电极条件对硫酸介质中电解还原提纯镱过程的影响

研究了以钌铱钛合金网和汞分别为阳、阴电极, 在无气氛保护条件下, 采用电解还原方法从铥、镱、镥硫酸盐溶液中分离提纯镱的过程. 讨论了在8 V恒电压时的电极间距、位置, 以及阴、阳极表面积对电解过程中的电流、还原率影响. 优化了电解还原过程, YbSO4产品的纯度稳定达到99.5%以上, 一次收率可达80%;提镱后母液中的铥和镥被富集4倍以上, 其中Lu含量高于50%, 十分有利于后续铥/镥分离.     

5''''-鸟苷酸与茜素红S的反应及其在分析化学中的作用

采用UV-Vis光谱法研究了茜素红S(ARS)与5'-鸟苷酸(5'-GMP)在pH 4.80的弱酸性缓冲溶液中生成络合物的结合反应.与试剂比较,络合物的最大吸收峰红移92 nm,测得络合物和表观摩尔吸光系数为ε＝1.3×104 L·mol-1·cm-1;最大结合数n=10;浓度线性范围0.2～16 mg/L;检出限为6.1×10-8 mol/L.研究了ARS与5'-GMP是分子间作用力的结合反应,并对时间、温度、离子强度对结合反应的影响,以及无机物、生物物质对反应体系的干扰情况进行了初步研究.     

Synergetic degradation of chitosan with gamma radiation and hydrogen peroxide

Chitosan samples were irradiated by ⁶⁰Co γ-rays in the presence of hydrogen peroxide with radiation dose from 10 kGy to 100 kGy. The degradation was monitored by gel permeation chromatography (GPC), revealing the existence of a synergetic effect on the degradation. Structures of the degraded products were characterized with Fourier-transform infrared spectra (FT-IR), ultraviolet-visible spectral (UV-vis) analysis, and X-ray diffraction (XRD). Results showed that the crystallinity of chitosan decreases with degradation, and the crystalline state of water-soluble chitosan is entirely different from that of water-insoluble chitosan. An elemental analysis method was employed to investigate changes in the element content of chitosan after degradation. Mechanism of chitosan radiation degradation with and without hydrogen peroxide was also discussed.     

锆对铂重整催化剂性能的影响规律

以正庚烷的转化为探针反应 ,研究了添加元素锆对铂重整催化剂性能的影响规律。结果表明 ,在 4 50℃和连续流动条件下 ,Pt/γ -Al2 O3催化剂中引入锆不仅能够提高铂催化剂的稳定性和芳构化产率、抑制氢解和异构化 ,而且能使铂催化剂保持初活性。锆含量在 0 .56%左右 ,其调变作用最为显著。     

Ce0.6Zr0.35Y0.05O2和Pr0.6Zr0.35Y0.05O2催化剂表面上CO氧化和18O-16O交换反应的研究

测定了在Ce0.6Zr0.4O2,Ce0.6Zr0.35Y0.05O2,Pr0.6Zr0.4O2和Pr0.6Zr0.35Y0.05O2 (分别表示为CZ,CYZ,PZ和PYZ)样品表面上的CO氧化反应和18O-16O 同位素交换反应.结果表明: 在CZ和PZ系列固熔中掺杂Y3 离子可以改善晶格氧的迁移速度;PZ和PZY的晶格氧比CZ 和CZY 的晶格氧具有更高的氧化反应活性.其原因是将Y3 掺杂到Ce0.6Zr0.4O2 或Pr0.6Zr0.4O2晶格中,增加了样品的氧空位浓度,从而提高了晶格氧的迁移性质,而PrOx比CeO2具有更低温度的氧化还原性质,因此PZ和PZY的晶格氧比CZ 和CZY 的晶格氧具有更高的氧化反应活性.     

Mechanical properties of BPDA-ODA polyimide fibers

An aromatic polyimide was synthesized via a one-step polycondensation reaction between biphenyltetracarboxylic dianhydride (BPDA) and 4,4′-oxydianiline (ODA) in p-chlorophenol. The polyimide (BPDA-ODA) solution dopes were spun into fibers by means of dry-jet wet spinning. The as-spun fibers were drawn and treated in heating tubes for improving the mechanical properties. The thermal treatment on the fibers resulted in a relatively high tensile strength and modulus. Thermal mechanical analysis (TMA) was employed to study the linear coefficient of thermal expansion (CTE). Thermal gravimetry analysis (TGA) spectra showed that the BPDA-ODA fibers possessed an excellent property of thermo-oxidative degradation resistance. The sonic modulus E_s of the polyimide fibers was measured.     

Solution-phase synthesis and electrochemical hydrogen storage of ultra-long single-crystal selenium submicrotubes

Ultra-long single-crystalline trigonal selenium submicrotubes were synthesized using a facile one-step solution-phase approach with the assistance of nonionic surfactant Polyoxyethylene(20)sorbitan monolaurate (Tween-20), which turned out to be significant for the formation of ultra-long Se submicrotubes. XRD, Raman, SEM, and TEM were adopted to characterize the morphology, structure and phase composition of the as-prepared Se products. It was found that the length of the obtained Se submicrotubes was over 100 microm. By variation of the experimental parameters, the t-Se spheres, nanowires, and broken microtubes can be prepared. The possible growth mechanism of the ultra-long selenium submicrotubes was explained. In addition, we have also demonstrated that the synthesized ultra-long t-Se submicrotubes using the Tween-20-assisted approach can electrochemically charge and discharge with the high capacity of 265 mAh/g (corresponding to 0.97 wt % hydrogen in SWNTs) under normal atmosphere at room temperature. Cyclic voltammetry was adopted to investigate the adsorption-oxidation behavior of ultra-long selenium submicrotubes. It was observed that the morphology of the synthesized selenium products had a remarkable influence on their capacity of electrochemical hydrogen storage. These differences in hydrogen storage capacity are likely due to the size and density of tubes as well as the microcosmic morphology of different Se samples. The as-obtained ultra-long Se submicrotubes are expected to find wide applications in hydrogen storage, high-energy batteries, and optoelectronic, biologic, and catalytic fields as well as in the studies of structure-property relationships. This simple Tween-assisted approach might be extended to the preparations of one-dimensional nanostructures of tellurium and other anisotropic materials.     

Potentiodynamic deposition of Prussian blue from a solution containing single component of ferricyanide and its mechanism investigation

Potentiodynamic techniques were used for the direct electrodeposition of Prussian blue nano-clusters from an acidic solution of ferricyanide. Electrochemical, EQCM, IR, AFM, and UV/vis measurements were carried out to characterize deposited nano-sized Prussian blue and to explore the formation mechanism. Results showed that ferricyanide could partially dissociate to free ferric and cyanide ions. The driving force of this dissociation is the formation of PB and the evolution of HCN. The optimal potential window for the potentiodynamic formation of PB from an acidic solution (pH 1.6) is between –0.5 V and 0.4 V. In addition, the influence of surface adsorption of CN^- ions on the formation of PB was discussed.Dedicated to Professor W. Vielstich on the occasion of his 80th birthday.     

季铵盐固相催化使聚氯乙烯脱HCl

通过将季铵盐与聚氯乙烯(PVC)混溶成膜,使其在固相脱HCl,研究了催化剂对PVC脱HCl反应速度和产物结构的影响以及固相反应与温度、时间的关系.发现在催化性能上下基铵盐比乙基铵盐好得多,根据实验结果提出了季铵盐通过分解成叔胺实现催化的机理.     

2,2—二（4—甲氧基苯基）—1,1—二氯乙烯的显色反应及应用研究

本文对2,2-二(4-甲氧基苯基)-1,1-二氯乙烯(简称DMDE)与H_2SO_4显色反应的机理进行了探讨,证实了该反应为可逆反应,其显色产物与亲电加成反应的中间体有关;并利用该反应建立了甲氧基氯原药和乳油中DMDE含量的分光光度测定方法。实验表明:DMDE在0～27.5μg/10ml范围内服从比耳定律,其表观摩尔吸光系数ε为2.56×10~4L·mol~(-1)·cm~(-1)。应用该法对甲氧基氯原药和乳油进行了分析,获得满意结果。