氧化锶催化性质：Ⅱ.SrO,MgO上异丙醇的分解反应

ＳｒＯ，ＭｓＯ对异丙醇的分解反应有各自的作用形式，因而产物分布也有明显差别．ＭｇＯ上异丙醇分解，在较低温度时，主要产物为丙酮和丙烯；随温度升高，生成丙烯的量增加，而丙酮的量减少，直至消失，在ＳｒＯ上，异丙醇在较高温度时反应，产物几乎为丙酮，丙烯的生成量极少。认为：产物中丙烯来源于异丙醇在催化剂表面强酸中心上的脱水；丙酮在ＭｇＯ上来源于强碱中心和酸中心协同作用异丙醇的脱氢，而在ＳｒＯ上则是ＳｒＯ表面极强的碱中心作用异丙醇而脱氢制得。     

Two New Xanthone Glycosides from Polygala tenuifolia

Two new xanthone glycosides,polygalaxanthone IV and V were isolated from the roots of Polygala tenuifolia Willd. Their structures were established as 6-O-[α-L-rhamnopyranosyl-(1→2)-β-D-glucopyranosyl]-1-hydroxy-3,7-dimethoxyxanthone(polygalaxanthone IV), and 6-O-[α-L-rhamnopyranosyl-(1→2)-β-D-glucopyranosyl]-1,3-dihydroxyl-7-methoxyxanthone (polyga-laxanthone V),respectively, on the basis of chemical and spectral evidence.     

液化石油气水蒸气重整镍催化剂新型载体研究

以共沉淀法合成了硅铝系载体（AS和SA），并采用改性天然高铝石为原料合成了矿物质载体（MC-1和MC-2）,采用浸渍法合成了镍负载型催化剂。用常压固定床管式反应器，考察了液化石油气水蒸气重整反应活性，通过XRD、物理吸附等手段对催化剂进行了表征。结果表明，以MC-1、MC-2和SA、AS为载体的催化剂的水蒸气重整活性明显高于目前普遍使用的Ni/α-Al2O3催化剂。以SA为载体，负载5%镍的催化剂具有最好的水蒸气重整活性。在750 ℃，水碳比为2.0的条件下转化率达100％，C1选择性达94.46％。XRD分析结果表明1 300 ℃焙烧后的SA载体中存在α-Al2O3晶型和莫来石结构。硅、铝添加次序对水蒸气重整活性影响较大，硅-铝添加次序的催化剂样品的活性高于铝-硅添加次序的样品，C1选择性提高12.7％。     

Elucidating dominant factors of PO43-, Cd2+ and nitrobenzene removal by biochar: A comparative investigation based on distinguishable biochars

Four distinct biochars were employed to remove three typical pollutants, meanwhile, path analysis, a multi-statistical regression method, was performed to elucidate the dominant factors of biochar adsorption. This work can provide a new insight to prepare a targeted biochar as adsorbents.     

六元N-杂环配体TIAMPP的合成及其在不对称催化加氢中的应用

在三乙胺的作用下，利用（S）-3-羟甲基-1，2，3，4-四氢异喹啉（（S）-TicOL）和Ph2PCl缩合，得到六元N-杂环配体（S）-TIAMPP．研究了（S）-TIAMPP与Rh（I）形成的手性催化剂[Rh（（S）-TIAMPP）（COD）]BF。在脱氢氨基酸的衍生物中不对称催化加氢的对映选择性和适应性，以及该催化剂对N-苯甲酰基脱氢肉桂酸甲酯加氢过程中温度、压力、反应溶剂、底物与催化剂比例（S／C）对光学收率的影响．结果表明，在S／C=100，15℃，1．0MPa的甲醇溶液中，反应24h，[Rh（（S）-TIAMPP）（COD）]BF。对N-苯甲酰基脱氢肉桂酸甲酯加氢的光学收率可达到96％．     

A new method for inversion of hydroxyl group of carbocyclic nucleosides

The hydroxyl group of carbocyclic nucleosides was inversed when the compounds were treated with Me_3SiCl,KCN and a catalytic amount of NaI in DMF/CH_3CN.     

1,3-二羧甲基咪唑盐酸盐热分解过程研究

离子液体是继超临界流体之后的一类新的绿色溶剂,因其具有一系列独特的性质,作为溶剂和反应介质已广泛应用于有机合成、催化反应工程、电化学、分离分析等领域.随着研究和应用的逐渐深入,仅仅将离子液体作为溶剂和反应介质已不能满足要求,使离子液体带上某些官能团,从而赋予其特定的功能,是相关领域的一个研究热点.1,3-二取代咪唑盐是一类常用的离子液体,对其功能化具有重要意义.1,3-二羧甲基咪唑的制备简单,将它与不同的酸如盐酸、磷酸、硼酸等进行反应,可得到对称二羧甲基取代的咪唑盐.这类咪唑盐作为缩聚单体与二醇或二胺反应,可得到每个重复链节上都含有咪唑阳离子的新的功能性聚酯或聚酰胺;如果用其掺杂导电聚苯胺,因其挥发性低则有可能大大提高聚苯胺的导电寿命.     

固相膜萃取与GC/MS联用测定地下水中痕量半挥发性有机物的野外采样方法研究

C18固相萃取膜适宜处理大体积地下水样现场采样而且易于运输、贮存。利用C18固相膜萃取以及GC／MS联用的方法对地下水中痕量半挥发性有机污染物进行了萃取以及定性、定量分析。优化了固相膜萃取的地下水采样量和浓缩体积。有机氯农药和多环芳烃的平均回收率分别为85％～110．1％、90．3％～115．1％；方法检出限达到10^-9g／L；相对标准偏差均小于15％。本方法用于北京地区地下水中的有机污染物分析，并给出地下水样C18固相膜萃取的GC／MS测定结果。     

Solar Photocatalytic Degradation of 4‐Chlorophenol in Kaolinite Catalysts

This research applies semiconductor photocatalysts, which are formed by metal ion exchange on the surface of kaolinite catalyst with cations, to the study of photocatalytic degradation of 4‐chlorophenol. The analysis results of catalyst properties shows that, after sintering at 400 °C, kaolinite catalyst has a particle size of between 10–100 nm indicating the nano level of synthesized catalysts. Under the same condition, kaolinite‐Ag/Zn catalyst works better in degradation efficiency than single kaolinite‐Ag and kaolinite‐Zn catalysts. Kaolinite‐Zn catalyst declines in degradation efficacy after 150 minutes and performs poorer than the other three types of kaolinite catalysts. In the experiments of different amounts of catalysts, when the concentration exceeds 0.1 wt%, utilization of light energy and degradation efficiency will be reduced due to shielding effect. When at different pH values, the higher the pH value, the more OH‐will be released and that is beneficial for reaction with substances and the increase of reaction rate. Finally multivariate analysis proves that there is one determining factor that influences the photocatalytic degradation of 4‐chlorophenol in kaolinite catalysts, named as “the factor with intermediates competition degree,” the one affecting the 4‐CP degradation at different weight percentages that is referred to as the “shielding effect factor.”     

Effect of nucleating agent on the structure and properties of polypropylene/poly(ethylene-octene) blends

The effect of the sorbital nucleating agent on properties of the ethylene-octene copolymer (POE) toughened polypropylene (PP) was studied. The results show that the addition of POE increases notched Izod and Charpy impact strength significantly but impair the tensile strength and flexural modulus. As a nucleating agent (1,3,2,4-di(p-methylbenzylidene) sorbitol, DM) was added, the toughness and stiffness of toughed PP increased simultaneously at the same content of POE. This result shows that the toughness and stiffness of toughed PP are in balance. Polarized light microscopy analysis shows that with the addition of POE and nucleating agent, only a low level of PP spherulites were observed.