Mode equation and its solution for dielectric waveguide with parabolic cross-section

The mode equation for the dielectric waveguide with parabolic cross-section is derived using both the effective index method and WKB theory, and the expression of the mode propagation constant or effective index is solved directly from this mode equation, so that the mode-propagation properties of this kind of waveguide can be analysed conveniently with comparative accuracy.     

A side-coupled photonic crystal filter with sidelobe suppression

This paper presents the theoretical model and the optimization method to suppress the sidelobes of side-coupled photonic crystal filters. Numerical verification shows a good agreement between the theoretical method and the finite-difference time-domain simulation, but the theoretic method does not involve the time-consuming computation. The theoretical method also presents a better physical image for choosing the critical parameters, such as the quality factor, phase shift and the number of resonators. Based on the theoretical model, two optimization methods (chirp and cascading) are proposed to deeply suppress the sidelobes. They also show more flexibility in controlling the bandwidth and steepness of the roll-off in the filter. PACS 42.70.Qs     

Analysis of Metabolites in Allantoic Fluid of Chicken Embryo by 900 MHz NMR Spectroscopy

900 MHz ¹H NMR (nuclear magnetic resonance) spectroscopy was used to analyze metabolites in allantoic fluid of the chicken embryo in the 9th incubation day without any chemical or physical sample separation. The result showed that superhigh spectral dispersion and sensitivity at 900 MHz are useful in directly analyzing a complex mixture, particularly in resolving the overlapped NMR resonances. In this study, we had assigned 61 metabolites and 26 chemical fragments in the allantoic fluid. The relative concentrations of the major metabolites were also measured. Among the assigned metabolites, some were detected by NMR in chicken embryo allantoic fluids for the first time. The biological functions of these compounds were briefly discussed. Authors' address: Maili Liu, State Key Laboratory of Magnetic Resonance and Atomic and Molecular Physics, Wuhan Institute of Physics and Mathematics, Chinese Academy of Sciences, Wuhan 430071, People's Republic of China     

Magnetically rotational reactor for absorbing benzene emissions by ionic liquids

A magnetically rotational reactor （MRR） has been developed and used in absorbing benzene emissions. The MRR has a permanent magnet core and uses magnetic ionic liquid [bmim]FeCl4 as absorbent. Benzene emissions were carried by N2 into the MRR and were absorbed by the magnetic ionic liquid. The rotation of the permanent magnet core provided impetus for the agitation of the magnetic ionic liquid, enhancing mass transfer and making benzene better dispersed in the absorbent. 0.68 g benzene emissions could be absorbed by a gram of [bmim]FeCl4, 0.27 and 0.40 g/g higher than that by [bmim]PF6 and [bmim]BF4, respectively. The absorption rate increased with increasing rotation rate of the permanent magnet.     

小分子硫原子团簇正离子的结构稳定性

用分子图形软件设计出 4 9种硫原子团簇Sn+ (n =3～ 13)的结构 ,使用B3LYP密度泛函进行几何构型优化和振动频率计算 ,根据分子的总能量得出最稳定的同分异构体 .在硫原子团簇正离子中 ,大部分原子为二配位成键 .带有一、三配位的原子结构的总能量较高 .部分最稳定硫原子团簇正离子的构型与最稳定的中性硫原子团簇的构型完全不同 .     

新超导体MgCNi3的虚晶掺杂研究

用全势线性缀加平面波方法,考虑局域自旋密度近似研究虚晶掺杂MgCNi3的超导电性和磁性.计算了自旋极化能带结构、体弹性模量和它对压力的导数、原子磁矩 m 及其变化率.计算结果表明,对于电子掺杂的Mg1-xAlxCNi3(0≤x≤0.5), 超导电性和磁涨落随掺杂量的增加逐渐减小.空穴掺杂的Mg1-xNaxCNi3,在x＝0.12处出现铁磁相变,超导电性消失.在MgCNi3少量空穴掺杂区域(0≤x<0.12),表现为超导与磁涨落共存的不稳定状态.     

Ⅰ类超晶格势阱中能级分布及电子跃迁规律研究

在研究大量实验曲线的基础上,指出势阱所有能级均有一定的宽度,电子或空穴在各能级中出现的概率符合正态分布,从理论上分析了I类超晶格和双势垒单势阱的发光光谱与吸收光谱·解释了GaAs/Ga1-xAlxAs多量子阱和超晶格吸收光谱吸收边及量子阱变窄时各吸收峰的“蓝移现象”及GaAs/Ga1-xAlxAs双势垒单量子阱样品的电流—电压特性曲线及电导—电压特性曲线的特征和出现的“负阻效应”·     

Eu3+离子在微晶玻璃研究中的探针作用

制备出单掺Eu3+离子的氟氧化物玻璃陶瓷系列样品,利用Eu3+离子作为荧光探针,通过热处理前后Eu3+离子发射光谱中电偶极子跃迁与磁偶极子跃迁强度比值的变化表征在玻璃材料中微晶是否形成,分析了Eu3+离子荧光发射谱中电偶极子跃迁与晶体场对称性的关系,进一步表征了稀土离子所处微晶晶格场的变化.     

A NOVEL METHOD FOR FABRICATING COMPOSITE MOSAIC MEMBRANE WITH UNIQUE NF SELECTIVITY

A novel method of fabricating composite mosaic membranes was studied on the basis of interracial polymerization （IP） by coating a thin selective layer onto the surface of a micro-porous hollow-fiber membrane, in which, 2,5-diaminobenzene sulfonic acid was used as one monomer of the IP reaction, and a mixture of trimesoyl chloride （TMCI） and 4-（chloromethyl） benzoyl chloride as the other monomer. Through the IP reaction a thin selective layer with negatively charged groups could be first formed on the polyethersulfone （PES） support membrane. Then trimethylamine solution was introduced to modify the IP layer through a quaternization reaction. Thus the selective layer of this composite membrane contained both negatively charged and positively charged groups to perform the mosaic functionality. Characterization of the composite mosaic membranes was carried out through permeation experiments using different inorganic salts and dyes. The experimental results showed that the membranes could permeate both mono- and bi-valent inorganic salts, but reject larger organic molecules. Such a mosaic membrane is potentially useful for the separation of salts from water-soluble organics, especially in dye and textile industries.     

Study on anti-emission materials for non-emitting grid applications in microwave power tubes

Hafnium and platinum were deposited onto molybdenum grids by ion-beam assisted deposition method. Electron-emission characteristics from molybdenum grids with Hf and Pt films, which were contaminated by active electron-emission substances (Ba, BaO) of the cathode, were measured using analogous diode method. The surfaces of grids were analyzed by X-ray diffraction. The results revealed that the reaction between BaO and Hf formed BaHfO₃ compound, which greatly reduced the accumulation of BaO on the surface and accordingly decreased grid emission. In contrast, Ba were formed by the decomposition of BaO on the surface of Pt film under high temperature and re-evaporated from its surface, which reduced the active electron-emission substances on the surface of the grid and effectively restrained grid emission. Their mechanisms for grid-emission suppression are discussed and a good method to develop new grid-coating materials is suggested.