Single crystal tin nano-rod arrays electrodeposited by a soft template

Single crystal tin nano-rod arrays were fabricated by the electrodeposition method when amphiphilic triblock copolymer P123 was used as a soft template at a concentration much lower than that for forming a liquid crystalline phase.     

Preparation and electrochemistry of azobenzene self-assembled monolayers on gold--long range tunneling and end-group hydrogen bonding effect

A series of thiol-functionalied azobenzene derivatives (RAzoCnSH: R=H for n=3-6, abbreviated as AzoCnSH; R=CH(3)CONH for n=4, abbreviated as aaAzoC4SH) on gold electrodes were prepared and their self-assembly and electrochemical properties were studied by cyclic voltammetry. They all formed uniform and reproducible self-assembled monolayers (SAMs) on gold and showed well-behaved voltammetric responses in aqueous solution. Both the length of the alkyl chain spacer and the H-bonding of the end acetamino group had effects on the stability and the electrochemical kinetics of the SAMs, and the effect of the H-bonding was dominant. The surface coverage of the SAMs (AzoCnSH) is gradually increased with an increase of the alkyl chain spacer length, whereas the presence of the terminal acetamino group leads to a greater increase of the surface coverage. At a low scan rate, voltammetric responses corresponding to an irreversible two-electron, two-proton reduction/oxidation of the trans-azobenzene redox center were obtained in the range of +300 mV and -800 mV, which exhibited very large peak-to-peak splitting. At a high scan rate of 500 mV/s, two steps of reversible one-electron, one-proton reduction/oxidation corresponding to the cis-isomer in azobenzene-thiol SAMs (n is odd) was clearly observed between +300 and -200 mV. The apparent electron-transfer rate is decreased with increasing distance between the azobenzene redox center and the gold electrode. The existence of the end acetamino group which restricted the conformational change during the redox process also led to a decrease of the standard rate constant, and this restriction effect is more predominant than the distance effect.     

含二氧杂环异黄酮的合成

本文报道含有3', 4'-亚甲二氧基, 3', 4'-亚乙二氧基, 3, 4'-三亚甲二氧基的异黄酮类化合物的合成, 所得25个新化合物的结构经元素分析、^1H NMR谱确证; 紫外光谱表明有异黄酮特征吸收。文中并对反应机理进行了探讨。     

碱性介质中高择优取向（220）镍电极上丙醇的电氧化

对１．０ｍｏｌ／ＬＮｉＳＯ４和０．５ｍｏｌ／Ｌ Ｈ３ＢＯ３体系，控制电位为一１．２５Ｖ，沉积６０ｍｉｎ，制得高择优取向镍电极。该镍电极经Ｘ射线衍射测定其织构度ＴＣ２２０为９２％。采用循环伏安法研究了１ｍｏｌ／Ｌ ＮａＯＨ溶液中高择翁取向镍电极上丙醇的电催化氧化机理有活性，结果表明：高择优取向镍电极对正丙醇的电催化活性高，对异丙醇的电催化活性小；推导出正丙醇的电氧化动力学方程，运用稳态极经曲线测定了     

Tris(2,2''''-bipyridyl)ruthenium(Ⅱ) electrochemiluminescence (ECL) enhanced by rutin on platinum electrode

Ru(bpy)_(3~(2 )) electrochemiluminescence (ECL) was applied to determination of rutin. ECL intensity of Ru(bpy)_(3~(2 ))could be enhanced in the presence of rutin in basic solution on platinum electrode. At pH 9.9, light emission intensity was found to be linear with rutin in the range of 1-50 mmol/L.     

从蓖麻油制取10-羟基癸酸的研究

本文报道了从蓖麻油制取10-羟基癸酸的研究,发现了从蓖麻油制取10-羟基癸酸的新的工艺路线和最佳的工艺条件,用氢氧化钠用量、2-辛醇量、反应时间和反应温度四因子三水平L_9(3~4)进行了正交试验,发现最佳工艺条件是:氢氧化钠(g)/蓖麻油(g):1.25:2-辛醇量(g)/蓖麻油(g):2:反应时间:6h;反应温度:180℃。在这一新的工艺路线和最佳工艺条件下,10-羟基癸酸产率可达75％。     

容量法测定氧化钒中的各种价态钒

用NaOH溶液处理样品，分离V（V）然后以Fe(Ⅱ）滴定测定之。定量加入过量的V（V）到上述残渣中并用H2SO4溶解，用Fe(Ⅱ）滴定，计算出V（Ⅱ），V（Ⅲ）的含量。V（Ⅳ）的测定是通过从总钒量中扣除V（Ⅱ）、V（Ⅲ）、V（Ⅴ）的含量得到。V（Ⅱ）、V（Ⅲ）和V（Ⅴ）的回收率均大于96％，其8次测定结果的相对标准偏差分别为：9．8％、0．4％、1．2％；本法快速、简便，在实际应用中效果良好。     

24-亚甲基-胆甾-3β,5α,6β,19-四醇——一种罕见的含19-羟基的多羟基甾醇

从我国西沙群岛采集的软珊瑚Nephthea albida和南沙群岛采集的N.tixiexae uer seueldt的乙醇,抽提物中,通过硅胶层析分离出一种罕见的含19-羟基的多羟基甾醇——Nephalsterol-A(1),该物质为无色针状结晶,m.p.242～243℃,[a]_D~(20)=O(C 0.053,CH_3OH),为一新化合物。 (1)的ELMS显示分子离子峰m/z 448,结合~(13) NMR DEPT谱确定(1)的分子式为C_(28)H_(48)     

基团的电子效应与单取代苯对位^1H,^13C的化学位移

基团的电子效应与单取代苯对位１Ｈ、１３Ｃ的化学位移＊韩长日冯娇杨钟照平（海南师范学院化学系海口５７１１５８）关键词１Ｈ的化学位移１３Ｃ的化学位移基团电负性共轭效应引言在１Ｈ、１３Ｃ核磁共振谱中，化学位移值的大小主要取决于屏蔽作用的大小，而屏蔽作用的大...