Investigation of isothermal bulk polymerization ofo-alkyaryl methacrylates by DSC

The kinetics of the AIBN-initiated free radical bulk polymerization of fiveo-alkylphenyl methacrylates was studied by means of DSC in the temperature range 353–373 K, and the enthalpy of polymerization, the overall reaction rate constant and the activation energy were determined. The results were compared with those published recently on correspondingp-alkylaryl methacrylates. All measured reaction rate constants were found to increase with increasing temperature and to decrease with increasingo-alkyl substituent mass and size. It was shown thato-substituents influence the rates of polymerization to a greater extent thanp-substituents. At about 373 K, all differences in rate, most probably resulting from steric hindrance caused by the alkyl groups, disappear in both series, a phenomenon earlier observed for dimethyl phenyl methacrylates.This work was supported by the Ministry of Science of the Republic of Serbia.     

Ammonium nitrate changes during thermal analysis

A study was made of the difference occurring in ammonium nitrate during investigation by DTA and by DSC. The results show that the DTA of ammonium nitrate (p.a.) is accompanied by the crystal transformation IV III II I and melting. During DSC investigation of the same ammonium nitrate samples, the salt undergoes the transformations IV III and IV II in parallel; then follow the crystal transformations III II I and melting. The investigation conditions and the history of the samples do not essentially influence the crystal transformations during thermal analysis.

---

Zusammenfassung Bei DTA und DSC von Ammoniumnitrat zu beobachtende Unterschiede wurden untersucht. Bei der DTA von p.a. Ammoniumnitrat verlaufen die Kristallumwandlungen IV III II I sowie der Schmelzvorgang. Während der DSC der gleichen Ammoniumnitratproben verlaufen die Übergänge IV III und IV II parallel, worauf die Kristallumwandlungen III II I und der Schmelzvorgang folgen. Die experimentellen Bedingungen und die Vorgeschichte der Proben hat keinen wesentlichen Einfluß auf die während der thermischen Analyse verlaufenden Kristallumwandlungen.

---

. ( ..) IV III II I . , IV III IV II - , III II ar I . .

     

Free radical-scavenging activity of indolic compounds in aqueous and ethanolic media

Indolic compounds are a broad family of substances present in microorganisms, plants and animals. They are mainly related with tryptophan metabolism, and present particularities that depend on their respective chemical structures. The most important members of the family are the plant hormone, indole-3-acetic acid, and the animal hormone, melatonin. An important characteristic of some indolic compounds is that they may be useful as chemical preventive agents against diseases such as cancer, oxidative stress, etc. For this reason, the possible antioxidant activities (free radical-scavenging activity) of several indoles were studied. The2,2'-azino-bis-(3-ethylbenzthiazoline-6-sulfonic acid /H(2)O(2)/HRP decoloration method was applied to determine both hydrophilic (in buffered media) and lipophilic (in organic media) antioxidant properties of the indolic compounds. Also, a study of the hydrophilic antioxidant activities of indoles at different pH values (between 4.5 and 8.5) was made. Finally, their possible role as diet plant antioxidants is discussed.     

Determination of diethanolamine or <Emphasis Type="Italic">N</Emphasis>-methyldiethanolamine in high ammonium concentration matrices by capillary electrophoresis with indirect UV detection: application to the analysis of refinery process waters

Alkanolamines such as diethanolamine (DEA) and N-methyldiethanolamine (MDEA) are used in desulfurization processes in crude oil refineries. These compounds may be found in process waters following an accidental contamination. The analysis of alkanolamines in refinery process waters is very difficult due to the high ammonium concentration of the samples. This paper describes a method for the determination of DEA in high ammonium concentration refinery process waters by using capillary electrophoresis (CE) with indirect UV detection. The same method can be used for the determination of MDEA. Best results were achieved with a background electrolyte (BGE) comprising 10 mM histidine adjusted to pH 5.0 with acetic acid. The development of this electrolyte and the analytical performances are discussed. The quantification was performed by using internal standardization, by which triethanolamine (TEA) was used as internal standard. A matrix effect due to the high ammonium content has been highlighted and standard addition was therefore used. The developed method was characterized in terms of repeatability of migration times and corrected peak areas, linearity, and accuracy. Limits of detection (LODs) and quantification (LOQs) obtained were 0.2 and 0.7 ppm, respectively. The CE method was applied to the determination of DEA or MDEA in refinery process waters spiked with known amounts of analytes and it gave excellent results, since uncertainties obtained were 8 and 5%, respectively.     

Solid-phase reagent for molecular spectroscopic determination of heavy metal speciation in natural water

A solid-phase reagent based on 1-(4-adamantyl-2-thiasolylazo)-2-naphthol adsorbed onto silica gel was prepared for Co(II) recovery and preconcentration prior to its sorption-spectroscopic detection. The immobilized reagent was applied to the determination of free cobalt ions in natural water. The solid-phase reagent and chemiluminescent method coupled with membrane filtration, gel-permeation and ion-exchange chromatography were applied to the study of the speciation of iron and cobalt in water from the Dnieper reservoirs and lakes of Kyiv City; their predominant forms were complexes of Fe(III) and Co(II) with dissolved organic matter and fulvic acids play a main role in their complexation.     

Facilitated transport of Hg(II) through novel activated composite membranes

The results presented in this work deal with the prime application of activated composite membranes (ACMs) for the transport of Hg(II) ions in a continuous extraction–re-extraction system using di-(2-ethylhexyl)dithiophosphoric acid (DTPA) as carrier. The effects of variables such as the pH, the nature of the acid and the concentration of the casting solutions on the transport of Hg(II) are also investigated. When the ACM was prepared with a 0.5 M DTPA solution and when the feed solution contained 2.5×10^–4 M Hg(II) in 0.1 M HCl, the amount of mercury extracted was greater than 76%. The re-extracted mercury was subsequently recovered by means of a stripping phase comprising 0.3 M thiourea solution in 2 M H₂SO₄, yielding 54% of the initial amount of mercury after transport had taken place for 180 min.     

Oxygen diffusion in SrCe<Subscript>0.95</Subscript>Yb<Subscript>0.05</Subscript>O<Subscript>3−δ</Subscript>

¹⁸O/¹⁶O isotope exchange depth profiling (IEDP) combined with secondary ion mass spectrometry (SIMS) has been used to measure the oxygen tracer diffusivity of SrCe_0.95Yb_0.05O_3– between 800 °C and 500 °C at a nominal pressure of 200 mbar. The values of D* (oxygen tracer diffusion coefficient) and k (surface exchange coefficient) increase steadily with increasing temperature, and the activation energies are 1.13 eV and 0.96 eV, respectively. Oxygen ion conductivities have been calculated using the Nernst–Einstein equation. The transport number for oxide ions at 769 °C, the highest temperature studied, is only ~0.05. Moreover, SrCe_0.95Yb_0.05O_3– has been studied using impedance spectroscopy under dry O₂, wet O₂ and wet H₂ (N₂/10% H₂) atmospheres, over the range 850–300 °C. Above ~550 °C, SrCe_0.95Yb_0.05O_3– shows higher conductivity in dry O₂ than in wet O₂ or wet H₂; below that temperature the results obtained for the three atmospheres are comparable. Dry O₂ shows the highest activation energy (0.77 eV); the activation energies for wet O₂ and wet H₂ are identical (0.62 eV).Abbreviations HTPC high-temperature proton conductor - IEDP isotope exchange depth profiling - SIMS secondary ion mass spectrometryPresented at the OSSEP Workshop Ionic and Mixed Conductors: Methods and Processes, Aveiro, Portugal, 10–12 April 2003     

Multicommutation as an environmentally friendly analytical tool in the hydride generation atomic fluorescence determination of tellurium in milk

The aim of this study is to show the advantages of the emerging multicommutation methodology based on the use of solenoid valves for Te determination in milk by hydride generation atomic fluorescence spectrometry (HG-AFS). The delivery of a series of alternating sequential insertions of small volumes of samples and reagents gives rise to new hydrodynamic processes and exciting analytical potentials by controlling the time of flow through the on/off-switched solenoid valves. This drastically reduces the reagent consumption by a factor of 4 and the generation of effluents (590 mL h^–1 instead of 750 mL h^–1 generated by the continuous-mode measurement) and also provides an improvement in the laboratory productivity by an increase of the sample throughput (85 h^–1 compared to 20 h^–1 found in the continuous mode). So, multicommutation is an environmentally and economically sustainable alternative to the methodology based on continuous measurements. The multicommutation-based method developed was applied to tellurium determination in commercially available milk samples; a calibration range of 0.0–0.5 ng mL^–1 and a detection limit of 0.20 ng L^–1 with average relative standard deviation of 2.1% were found. Comparable results were obtained for a series of samples using both continuous and multicommutation HG-AFS modes.     

Preconcentration using diethylenetriaminetetraacetic acid-functionalized polysiloxane (DETAP) for determination of molybdenum(VI) in seawater by ICP–OES

This paper reports a new method for preconcentration and separation of trace amounts of molybdenum in seawater samples prior to determination by inductively coupled plasma–atomic emission spectroscopy (ICP–OES). Diethylenetriaminetetraacetic acid-functionalized polysiloxane (DETAP) was synthesized by carboxymethylation of amino groups on triamine immobilized polymer, which was prepared by modification of 3-chloropropylpolysiloxane with diethylenetriamine. The resulting polysiloxane is highly selective and efficient in chelating Mo(VI) at trace levels. It can be used as a column packing material. The polysiloxane column can be reused over ten times without losing its original properties, so it is suitable for preconcentration of molybdenum species in seawater samples before determination. The parameters governing the characteristics of polysiloxane for adsorption of Mo(VI) were investigated. These include the effect of pH, amount of polysiloxane, equilibrium time, adsorption isotherm, maximum adsorption capacity, interfering ions, flow rate, capacity for reuse, and desorption. The precision of the preconcentration method, calculated as the relative standard deviation of seawater samples, was 3%. The preconcentration factor was 100. The detection limit, defined as 3 times the standard deviation of five replicate measurements of the blank sample at pH 3, was 0.17 g L^–1. Measurement results for standard reference materials were in good agreement with the certified values [(CRMs), NASS-2 Seawater (Open Ocean) and CASS-2 Seawater (Coastal)].     

Evaluation of glycoalkaloids in tubers of genetically modified virus Y-resistant potato plants (var. Désirée) by non-aqueous capillary electrophoresis coupled with electrospray ionization mass spectrometry (NACE–ESI–MS)

The glycoalkaloid content of transgenic potatoes was evaluated by an optimised method based on non-aqueous capillary electrophoresis coupled on-line with electrospray ionization-mass spectrometry (NACE-ESI-MS). The potato material consisted of tubers from a conventional cv. Désirée and from three lines of modified plants resistant, intermediate and susceptible to infection by potato virus Y (PVY). The main glycoalkaloids were confirmed to be alpha-solanine and alpha-chaconine with parent ion masses m/z 852 and 868, respectively. In addition, an unknown minor peak at m/z 850.6 was found both in conventional (control) and susceptible line potato tubers. Such a compound exhibited an MS(2) spectrum with fragments ions at 704 and 396 m/z derived by loss of two ions, i.e. m/z 146 and 307, most likely corresponding to a rhamnose unit and a [glucose-(rhamnose)(2)] moiety, respectively. Up to 30-80-fold higher concentrations of total glycoalkaloids were found in the peel compared to flesh samples of all tubers examined. TGA content was nearly doubled in peel samples of resistant compared to control lines, and these levels were lower than the limit recommended for food safety, i.e. 20-60 mg of TGA per 100 g fresh weight. Moreover, it was established that tubers produced by virus-resistant clones are substantially equivalent in glycoalkaloid contents to those produced by conventional potato varieties.