusivity and permeability values for various polyarylates and polyimides are examined on the basis of the packing density measured by these different techniques. It is shown that in these rigid glassy polymers, the mean intersegmental distance, the d-spacing, obtained from WAXD provides a better measure of the effect of polymer packing on diffusivity than either direct density measurements or estimated free volumes. It has been possible to correlate previously reported diffusivity and sorption data for various polyarylates and polycarbonate on the basis of the WAXD investigation, using the d-spacing and the amorphous peak width, respectively. The effect of polyarylate structure on d-spacing has been studied. A series of polyarylates have been synthesized with different substituents on the bridge carbon. In this series the d-spacing remains constant while the carbonyl group density and the glass transition temperatures are varied. However, small substituents on the aromatic ring cause significant changes in the d-spacing. These results can be used to tailor polyarylates with desired intersegmental distances and chain flexibility.     

Study of the reciprocal space image of the biaxial nematic phase in the plane of the amphiphilic bilayer

High resolution synchrotron X-ray measurements have been performed on the uniaxial and biaxial phases of the lyotropic mixture potassuim laurate, decanol and water. An elegant magnetic orientational procedure allows us to obtain the cut of the reciprocal space image of the biaxial phase at the plane perpendicular to the amphiphilic bilayer. The analysis of densitometric profiles of the diffracted bands indicate an anisotropic micellar correlation in the plane of the amphiphilic bilayer. It is suggested that an anisotropic distribution of decanol and potassium laurate in this plane could be responsible for this effect.     

The magnetic properties of Be-codoped GaMnN grown via molecular beam epitaxy

GaMnN and Be-codoped GaMnN were grown via molecular beam epitaxy using a single GaN precursor and their structural and magnetic properties were examined. X-ray diffraction and superconducting quantum interference device (SQUID) measurements revealed that the grown layers are homogeneous without precipitates. The saturation magnetization of GaMnN has increased from ∼4 to ∼16 emu/cm³ via codoping of Be. The d–d exchange interaction between Mn atoms was discussed for the ferromagnetism of GaMnN.     

Oil Migration in Chocolate

Oil migration in filled chocolates limits shelf life due to texture changes and loss of visual appeal. Spatial and temporal oil concentration changes of a two-layer chocolate and peanut butter filling system, which models a filled chocolate, were monitored by magnetic resonance imaging. Formulations of chocolate varied with respect to particle size, milk fat content and emulsifier level. Sorption-time experimental data was used to establish the best fit diffusion coefficient for a Fickian diffusion model. On the basis of the comparison of spatial experimental data to the model, Fickian diffusion alone does not account for oil migration. Authors' address: Michael J. McCarthy, Department of Food Science and Technology, University of California, One Shields Avenue, Davis, CA 95616, USA     

High performance a-Si solar cells and new fabrication methods for a-Si solar cells

The super chamber, a separated UHV reaction-chamber system has been developed. A conversion efficiency of 11.7% was obtained for an a-Si solar cell using a high-quality i-layer deposited by the super chamber, and a p-layer fabricated by a photo-CVD method.As a new material, amorphous superlattice-structure films were fabricated by the photo-CVD method for the first time. Superlattice structure p-layer a-Si solar cells were fabricated, and a conversion efficiency of 10.5% was obtained.For the fabrication of integrated type a-Si solar cell modules, a laser pattering method was investigated. A thermal analysis of the multilayer structure was done. It was confirmed that selective scribing for a-Si, TCO and metal film is possible by controlling the laser power density. Recently developed a-Si solar power generation systems and a-Si solar cell roofing tiles are also described.     

Effect of γ-ray irradiation on the magnetic properties of NdFeB and Fe–Cr–Co permanent magnets

The effect of γ-ray irradiation on the magnetic properties of NdFeB and Fe–Cr–Co permanent magnets has been investigated. The magnetic flux loss of two kinds of magnets before and after irradiation was measured. Results show that the effect of γ-ray irradiation on the magnetic properties of sintered NdFeB is not so obvious as that on Fe–Cr–Co magnet. Irradiation-induced damage from γ-ray for the Fe–Cr–Co magnets was characterized for the first time. The decline of permanent magnetic properties of Fe–Cr–Co magnet induced by γ-ray irradiation is reversible except for the maximum energy product (BH)_max. The difference of coercivity mechanism between these two kinds of permanent magnets is responsible for the different dependence of magnetic properties loss induced by γ-ray irradiation.     

Characteristics of soft magnetic composite material under rotating magnetic fluxes

This paper reports the measurement of magnetic properties of the soft magnetic composite material SOMALOY^TM 500 in a square sample under different patterns of flux density with 2D magnetic excitations. The test system, principle of measurement, magnetic power loss calculation, and methods of correction for misalignment of H surface sensing coils are presented. The experimental results show that although nominally isotropic, the SOMALOY^TM 500 sample exhibits some anisotropy. The results are useful in the design and performance analysis of rotating electrical machines.     

Exciton reflectivity of GaAs/Ga1−x Al x As multiple quantum wells

Summary The normal incidence reflectivity spectrum of excitons in GaAs/Ga_1−x Al _x As multiple quantum wells is calculated within the local response approximation. It is shown that the reflectivity lineshape strongly depends on the sample geometry. Using realistic parameters of a multiple quantum well structure, we obtain an excellent fit of the experimental reflectivity curve, thus giving exciton energies, oscillator strengths and exciton broadening parameters.

---

Riassunto Lo spettro di riflettività ad incidenza normale degli eccitoni nei pozzi quantistici multipli di GaAs/Ga_1−x Al _x As è calcolato nell’ambito dell’approssimazione locale. Si mostra con la forma della linea di riflettività dipende in gran misura dalla forma geometrica del campione. Usando parametri realistici di una struttura a pozzi quantistici multipli, si ottiene un’ottima approssimazione della curva di riflettività sperimentale, che fornisce così energie eccitoniche, forze dell’oscillatore e parameri di ampliamento eccitonico.

---

Резюме В рамках приближения линейного отклика вычисляется спекрт отражательной способности экситонов при нормальном падении для множественных квантовых ям в GaAs/Ga_1−x Al _x As. Показывается, что форма линии отражательной способности сильно зависит от геометрии образца. Используя реалистические параметры структуры множественных квантовых ям, мы получаем хорошее соответствие с экспериментальной кривой для отражательной способности. Получаются энергии экситонов, силы осцилляторов и парам⪟тры экситонного уширения.

     

Kinetic model for hydrocarbon-assisted particulate boron combustion

A kinetic model is presented to describe the high temperature (1800 K < T < 3000 K) surface oxidation of particulate boron in a hydrocarbon combustion environment. The model includes a homogeneous gas-phase B/O/H/C oxidation mechanism consisting of 19 chemical species and 58 forward and reverse elementary reactions, multi-component gas-phase diffusion, and a heterogeneous surface oxidation mechanism consisting of ‘elementary’ adsorption and desorption reaction steps. Thermochemical and kinetic parameters for the surface reactions are estimated from available experimental data and/or elementary transition state arguments. The kinetic processes are treated using a generalized kinetics code, with embedded sensitivity analysis, for the combustion of a one-dimensional (particle radius), spherical particle. Model results are presented for the oxidation of a 200 μm boron particle in a JP-4/air mixture at ambient temperatures of 1400 K and 2000 K. These results include temperature and gas-phase species profiles as a function of radial distance and particle burning rates. © 1994 John Wiley & Sons, Inc.     

An efficient lasing action from pyrromethene 556 dye-doped organically modified silicates

Organically modified solid-state silicates (ORMOSILS) doped with a new laser dye 1,3,5,7,8-pentamethylpyrromethene-2,6-disulfonate-BF₂ complex (pyrromethene 556) have been synthesized by a sol-gel method and the compositional effects on pore characteristics, fluorescence and lasing properties have been investigated. It is found that the use of dimethylsulfoxide and γ-glycidoxypropyltrimethoxysilane could greatly change the structure properties of sol-gel derived ORMOSILS cage, and thus the fluorescence and lasing properties of the materials could improve significantly. A successful laser oscillation from this dye-doped ORMOSILS sample has been achieved upon pumping with a Q-switched frequency-doubled Nd:YAG laser at 532 nm. A slope efficiency of 54% with a useful lifetime greater than 10,000 shots has been demonstrated at a pump repetition rate of 1 Hz and a pump intensity of 1 J/cm² by using the new ORMOSILS cage on our newly designed laser system. Our results have shown that it is possible to obtain a high-efficiency with a long-lifetime for a compact new laser device by low cost dye-doped solid-state ORMOSILS.