Analysis of whole congener mixtures of polybromodiphenyl ethers by gas chromatography–mass spectrometry in both environmental and biological samples at femtogram levels

A sensitive and selective method for the determination of the whole congener distribution of polybromodiphenyl ethers in environmental and biological samples in one single instrumental run is described. The method is based on gas chromatography coupled to low-resolution mass spectrometry in negative ion chemical ionization mode. It allows determination of these compounds at concentration levels lower than 10⁻¹⁴ g. A programmed temperature vaporization injector has been used to ensure maximum compound transfer to the chromatographic column while maintaining low thermal degradation levels of the more brominated congeners. Selectivity was increased by modification of the MS source parameters for optimization of the abundance of the high mass fragment ions. Under optimized condition, good repeatability (1.7–9.1%) and reproducibility (4.1–20%), and low detection limits, ranging between 1.5 and 15 pg ml⁻¹, were obtained. These features afforded reliable quantification of these compounds in snow and human samples at the concentrations in which these compounds are found.     

Effect of beta-lactoglobulin hydrolysis with thermolysin under denaturing temperatures on the release of bioactive peptides

In this study, bovine beta-lactoglobulin A (beta-Lg A) was hydrolysed with thermolysin under non-denaturing and heat-denaturing conditions. The peptides released during hydrolysis were identified by HPLC-MS/MS. A total of 25 peptides were identified in the hydrolysate obtained at 37 degrees C for 5 min. Some of these peptides survived to further proteolysis even at higher incubation temperatures. Furthermore, novel cleavage sites localised in the most buried zones of beta-Lg and available for thermolysin were recognised when the incubation temperature increased in the range between 60 and 80 degrees C. Three new peptides, LDA, LKPTPEGD, and LQKW, appeared after 30 min hydrolysis at these incubation temperatures, but they were not identified in the 30-min hydrolysates obtained at 37 and 50 degrees C. Of special interest was the peptide LQKW, corresponding to the fragment f(58-61) that had been previously described as a potent angiotensin-converting enzyme-inhibitor (IC50 value of 34.7 microM).     

Microemulsion electrokinetic chromatography separation by using hexane-in-water microemulsions without cosurfactant: comparison with MEKC

A new hexane-in-water microemulsion was investigated as buffer in microemulsion EKC (MEEKC). At difference with other microemulsions, the addition of cosurfactant was not necessary to stabilize the microemulsion. The proposed microemulsion was successfully used to achieve electrophoretic separation of seven antibiotics including nitroimidazoles, cephapirin and tetracyclines. Selectivity and separation efficiency achieved in MEEKC were compared with MEKC. MEEKC technique proved to be more efficient than MEKC for performing the separation of the analytes and the presence of microemulsions was found to be critical to achieve the separation of tetracyclines. The proposed microemulsion also points out that solvents with high volatility, such as hexane, can be stabilized and used as a microemulsion of SDS.     

Changes in the vascular tissue of fresh Hass avocados treated with cobalt 60

This research was based on fresh avocado fruit treated with gamma rays at quarantine doses and stored at room temperature. The effects of irradiation were analyzed and measured by three different types of studies: histological, biochemical and physiological. Histological studies were focused on the effect of Cobalt 60 gamma rays in the mesocarp of avocado irradiated at three different doses; 150, 250, and 350 Gy. Damage was observed principally in the parenchyma tissue where the cell membrane was plazmolized and a red color was observed due to the development of phenol compounds. Another important effect was an increase in the size of xylem and phloem cells in the vascular tissue even at the minimum dose of 150 Gy. The biochemical and the physiological studies were done on avocado fruit irradiated at 100 and 150 Gy. An increase in L-phenilalanine ammonialyase activity was observed and therefore, an increase in the concentration of phenol compounds. These changes were not perceived by panelists in a sensorial test. Irradiated fruits were accepted by panelists as well as control fruit as regards parameters of taste, internal color and external color. These results demonstrate the feasibility of using irradiation to disinfest avocado fruit using a minimum dose of 100 Gy.     

Specific peptides as alternative to antibody ligands for biomagnetic separation of Clostridium tyrobutyricum spores

Nowadays, the reference method for the detection of Clostridium tyrobutyricum in milk is the most-probable-number method, a very time-consuming and non-specific method. In this work, the suitability of the use of superparamagnetic beads coated with specific antibodies and peptides for bioseparation and concentration of spores of C. tyrobutyricum has been assessed. Peptide or antibody functionalized nanoparticles were able to specifically bind C. tyrobutyricum spores and concentrate them up to detectable levels. Moreover, several factors, such as particle size (200 nm and 1 μm), particle derivatization (aminated and carboxylated beads), coating method, and type of ligand have been studied in order to establish the most appropriate conditions for spore separation. Results show that concentration of spore is favored by a smaller bead size due to the wider surface of interaction in relation to particle volume. Antibody orientation, related to the binding method, is also critical in spore recovery. However, specific peptides seem to be a better ligand than antibodies, not only due to the higher recovery ratio of spores obtained but also due to the prolonged stability over time, allowing an optimal recovery of spores up to 3 weeks after bead coating. These results demonstrate that specific peptides bound to magnetic nanoparticles can be used instead of traditional antibodies to specifically bind C. tyrobutyricum spores being a potential basis for a rapid method to detect this bacterial target.     

Mutagenicity of flavonoids assayed by bacterial reverse mutation (Ames) test

The mutagenicity of ten flavonoids was assayed by the Ames test, in Salmonella typhimurium strains TA98, TA100 and TA102, with the aim of establishing hydroxylation pattern-mutagenicity relationship profiles. The compounds assessed were: quercetin, kaempferol, luteolin, fisetin, chrysin, galangin, flavone, 3-hydroxyflavone, 5-hydroxyflavone and 7-hydroxyflavone. In the Ames assay, quercetin acted directly and its mutagenicity increased with metabolic activation. In the presence of S9 mix, kaempferol and galangin were mutagenic in the TA98 strain and kaempferol showed signs of mutagenicity in the other strains. The absence of hydroxyl groups, as in flavone, only signs of mutagenicity were shown in strain TA102, after metabolization and, among monohydroxylated flavones (3-hydroxyflavone, 5-hydroxyflavone and 7-hydroxyflavone), the presence of hydroxyl groups only resulted in minor changes. Luteolin and fisetin also showed signs of mutagenicity in strain TA102. Finally, chrysin, which has only two hydroxy groups, at the 5-OH and 7-OH positions, also did not induce mutagenic activity in any of the bacterial strains used, under either activation condition. All the flavonoids were tested at concentrations varying from 2.6 to 30.7 nmol/plate for galangin and 12.1 to 225.0 nmol/plate for other flavonoids. In light of the above, it is necessary to clarify the conditions and the mechanisms that mediate the biological effects of flavonoids before treating them as therapeutical agents, since some compounds can be biotransformed into more genotoxic products; as is the case for galangin, kaempferol and quercetin.     

CaSO4 and its pressure-induced phase transitions. A density functional theory study

Theoretical investigations concerning possible calcium sulfate, CaSO(4), high-pressure polymorphs have been carried out. Total-energy calculations and geometry optimizations have been performed by using density functional theory at the B3LYP level for all crystal structures considered. The following sequence of pressure-driven structural transitions has been found: anhydrite, Cmcm (in parentheses the transition pressure) → monazite-type, P2(1)/n (5 GPa) → barite-type, Pnma (8 GPa), and scheelite-type, I4(1)/a (8 GPa). The equation of state of the different polymorphs is determined, while their corresponding vibrational properties have been calculated and compared with previous theoretical results and experimental data.     

Shear rheometry and visualization of glass fiber suspensions

The nonlinear rheological behavior of short glass fiber suspensions has been investigated in this work by rotational rheometry and flow visualization. A Newtonian and a Boger fluid (BF) were used as suspending media. The suspensions exhibited shear thinning in the semidilute regime and weaker shear thinning in the transition to the concentrated one. Normal stresses and relative viscosity were higher for the BF suspensions than for the Newtonian ones presumably due to enhanced hydrodynamic interactions resulting from BF elasticity. In addition, relative viscosity of the suspensions increased rapidly with fiber content, suggesting that the rheological behavior in the concentrated regime is dominated by mechanical contacts between fibers. Visualization of individual fibers and their interactions under flow allowed the detection of aggregates, which arise from adhesive contacts. The orientation states of the fibers were quantified by a second order tensor and fast Fourier transforms of the flow field images. Fully oriented states occurred for shear rates around 20 s^− 1. Finally, the energy required to orient the fibers was higher in step forward than in reversal flow experiments due to a change in the spatial distribution of fibers, from isotropic to planar oriented, during the forward experiments.     

Rheo-PIV analysis of the slip flow of a metallocene linear low-density polyethylene melt

The continuous extrusion of a metallocene linear low-density polyethylene through a transparent capillary die with and without slip was analyzed in this work by rheometrical measurements and particle image velocimetry (PIV). For this reason, a comparison was made between the rheological behaviors of the pure polymer and blended with a small amount of fluoropolymer polymer processing additive. Very good agreement was found between rheometrical and PIV measurements. The pure polymer exhibited stick-slip instabilities with nonhomogeneous slip at the die wall, whereas the blend showed stable flow. The slip velocity was measured directly from the velocity profiles and was negligible for the pure polymer before the stick-slip but increased monotonously as a function of the shear stress for the blend. The flow curves and the slip velocity as a function of the shear stress deviated from a power law and were well fitted by continuous “kink” functions. Comparison of PIV data with rheometrical ones permitted a direct proof of the basic assumption of the Mooney theory. Finally, the analysis of the velocity profiles showed that there is a maximum in the contribution of slip to the average fluid velocity, which is interpreted as the impossibility for the velocity profile to become plug like in the presence of shear thinning.