从常温常压到超临界乙醇的分子动力学模拟

采用分子动力学方法系统地研究了从常温常压到超临界状态乙醇的热力学性质、结构性质和动力学性质.模拟发现随着温度的升高,体系焓值增大,乙醇分子间的氢键作用减弱,自扩散系数增大;随着压强的增大,乙醇分子间的氢键作用增强,自扩散系数减小;乙醇自扩散系数在液相区随温度变化不明显,在气相区随压强增大很快减小,超临界区乙醇的自扩散系数比液相区大十几倍.温度和压强对乙醇自扩散系数的影响可通过密度来体现.与常温常压相比,超临界条件下的乙醇体系因密度涨落存在分子聚集现象,且在低密度区域更显著;乙醇分子间的氢键作用明显减弱,结     

Forward and inverse problem for cardiac magnetic field and electric potential using two boundary element methods

This paper discusses the forward and inverse problem for cardiac magnetic fields and electric potentials.A torso-heart model established by boundary element method(BEM) is used for studying the distributions of cardiac magnetic fields and electric potentials.Because node-to-node and triangle-to-triangle BEM can lead to discrepant field distributions,their properties and influences are compared.Then based on constructed torso-heart model and supposed current source functional model-current dipole array,the magnetic and electric imaging by optimal constrained linear inverse method are applied at the same time.Through figure and reconstructing parameter comparison,though the magnetic current dipole array imaging possesses better reconstructing effect,however node-to-node BEM and triangleto-triangle BEM make little difference to magnetic and electric imaging.     

Theoretical Study on a Cluster-Seven-Core Photonic Crystal Fiber with High Nonlinearity and High-Power Endurance

We present a novel cluster-seven-core photonic crystal fiber which possesses high nonlinearity and supports the high-power pumping. Its nonlinearity coefficient and effective mode area are calculated by the full vector multipole method. Compared with the single core PCF, the cluster-seven-core photonic crystal fiber can support high-power beam transmitting in the core, and simultaneously has high nonlinearity. This kind of photonic crystal fiber can be applied to the photoelectron-device field.     

Real-time surface profile measurement using a feedback type of sinusoidal phase modulating interferometer

In this paper, we propose a sinusoidal phase modulating (SPM) interferometer that is insensitive to external disturbances, and its measuring principle is analyzed theoretically. In the SPM interferometer, the interference signal is detected by a high-speed image sensor based on a low-speed CCD and a signal processing circuit is used to obtain the phase of each point on the surface. Therefore, the surface profile can be measured real-time. The experiments measuring the surface profile of a wedge-shaped optical flat show that the measurement time of the SPM interferometer is less than 10 ms, the repetitive measurement accuracy is 4.2 nm. The results show that the impacts of nonlinear distortion of the piezoelectric transducer (PZT) and part external disturbance are removed.     

Three-dimensional contrast-enhanced ultrasound of the liver: Experience of 92 cases

Three-dimensional contrast-enhanced ultrasound (3D-CEUS) is a combination of three-dimensional ultrasound (3DUS) and contrast-enhanced ultrasound (CEUS). To evaluate the feasibility of 3D-CEUS in liver imaging, investigate possible influencing factors to its image quality, and evaluate the influence of 3D-CEUS to clinical outcome, low acoustic power (mechanical index, 0.08-0.13) 3D-CEUS was carried out in 102 focal liver lesions in 92 patients by using the LOGIQ 9 ultrasound scanner and a volume transducer (frequency range, 2-5 MHz; focusing ability, 2-25 cm in depth; azimuth aperture 5.9 cm). The lesions were classified into two groups: group 1 (n = 51) for characterization and group 2 (n = 51) for local treatment response evaluation. The factors that influenced the image quality of 3D-CEUS were analyzed. The image quality and usefulness of 3D-CEUS between the two groups were compared by using the χ²-test. The results showed that the lesion diameter, location, and scanning route had no significant influence on the image quality in both groups, whereas interfering factors damaged the image quality in group 1. In group 1, during arterial phase, high image quality was more frequently found in hyperenhanced and hypo- or non-enhanced lesions compared with isoenhanced lesions. In group 2, interfering factor and local treatment response had no obvious influence on the image quality. The visualization rate of high image quality was 94.1% (48/51) in group 2 vs. 72.6% (37/51) in group 1 (P = 0.012). The investigators found that 3D-CEUS improved confidence but made no change in diagnosis in 19 (37.3%) of 51 lesions in group 1, whereas 41 (80.4%) of 51 lesions in group 2 (P = 0.000). 3D-CEUS tends to obtain better image quality and lead to higher diagnostic confidence in the lesions for local treatment response evaluation, and perhaps is more useful in this aspect in future clinical settings.     

Image contrast enhancement in field-emission scanning electron microscopy of single-walled carbon nanotubes

The image contrast enhancement in scanning electron microscopy of single-walled carbon nanotubes (SWNTs) on SiO₂ surfaces was experimentally investigated using a field-emission scanning electron microscope (FESEM) using a wide range of primary electron (PE) voltages. SWNT images of different contrasts were obtained at different PE voltages. Image contrast enhancement of SWNTs was investigated by charging SiO₂ surfaces at different PE voltages. The phenomena are ascribed to the surface potential difference and charge injection between SWNTs and SiO₂ substrates induced by the electron-beam irradiation.     

Stability of SIRS system with random perturbations

Epidemiological models with bilinear incidence rate λSI usually have an asymptotically stable trivial equilibrium corresponding to the disease-free state, or an asymptotically stable non-trivial equilibrium (i.e. interior equilibrium) corresponding to the endemic state. In this paper, we consider an epidemiological model, which is an SIRS model with or without distributed time delay influenced by random perturbations. We present the stability conditions of the disease-free equilibrium of the associated stochastic SIRS system.     

Theoretical and experimental investigations of nanosecond 177.3 nm deep-ultraviolet light by second harmonic generation in KBBF

We have presented theoretical and experimental investigations of nanosecond (ns) deep-ultraviolet (DUV) 177.3 nm radiation by means of second harmonic generation (SHG) from a frequency-tripled Nd:YAG laser (355 nm, 49 ns and 10 kHz) in KBe₂BO₃F₂ (KBBF) nonlinear crystal for the first time. A DUV KBBF-SHG numerical model, accounting for linear absorption, pump depletion, beam spatial birefringent walk-off and diffraction, is performed in the Gaussian approximation of spatial and temporal profiles. In the experiment, a maximum average output power of 14.1 mW at 177.3 nm was obtained. The dependence of 177.3 nm output power on the 355 nm pump power was simulated. The calculated results are in good agreement with the measured data. We used the model further to investigate the optical conversion efficiency, pulse width, beam spatial intensity profile and beam quality factor of the generated 177.3 nm light, in particular the effect of beam birefringent walk-off.     

The effect of metastable states of the impurities on quantized acoustoelectric current

We report a detailed experimental study of the fluctuations of acoustoelectric (AE) current induced by surface acoustic waves in a shallow-etched quantum point contact defined in a GaAs/Al_xGa_1?xAs heterostructure at 1.7 K. We observe that current fluctuations between two AE current plateaus are more obvious than those at the plateaus. Switching the metastable states of the impurities is considered as the physical origin of the current fluctuations.     

Optical characterization and composition of abdominal wall muscle from rat

Complete optical characterization of biological tissue is desirable to develop clinical methods using optical technologies. Particularly, to develop optical clearing methods in biological tissues, it is necessary to know the composition of the tissue, the percentage of each constituent and corresponding refractive indexes. To obtain such information for rat muscle, we used a simple method to characterize tissue constituents for both content percentage and refractive index. The study consisted on measuring mass with a precision weighting scale and the refractive index with an Abbe refractometer during tissue dehydration. With the collected data, we used a theoretical model to calculate the refractive index and percentage for both interstitial fluid and solid part of the rat muscle. The results obtained are in good agreement with data published by other authors, and were considered of vital information for the optical clearing studies that we planned to perform.