First-principles study of mechanical stability and thermal properties of MNNi3 （M=Zn,Mg,Al） under pressure

The mechanical stability,elastic,and thermodynamic properties of the anti-perovskite superconductors MNNi 3（M=Zn,Mg,Al） are investigated by means of the first-principles calculations.The calculated structural parameters and elastic properties of MNNi 3 are in good agreement with the experimental and the other theoretical results.From the elastic constants under high pressure,we predict that ZnNNi 3,MgNNi 3,and AlNNi 3 are not stable at the pressures above 61.2 GPa,113.3 GPa,and 122.4 GPa,respectively.By employing the Debye model,the thermodynamic properties,such as the heat capacity and the thermal expansion coefficient,under pressures and at finite temperatures are also obtained successfully.     

Removing paint from a metal substrate using a flattened top laser

In this paper,we investigate laser cleaning using a flattened top laser to remove paint coating from a metal substrate.Under the irradiation of a flattened top laser,the coating paint of the metal substrate can be removed efficiently by laser induced ablation,stress,and displacement force.The temperature distribution,stress,and displacement are calculated in the coating layer and substrate using finite element analysis.The effects of a Gaussian laser and a flattened top laser and the results of different diameters of laser spot are compared.The investigation shows that the flattened top laser can reduce the substrate damage and enhance the cleaning efficiency.This method meets the need of large area industrial cleaning applications by optimizing the flattened top laser parameters.     

1064 nm激光对中性密度滤光片的损伤机理研究

中性密度滤光片的典型结构是在K9玻璃上镀金属膜,来实现对激光的有效吸收.由于损伤阈值较低,严重限制了其在高能激光系统中的应用.实验研究了较高激光能量密度下滤光片的损伤形貌和损伤机理.损伤形貌的变化特征是:随着激光能量密度的增加,滤光片先出现损伤点,后以损伤点为中心产生裂纹,且裂纹长度逐渐变长,最终连接成线状和块状,导致大面积的薄膜脱落.建立了缺陷吸收激光能量升温致中性密度滤光片表面薄膜损伤的模型,计算了薄膜表面的温度和应力分布,讨论了薄膜表面不均匀温升造成的径向、环向和轴向热应力分布.理论分析显示:环向应力是造成薄膜沿径向产生裂纹的主要原因.当激光能量密度大于约2.2 J/cm²,杂质粒子半径大于140 nm且相邻杂质粒子之间的距离小于10 μ m时,裂纹才能大量连接起来引起薄膜的大面积脱落.     

铁基Heusler合金Fe2Co1-xCrxSi的结构、磁性和输运性质的研究

基于多种实验手段和能带计算的方法, 对四元合金Fe₂Co_1-xCr_xSi的晶体结构、 磁性、输运性质及能带结构进行了研究. 研究发现, 随着Cr的增加, 合金Fe₂Co_1-xCr_xSi保持了高度有序结构, 逐渐从Hg₂CuTi结构的Fe₂CoSi 过渡到L2₁结构的Fe₂CrSi; 由于次晶格网络的破坏, 居里温度逐渐下降; 系列合金的分子磁矩呈现线性下降, 符合半金属特性; 剩余电阻比率与原子占位有序程度密切相关, 呈现两端大、 中间小的特点. 在Cr替代Co的过程中, 材料半金属能隙逐渐打开, 表现半金属特征. 同时费米能级从Fe₂CoSi半金属能隙的价带顶上移至Fe₂CrSi能隙的导带底. 最大的能隙宽度出现在x= 0.75处, 这表明四元合金有可能成为具有更高自旋极化率和更强抗干扰能力的自旋电子学材料.     

基于1/f噪声变化的pn结二极管辐射效应退化机理研究

基于pn结二极管辐射效应退化机理中位移效应和电离效应之间的关系, 并结合pn结二极管辐射退化的噪声机理, 得到了pn结二极管辐射诱导低频噪声的变化规律, 发现两种效应引起的二极管噪声变化规律之间的不一致性. 根据实验得到的噪声变化规律, 判断出了辐射应力条件下两种效应之间的关系, 很好地解释了实验中出现的不符合原有理论解释的现象, 对器件加固的研究有着重要意义.     

Typical Microstructures of Chinese Medicines with X-Ray Microscopy in Phase Contrast

Due to the low absorption contrast of plant tissues, traditional x-ray radiography has not been included in the microscopic techniques used in the identification of traditional Chinese medicines （TCMs）. With the development of x-ray phase contrast imaging （XPCI） in recent years, weakly absorbing materials could also be imaged by x- rays. Here we investigate microstructures of TCMs utilizing XPCI based on a nano-focus x-ray tube. The results demonstrated that XPCI is capable of revealing the microstructures of TCMs used as judging criteria in the identification of TCMs. The major advantages of the new method are nondestructivity, no special demand for sample preparation and suitability for thick samples.     

CNx纳米管的制备、结构观察及低场致电子发射性能研究

采用高温热解法，以乙二胺为前驱液，在沉积有铁催化剂的p型硅（111）基底上制备出了定向生长的CNx纳米管.利用扫描电子显微镜、高分辨率透射电子显微镜和拉曼光谱对CNx纳米管进行了形貌观察和表征.CNx纳米管的高度在20?μm左右，直径在50—100nm之间，具有明显的“竹节状”结构，结晶有序度较差.对CNx纳米管薄膜进行低场致发射性能测试：外加电场为1.4V/μm，观察到20?μA /cm2发射电流，外电场升至2.54V/μm时发射电流达到1.280mA/cm2，在较高外电场下，没有发现电流“饱和”.这比 关键词： CNx纳米管 高温热解 “竹节状”结构 场致发射     

裂缝性地层黏弹性地震多波波动方程

裂缝检测是目前国内外石油勘探界研究的一个热点问题，如何确定裂缝方位等参数是石油公司面临的难题，而解决该难题就要确定裂缝方位等参数与地震波场传播之间的定量关系.但是目前所采用的裂缝性地层介质模型不能完全定量地反映裂缝的方位特征和衰减特征.针对该问题，建立了具有任意裂缝方位的裂缝性地层介质模型；并构造了时间增量的方法，将非线性的卷积积分采用近似的方法实现，建立了以位移场表示的具有任意方位角的黏弹性方位各向异性介质的波动方程.该波动方程定量地给出了黏弹性波场特征与裂缝走向的关系，描述了黏弹性地震波在这种介质中的 关键词： 裂缝 各向异性 黏弹性 波动方程     

纳米ZnO的表面化学修饰及其分析表征

采用水溶性羟丙基甲基纤维素HPMC对无机纳米ZnO粒子进行物理吸附处理 ,获得了核为无机纳米ZnO ,外壳为水溶性高分子HPMC的粒子。然后在其上进行了甲基丙烯酸甲酯的接枝聚合。采用红外光谱、差热分析的方法对复合粒子进行了表征 ,并采用透射电镜观察了粒子的形貌。红外光谱表明在纳米ZnO的表面吸附了HPMC并接枝了PMMA ,差热分析表明HPMC ,HPMC g PMMA和ZnO/HPMC g PMMA的热稳定性逐渐提高 ,透射电镜观察表明 ,在纳米ZnO的表面粘附了一层聚合物 ,成功地实现了纳米粒子的表面修饰。     

The measurements of correlation times of molecules adsorbed on silica gel,alumina and charcoal using NOESY and MAS NMR

The correlation times (τ_c) and cross relaxation rates of toluene, dimethylformamide, tetrahydrofuran, water-acetone and water-dioxane adsorbed on silica gel, alumina and charcoal were obtained by measurements of the integrated intensities of cross and diagonal peaks in their NOESY spectra. The (τ_c) of the above mentioned systems is in the range of 10^?6?10^?9 s, much longer than that in the liquid (10^?12?10^?14 s). It was found that intramolecular rotation of toluene adsorbed on charcoal is slower than that on SiO₂, Al₂O₃ and the inversion of α and β protons in tetrahydrofuran is very fast (τ_c = 1.76×10^?9 s). The cross relaxation plays an important role in the relaxation of molecules adsorbed on solid surfaces with low electron densities.