GS-221高速摄影测量仪测角信息的采集与处理

在GS-221高速摄影测量仪中,测角信息采集与处理速度的快慢是重要性能指标之一。本文讨论了如何在尽可能短的时间内对测角信息进行采集和处理的软件实现方法。     

吹气孔直径对RH精炼过程钢液流动和混合特性的影响

针对90t RH精炼装置,以水力学模拟研究了吹气孔直径对真空循环精炼过程中钢液流动和混合特性的影响.模型和原型的相似比为15.模型吹气孔直径分别为0.8 mm和1.2 mm.结果表明,1.2 mm孔径下环流量和主要工艺参数间的关系为Ql Q80.26Du0.69Dd0.80;在给定的吹气量和插入管内径下,增大吹气孔直径并不显著改变精炼过程中钢液流动特征,环流量随吹气孔直径的增大而略有增大,其关系式为Ql=2.40Q 0.23gD0.72u D0.88d d0.13in;相应地,混合时间稍有缩短;0.8和1.2 mm孔径下,τm与搅拌能密度的关系分别为τm ε5和τm ε0.49.     

一种新型有机电致微腔结构的双模发射

采用结构Glass／DBR／ITO／NPB／NPB：Alq／Alq／Al制作了有机微腔电致发光器件。将空穴传输材料与发光材料以一定比例混合作为发光层，为了便于对比，在不改变有机层的膜厚的情况下同时制作了传统的异质结微腔器件，发现两种器件的发光光谱有很大不同，器件的复合效率与传统的异质结器件相比也得到了很大提高，这是因为将两种有机材料混合能消除界面势垒，提高器件的复合效率，从而提高了器件的发光性能，实现了微腔双模发射，且两个模式的半峰全宽分别为8nm和12nm。通过进一步优化器件结构可以实现微腔白光发射。     

Phenylene vinylene‐based electroluminescent polymers with electron transport block in the main chain

We report a new route for the design of soluble phenylene vinylene (PV) based electroluminescent polymers bearing electron‐deficient oxadizole (OXD) and triazole (TZ) moieties in the main chains with the aryloxy linkage. Both series of the PV‐based polymers were prepared by Wittig reaction. By properly adjusting the OXD and/or TZ content through copolymerization, we can achieve an enhanced balance of hole‐ and electron injections, such that the device efficiency is significantly improved. Light‐emitting diodes fabricated from P1, P2, P3, P4, P5, P6, and P7 with the configuration of Indium–Tin Oxide (ITO)/Poly (styrene sulfonic acid) doped poly (ethylenedioxythiophene) (PEDOT)/polymer/Ca/Al, emit bright green light with the maximum peak around 500 nm. For the device using the optimal polymer (P4) as emitting layer, a maximum brightness of 1300 cd/m² at 20 V and a maximum luminance efficiency of 0.325 cd/A can be obtained. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3469–3478, 2006     

Investigation of sulfonated poly(ether ether ketone sulfone)/heteropolyacid composite membranes for high temperature fuel cell applications

The sulfonated poly(ether ether ketone sulfone) (SPEEKS)/heteropolyacid (HPA) composite membranes with different HPA content in SPEEKS copolymers matrix with different degree of sulfonation (DS) were investigated for high temperature proton exchange membrane fuel cells. Composite membranes were characterized by Fourier transfer infrared spectroscopy (FTIR) and scanning electron microscopy (SEM). FTIR band shifts suggested that the sulfonic acid groups on the copolymer backbone strongly interact with HPA particles. SEM pictures showed that the HPA particles were uniformly distributed throughout the SPEEKS membranes matrix and particle sizes decreased with the increment of copolymers' DS. The holes were not found in SPEEKS‐4/HPA30 (consisting of 70% SPEEKS copolymers with DS = 0.8 and 30% HPA) composite membrane after composite membranes were treated with boiling water for 24 h. Thermal stabilities of the composite membranes were better than those of pure sulfonated copolymers membranes. Although the composite membranes possessed lower water uptake, it exhibited higher proton conductivity for SPEEKS‐4/HPA30 especially at high temperature (above 100 °C). Its proton conductivity linearly increased from 0.068 S/cm at 25 °C to 0.095 S/cm at 120 °C, which was higher than 0.06 S/cm of Nafion 117. In contrast, proton conductivity of pure SPEEKS‐4 membrane only increased from 0.062 S/cm at 25 °C to 0.078 S/cm at 80 °C. At 120 °C, proton conductivity decreased to poor 0.073 S/cm. The result indicated that composite membranes exhibited high proton conductivity at high temperature. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1967–1978, 2006     

Probing the use of small‐angle light scattering for characterizing structure of titanium dioxide/low‐density polyethylene nanocomposites

Small‐angle light scattering (SALS) measurements were used to study the structure of titanium dioxide (TiO₂)/low‐density polyethylene (LDPE) nanocomposites. The results showed that the scattering from LDPE crystalline structures and the scattering from TiO₂ nanoparticles can be resolved and separated. It is shown that the independent effects of crystallization conditions and the presence of nanoparticle aggregates on the spherulitic structure of the LDPE matrix can be determined by analyzing the scattering patterns using the methods proposed. From the SALS results, we conclude that the nanoparticle surface chemistry affects both nucleation of spherulites and their structure particularly under rapid cooling conditions. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1084–1095, 2006     

用好插图事半功倍--浅谈"机械波"的教学

物理插图能起到形象地再现物理情景，辅助解释物理原理的作用．现行人教版物理第二册（必修加选修），第十章“机械波”第一节的知识“波的形成和传播”是该章的重点，本节插图10-5“横波的形成”又是该节的教学重点．这幅插图用得好，直接为后面的波的图像教学及用图像解决问题打下坚实的基础．