Newtonian limits of warp drive spacetimes

We find a class of warp drive spacetimes possessing Newtonian limits, which we then determine. The same method is used to compute Newtonian limits of the Schwarzschild solution and spatially flat Friedmann-Robertson-Walker cosmological models. This work was partially supported by FCT/POCTI/FEDER.     

Phenylene vinylene‐based electroluminescent polymers with electron transport block in the main chain

We report a new route for the design of soluble phenylene vinylene (PV) based electroluminescent polymers bearing electron‐deficient oxadizole (OXD) and triazole (TZ) moieties in the main chains with the aryloxy linkage. Both series of the PV‐based polymers were prepared by Wittig reaction. By properly adjusting the OXD and/or TZ content through copolymerization, we can achieve an enhanced balance of hole‐ and electron injections, such that the device efficiency is significantly improved. Light‐emitting diodes fabricated from P1, P2, P3, P4, P5, P6, and P7 with the configuration of Indium–Tin Oxide (ITO)/Poly (styrene sulfonic acid) doped poly (ethylenedioxythiophene) (PEDOT)/polymer/Ca/Al, emit bright green light with the maximum peak around 500 nm. For the device using the optimal polymer (P4) as emitting layer, a maximum brightness of 1300 cd/m² at 20 V and a maximum luminance efficiency of 0.325 cd/A can be obtained. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3469–3478, 2006     

Probing the use of small‐angle light scattering for characterizing structure of titanium dioxide/low‐density polyethylene nanocomposites

Small‐angle light scattering (SALS) measurements were used to study the structure of titanium dioxide (TiO₂)/low‐density polyethylene (LDPE) nanocomposites. The results showed that the scattering from LDPE crystalline structures and the scattering from TiO₂ nanoparticles can be resolved and separated. It is shown that the independent effects of crystallization conditions and the presence of nanoparticle aggregates on the spherulitic structure of the LDPE matrix can be determined by analyzing the scattering patterns using the methods proposed. From the SALS results, we conclude that the nanoparticle surface chemistry affects both nucleation of spherulites and their structure particularly under rapid cooling conditions. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1084–1095, 2006     

Electrical properties of polypyrrole/p‐InP structure

The polypyrrole/p‐InP structure has been fabricated by the electrochemical polymerization of the organic polypyrrole onto the p‐InP substrate. The current–voltage (I–V), capacitance–voltage (C–V), and capacitance–frequency (C–f) characteristics of the PPy/p‐InP structure have been determined at room temperature. The structure showed nonideal I–V behavior with the ideality factor and the barrier height 1.48 and 0.69 eV respectively. C–f measurements of the structure have been carried out using the Schottky capacitance spectroscopy technique and it has been seen that there is a good agreement between the experimental and theoretical values. Also, it has been seen that capacitance almost show a plateau up to a certain value of frequency, after which, the capacitance decreases. The higher values of capacitance at low frequencies were attributed to the excess capacitance resulting from the interface states in equilibrium with the p‐InP that can follow the a.c. signal. The interface state density N_ss and relaxation time τ of the structure were determined from C–f characteristics. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1572–1579, 2006     

用好插图事半功倍--浅谈"机械波"的教学

物理插图能起到形象地再现物理情景，辅助解释物理原理的作用．现行人教版物理第二册（必修加选修），第十章“机械波”第一节的知识“波的形成和传播”是该章的重点，本节插图10-5“横波的形成”又是该节的教学重点．这幅插图用得好，直接为后面的波的图像教学及用图像解决问题打下坚实的基础．     

A note on the acyclicity of the Koszul complex of a module

We prove the vanishing of the Koszul homology group H _μ(Kos(M)_μ), where μ is the minimal number of generators of M. We give a counterexample that the Koszul complex of a module is not always acyclic and show its relationship with the homology of commutative rings.     

The practice for eight-year operation of the cobalt-60 irradiation facility at Beijing Radiation Application Research Center

The radiation facility was made by Sulzer Company in Switzerland. The designed capacity is 3.7 × 10¹⁶Bq( 1MCi) and 12.21 × 10¹⁵Bq(330kCi)of Cobalt -60 source was loaded at the first phase. Current cobalt -60 source-loading is 2.4 × 10¹⁶Bq(650kCi). The equipment assembling and installation regulating and testing were completed at the end of 1988. The facility was put into commissioning in 1989. It operates 7000–8000 hours per year. The facility has been utilized to carry out many research work and irradiate many kinds of items. Lots of economical benefits have been gained since then. Now it is becoming a radiation processing model base in China. This paper summarized the strong and weak points of the design of the facility through in eight years' practice and analysed the economical benefits.