40,48Ca+90,96Zr融合反应的动力学模型研究

应用改进的量子分子动力学模型,在严格挑选初始核考虑弹靶结构效应的基础上,研究了近垒和垒上融合反应^40,48Ca+^90,96Zr. 研究表明: 4个反应的理论计算截面与实验值很好符合; 丰中子反应⁴⁰Ca+⁹⁶Zr的垒下融合截面比其他3个反应有明显增强的现象.为了理解丰中子反应⁴⁰Ca+⁹⁶Zr与⁴⁰Ca+⁹⁰Zr相比垒下融合截面增强,而Ca+⁹⁶Zr垒下融合截面没有明显增强的原因, 进一步分析了484个反应的融合位垒,中子转移与融合位垒的关系、中子转移与Q值的关系,结果表明: 正反应Q值会引起核子(特别是中子)转移的增强,从而导致动力学融合位垒的下降和垒下融合截面增强.     

Spurious Shell Closures in the Relativistic Mean Field Model

Following a previous systematic theoretical study of the ground-state properties of over 7000 nuclei from the proton drip line to the neutron drip line in the relativistic mean field model [Prog. Theor. Phys. 113 （2005） 785], which is in fair agreement with existing experimental data, we observe a few spurious shell closures, i.e. proton shell closures at Z = 58 and Z = 92. These spurious shell closures are found to persist in all the effective forces of the relativistic mean field model, e.g. TMA, NL3, PKDD and DD-ME2.     

甲醇与蓖麻油混合物运动粘度的实验研究

利用改型的乌别洛特毛细管粘度计,本文对243～353K温度范围内对质量配比为98.8:1.2的甲醇与蓖麻油混合物的运动粘度进行了实验研究,运动粘度测量结果的不确定度为1.06%,利用得到的实验数据拟合了甲醇 蓖麻油二元混合物的运动粘度方程.方程与实验数据最大偏差为3.31%,平均偏差为1.11%.     

具有HfN/HfO2栅结构的p型MOSFET中的负偏置-温度不稳定性研究

研究了HfN/HfO₂高K栅结构p型金属-氧化物-半导体(MOS)晶体管(MOSFET)中，负 偏置-温度应力引起的阈值电压不稳定性(NBTI)特征.HfN/HfO₂高K栅结构的等效 氧化层厚度(EOT)为1.3nm，内含原生缺陷密度较低.研究表明，由于所制备的HfN/HfO₂ 高K栅结构具有低的原生缺陷密度，因此在p-MOSFET器件中观察到的NBTI属HfN/HfO2高K栅结构的本征特征，而非工艺缺陷引起的；进一步研究表明，该HfN/HfO₂高K栅结构中观察到的NBTI与传统的SiO₂基栅介质p-MOSFET器件中观察 到的NBTI具有类似的特征，可以被所谓的反应-扩散(R-D)模型表征： HfN/HfO₂ 栅结构p-MOSFET器件的NBTI效应的起源可以归为衬底注入空穴诱导的界面反应机理，即在负 偏置和温度应力作用下，从Si衬底注入的空穴诱导了Si衬底界面Si-H键断裂这一化学反应的 发生，并由此产生了Si^＋陷阱在Si衬底界面的积累和H原子在介质层内部的扩散 ，这种Si^＋陷阱的界面积累和H原子的扩散导致了器件NBTI效应的发生. 关键词： 高K栅介质 负偏置-温度不稳定性(NBTI) 反应-扩散(R-D)模型     

热丝CVD生长金刚石薄膜喇曼散射研究

本文报道热丝化学气相沉积法（ＨＦＣＶＤ）生长金钢石薄膜的喇曼散射结果。选取多种峰型，对金钢石薄膜喇曼谱（１１０－１８００ｃｍ－１）采用最小二乘法进行非线性拟合，得到最佳拟合模型，其计算得到的拟合曲线怀实验谱图符合得较好。该模型揭示，石墨Ｄ峰（１３５５ｃｍ－１）是金刚石薄膜喇曼谱中不可缺少的一个组份，并且结合石墨Ｄ峰和金刚石喇曼的空间相关线型，可以解释金刚石喇曼区特殊峰形的物理机制，拟合参量的进一步     

Hamiltonian formulation of generalized quantum dynamics

The Hamiltonian formulation of the usual complex quantum mechanics in the theory of generalized quantum dynamics is discussed. After the total trace Lagrangian, total trace Hamiltonian and two kinds of Poisson brackets are introduced, both the equations of motion of some total trace functionals which are expressed by total trace Poisson brackets and the equations of motion of some operators which are expressed by the without-total-trace Poisson brackets are obtained. Then a set of basic equations of motion of the usual complex quantum mechanics are obtained, which are also expressed by the Poisson brackets and total trace Hamiltonian in the generalized quantum dynamics. The set of equations of motion are consistent with the corresponding Heisenberg equations. Project supported by Prof. T.D. Lee’s NNSC Grant, the National Natural Science Foundation of China, the Foundation of Ph. D. Directing Programme of Chinese University, and the Chinese Academy of Sciences.     

（±）—Salvinolone的全合成研究

以２－（３，４－环己基类二氧－５－异丙基）苯基乙醇（２）和３－异丙氧基－５，５－二甲基－１，３－环己烯酮（４）为原料，利用羰基α－位的烷基化反应和分子内的Ｆｒｉｅｄｅｌ－Ｃａｒｆｔｓ反应为关键步骤，经９步反应，合成了多氧芳香型三环二萜类天然产物Ｓａｌｖｉｎｏｌｏｎｅ。     

棒状钡铁氧体的反相微乳法制备

A rodlike barium ferrite precursor with an average size of 0.72～19.6 μm and aspect ratio of 2.6～8.3 has been successfully prepared in an inverse microemulsion consisting of isooctane, cetanyl trimethyl ammonium bromide (CTAB), n-C₄H₉OH and water with ammonia and ammonium oxalate as precipitants. On sintering at 780(C, the rodlike precursor particles could be transformed into rodlike particles of barium ferrite(BaFe₁₂O₁₉) with the average size and aspect ratio of 0.69～18.2 μm and 2.3～5.8, respectively. The effect of volume ratio of aqueous phase to oleic phase, the starting concentrations of metal ions and the starting concentration ratios of metal ions to precipitants were investigated.     

电镀烧结法制备Ti/SnO2-Sb2O4电极的研究

The Ti/SnO₂-Sb₂O₄ electrode has been prepared by the electroplate-sinter method. The effect of SbCl₃ adding amount and sintering temperature on its electrode lifetime and oxygen evolution potential were investigated by means of EDX, SEM and XRD analysis. The results indicated that the electrode appeared the best performance when the SbCl₃ adding amounts was 0.2g and the sintering temperature was 550℃. In optimized conditions Ti substrate was entirely covered by SnO₂-Sb₂O₄ and the combinations among them were tight. Due to the use of electroplate method, the electrical conductivity, the oxygen evolution potential and the electrode lifetime were increased, so the elec-tro-catalytic activity and the electrochemical stability of the prepared electrode were found to be superior.