基于5-芳基乙内酰脲类化合物的CoMFA和HQSAR研究

用CoMFA和HQSAR两种QSAR方法研究了50个乙内酰脲类分子的定量构效关系.本研究从构象搜索所得的低能结构出发构建化合物分子的构象, 建立CoMFA模型,并进行了全空间搜索. HQSAR本质上是一种二维的QSAR方法,与CoMFA方法相比,该方法在数据处理方面,比CoMFA方法快捷,并且可重复性好.两种方法均得到了较好分析结果, CoMFA的交叉验证相关系数q2 值为0.815, HQSAR的q2值为0.893.这些方程有力地说明了该类分子在(R,R)-N-3,5-dinitrobenzoyl-1,2-diamine型手性固定相上拆分过程中的影响因素,对今后类似拆分的实验研究提供了理论支持.     

Synthesis of SBA-15/carbon composite with an ink-bottle-like pore structure by a novel pulse CVD technique

A novel and easy post modification method, pulse chemical vapor deposition (pulse CVD), was developed to tailor the pore-opening of SBA-15 while largely keeping its surface area and pore volume. By using acetylene as carbon precursor and nitrogen as carrier gas, the pore-mouth of SBA-15 was effectively reduced from 8.1 nm to 5.1 nm within 5 min while maintaining the pore body at 8.1 nm. This ink-bottle-structured SBA-15/carbon composite only losses 12% BET specific surface area and 16% total pore volume, respectively. The SBA-15/carbon composite is highly hexagonally ordered and has similar particle morphology as the original SBA-15. The effect of three pore modification factors—the number of cycles of pulse CVD, the ratio of acetylene/nitrogen and the feeding time of carbon precursor, on the final pore structure of the SBA-15/carbon composite is also studied.     

酚醛型氰酸酯与双酚A型环氧共固化反应的FTIR研究

在恒温固化条件下,通过FTIR跟踪方法,研究了酚醛型氰酸酯与双酚A型环氧共固化反应的路径及其反应机理.共固化体系的反应过程包括在150℃及其以下温度,主要发生的是氰酸酯的三嗪环化固化反应,其中三嗪环化固化反应由于环氧的加入,反应速率被极大地提高了;同时,酚醛型氰酸酯中的氨基甲酸酯类杂质与环氧发生开环聚合反应,引起环氧官能团产生弱而持续的消耗.但在此阶段,酚醛型氰酸酯与环氧之间没有化学反应发生;在180℃及其以上温度,三嗪环和环氧发生反应,异构为异氰脲酸环结构,并进一步反应生成唑啉酮环结构,由于该反应的发生,促进了环氧官能团的消耗速度,在环氧官能团的转化率-时间图中,出现倒S曲线;在三嗪环的转化率图中,出现一个极大值后再降落的曲线.反应温度的提高有利于促进酚醛型氰酸酯与环氧之间的共固化反应,特别是当反应温度为220℃时,氰酸酯官能团和环氧官能团的消耗、三嗪环和唑啉酮环的生成均以较快的速率进行,—OCN生成三嗪环的转化率可以较容易地达到1,而唑啉酮环的转化率不超过0.5.     

Low dielectric thermoset. II. Synthesis and properties of novel 2,6‐dimethyl phenol–dipentene epoxy

A 2,6‐dimethyl phenol–dipentene adduct was synthesized from dipentene (DP) and 2,6‐dimethyl phenol, and then a 2,6‐dimethyl phenol–DP epoxy was synthesized from the reaction of the resultant 2,6‐dimethyl phenol–DP adduct and epichlorohydrin. The proposed structures were confirmed by Fourier transform infrared, elemental analysis, mass spectra, NMR spectra, and epoxy equivalent weight titration. The synthesized 2,6‐dimethyl phenol–DP adduct was cured with 4,4‐diamino diphenyl methane, phenol novolac, 4,4‐diamino diphenyl sulfone, and 4,4‐diamino diphenyl ether. The thermal properties of the cured epoxy resins were studied with differential scanning calorimetry, dynamic mechanical analysis, dielectric analysis, and thermogravimetric analysis. These data were compared with those for the bisphenol A epoxy system. The cured 2,6‐dimethyl phenol–DP epoxy exhibited a lower dielectric constant (ca. 3.1), a lower dissipation factor (ca. 0.065), a lower modulus, lower thermal stability (5% degradation temperature = 366–424 °C), and lower moisture absorption (1.21–2.18%) than the bisphenol A system but a higher glass‐transition temperature (ca. 173–222 °C) than that of bisphenol A system. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 4084–4097, 2002     

Rare earth(III) perfluorooctanesulfonates catalyzed Friedel-Crafts alkylation in fluorous biphase system

The catalyst of rare earth(III) perfluorooctanesulfonates (RE(OSO₂C₈F₁₇)₃, RE = Sc, Y, La-Lu) were prepared from either rare earth chlorides(III) or oxides and perfluorooctanesulfonic acid. The perflates thus obtained act as novel catalysts for Friedel-Crafts alkylation in fluorous biphasic system. Perfluorohexane (C₆F₁₄), perfluoromethylcyclohexane (C₇F₁₄), perfluorotoluene (C₇F₈), perfluorooctane (C₈F₁₈), perfluorooctyl bromide (C₈F₁₇Br) and perfluorodecalin (C₁₀F₁₈, cis- and trans-mixture) can be used as fluorous solvents for this reaction. By simple separation of the fluorous phase containing only catalyst, alkylation can be repeated many times.     

A New Amperometric Glucose Biosensor with Naphthol Green B as Mediator

Naphthol green B was used, for the first time, as a new mediator in an amperometric glucose biosensor. It is a good mediator, promoting electron transfer from glucose oxidase to graphite electrode. The biosensor shows high sensitivity to glucose at low potential with response time of 30 seconds. The linear range is from 1.5 to 18μmol/L glucose with detection limit of 0.5μmol/L glucose.     

Mesoscale organization of CuO nanoribbons: formation of "dandelions"

A two-tiered organizing scheme with multiple-length scales for construction of dandelion-like hollow CuO microspheres has been elucidated: (1) mesoscale formation of rhombic building units from smaller nanoribbons via oriented aggregation and (2) macroscopic organization of these units into the CuO microspheres. This self-assembly concept may also be applicable to other metal oxides by creating geometric constraints for constructional units.     

有害杂草的微量元素分析

紫茎泽兰和水葫芦均属有害杂草，大规模防治的有效方法还未找到，本文分析研究了采自昆明郊区的紫茎泽兰和滇池水域的水葫芦中微量元素的含量，为进一步开发利用这两种杂草提供科学依据。     

A Mild Isomerization Reaction for β,γ‐Unsaturated Ketone to α,β‐Unsaturated Ketone

A series of β,γ‐unsaturated ketones were isomerized to their corresponding α,β‐unsaturated ketones by the introduction of DABCO in iPrOH at room temperature. The endo‐cyclic double bond (β,γ‐position) on ketone was rearranged to exo‐cyclic double bond (α,β‐position) under the reaction conditions.     

Modifying electronic communication in dimolybdenum units by linkage isomers of bridged oxamidate dianions

Reactions of Mo(2)(O(2)CCH(3))(DAniF)(3), DAniF = N,N'-di-p-anisylformamidinate, with oxamidate dianions [ArNC(O)C(O)NAr](2-), Ar = C(6)H(5) and p-anisyl, give pairs of isomeric compounds where the [Mo(2)] units are bridged by the oxamidate anions. For the alpha isomers, the C-C unit of the dianion is nearly perpendicular to the Mo-Mo bonds, and these are essentially perpendicular to each other. For the beta isomers, the corresponding C-C unit and the Mo-Mo bonds are essentially parallel to each other. Each type of isomer is stable in solution. The electronic communication as measured by the DeltaE(1/2) for the oxidation of each of the Mo(2) units is significantly better for the beta isomers. This is supported also by the appearance of what is conventionally called an intervalence charge-transfer band in the near infrared region upon oxidation of the beta isomers but not the alpha isomers. Molecular mechanics and DFT calculations help explain the relative conformations in the alpha isomers and the relative energy differences between the alpha and beta isomers.