Oxidative Methyl Esterification of Primary Alcohols with Iodine‐Mediated Poly[4‐(Diacetoxyiodo)Styrene]

An operationally simple oxidative methyl esterification of primary alcohols in good yields using an iodine‐mediated poly[4‐(diacetoxyiodo)styrene] in methanol at room temperature is described. The polymeric reagent can be regenerated and reused as an environmentally benign reagent.     

呋喃西林水溶液在光和热作用下的稳定性

The influence of both light and heat on the stability of nitrofurazone aqueous solution was studied. Results show that in either heating experiments or the exposure to light at high temperatures, the degradation rate obeyed zero-order kinetics. The total rate constant ktotal caused by both light and heat can be divided into two parts: ktotal =kdark klight, where kdark and klight are the degradation rate constants caused by heat and light, respectively. The klight can be expressed as klight=Alight*exp(-Ea,light/RT)*E, where E is the illuminance of light, and Alight and Ea,light both are experimental constants. The values of these kinetic parameters were determined based on the experiments in the dark and upon exposure to three different light sources. Results show that the values of Alight and Ea, light varied with the light source. To save time, labor, and drugs, exponential heating experiments were employed and compared with the isothermal experiments. Results indicated that kinetic parameters obtained by exponential heating experiments are comparable to those obtained by isothermal experiments either in the dark or upon exposure to light.     

Multilayer poly(vinyl alcohol)-adsorbed coating on poly(dimethylsiloxane) microfluidic chips for biopolymer separation

A poly(dimethylsiloxane) (PDMS) microfluidic chip surface was modified by multilayer-adsorbed and heat-immobilized poly(vinyl alcohol) (PVA) after oxygen plasma treatment. The reflection absorption infrared spectrum (RAIRS) showed that 88% hydrolyzed PVA adsorbed more strongly than 100% hydrolyzed one on the oxygen plasma-pretreated PDMS surface, and they all had little adsorption on original PDMS surface. Repeating the coating procedure three times was found to produce the most robust and effective coating. PVA coating converted the original PDMS surface from a hydrophobic one into a hydrophilic surface, and suppressed electroosmotic flow (EOF) in the range of pH 3-11. More than 1,000,000 plates/m and baseline resolution were obtained for separation of fluorescently labeled basic proteins (lysozyme, ribonuclease B). Fluorescently labeled acidic proteins (bovine serum albumin, beta-lactoglobulin) and fragments of dsDNA phiX174 RF/HaeIII were also separated satisfactorily in the three-layer 88% PVA-coated PDMS microchip. Good separation of basic proteins was obtained for about 70 consecutive runs.     

A Density Functional Theory Study on Electronic Structure and Second—order Nonlinear Optical Properties of Some Push—Pull Molecules

Time-dependent density-functional theory(TDDFT)has been applied to calculate the electronic structure and second-order nonlinear optical(NLO) properties of some organic molecules.The two-dimensional(2-D)charge transfer charateristics of calculated molecules were studied and compared with corresponding experimental results.All the theoretical results agree well with the measurement.For 2-D molecule with two-fold symmetry,the dominant charge transfer is off-diagonal,while for three-fold symmetry 2-D molecule,the dominant charge transfer is not only between branches and central group but also among branches.     

Instrumental neutron activation analysis of large samples: A pilot experiment

A large sample INAA (LS-INAA) was conducted based on available experimental conditions. Four different materials, e.g., a quartz-sand and three wastes from an incineration plant were analyzed on sample size of 1 kg. The neutron flux spatial distribution was determined by irradiation of flux monitors in the sample. The gamma-ray apparent counting efficiency was evaluated based on the effective-solid angle concept, using linear attenuation coefficients calculated from an iteration process. The k ₀- and the modified monostandard methods were modified for the LS-INAA. To check the LS-INAA performance, a conventional small sample INAA was carried out for the quartz sand and a waste. All detected elements in the LS-INAA are presented and the discussion is conducted to explore the sources of errors in the LS-INAA. As a pilot experiment, the information from this work will be used in constructing irradiation and counting devices for the new FRM-II neutron source in Garching, Germany.     

基质辅助激光解吸附飞行时间质谱分析缩合单宁的阳离子化问题

以单价金属离子Cs 和Na 作为离子化试剂,对3种缩合单宁进行基质辅助激光解吸附飞行时间(MALD I-TOF)质谱分析。加入Na 作为阳离子化试剂,能得到较高质量的质谱图。但由于实验通道中几乎不可能完全去除的K 的干扰而会高估棓儿茶酚/表棓儿茶酚单元的组成比例,从而影响对棓儿茶酚/表棓儿茶酚单元存在与否的判断;选择Cs 作为阳离子化试剂可以避免此问题,但在复杂的缩合单宁分析中,同样因为杂质离子Na 和K 的干扰而使得质谱图变得更复杂;未去离子处理直接对缩合单宁进行MALD I-TOF质谱分析与去离子并加入Cs 的处理比去离子并加入Na 能检测到更高聚合度的高聚物,检测到离子峰强度最高的聚合物随离子不同而不同。     

Rapid separation and laser-induced fluorescence detection of mutated DNA by capillary electrophoresis in a self-coating, low-viscosity polymer matrix

The detection of point and other simple mutations in DNA is important for cancer research and diagnosis and other biological studies. Capillary electrophoresis has been successfully used for separating DNA fragments. However, a low-viscosity polymer sieving buffer for DNA separation with on-line coating has never been reported. In this paper, a new method using capillary electrophoresis with on-line coating and laser-induced fluorescence detection (CE-LIF) for screening for point or simple DNA mutations has been demonstrated. The method uses an on-line dynamic coating technique that increases capillary lifetime and analysis reproducibility, and employs a low-viscosity polymer solution, which allows the user to rinse the capillary rapidly and refill with polymer solution easily. Experiments proved that the additives in the separation buffer for on-line capillary coating do not affect the separation efficiency of the running buffer, and do not interfere with the formation of hydrogen-bonded network between boric acid, mannitol and hydroxypropylmethylcellulose polymers. The stability of the dynamically coated capillary was quantitatively studied; the capillary lifetime was increased 6- to 7-fold compared with that of permanently coated CE columns. Standard DNA fragments containing mutations, with sizes of 209, 219, and 338 bps, were successfully separated and detected with this system, after the mutated DNA fragments were cleaved by CEL-I endonuclease. The technique is very sensitive for the size-separation of low-range, middle-range, and high-range DNA fragments. Results were compared with the HPLC methods developed by Transgenomic, Inc. and were in good agreement. The method should be applicable to mutation detection for all relevant biological and clinical studies. The factors influencing separations and the stability of dynamic capillary coatings are also discussed in the paper.     

Synthesis and structures of 5-(pyridyl)tetrazole complexes of Mn(II)

New Mn(II) complexes containing 5-(2-pyridyl)tetrazole, 5-(3-cyano-4-pyridyl)tetrazole or 5-(4-pyridyl)tetrazole ligands are described. The complexes are prepared by reaction of the corresponding cyanopyridines with sodium azide in the presence of Mn(II) salts. All the complexes have been characterized by X-ray crystallography, which reveals that 5-(pyridyl)tetrazole ligands can coordinate to Mn through either type of nitrogen atom in the tetrazole residue or via the pyridyl group. In the solid state, extended 2D and 3D structures are produced through networks of hydrogen bonding (involving water molecules and the tetrazolate residue). Acidification of the complexes produces the corresponding free 5-(pyridyl)-1H-tetrazole.     

Preparation and characterization of lithium ion-conducting glass-ceramics in the Li1 + xCrxGe2 − x(PO4)3 system

Li₂O–Cr₂O₃–GeO₂–P₂O₅ based glasses were synthesized by a conventional melt-quenching method and successfully converted into glass-ceramics through heat treatment. Experimental results of DTA, XRD, ac impedance techniques and FESEM indicated that Li_1.4Cr_0.4Ge_1.6(PO₄)₃ glass-ceramics treated at 900 °C for 12 h in the Li_1 + xCr_xGe_2 − x(PO₄)₃ (x = 0–0.8) system exhibited the best glass stability against crystallization and the highest ambient conductivity value of 6.81 × 10⁻⁴ S/cm with an activation energy as low as 26.9 kJ/mol. In addition, the Li_1.4Cr_0.4Ge_1.6(PO₄)₃ glass-ceramics displayed good chemical stability against lithium metal at room temperature. The good thermal and chemical stability, excellent conducting property, easy preparation and low cost make it promising to be used as solid-state electrolytes for all-solid-state lithium batteries.     

Formation of MoS2 inorganic fullerenes (IFs) by the reaction of MoO3 nanobelts and S

The reaction of MoO3 and S at temperatures higher than 300 degrees C in an argon atmosphere provides a convenient and effective method for the synthesis of MoS2 nanocrystalline substances. MoS2 nanotubes and fullerene-like nanoparticles have been obtained by the reaction at 850 degrees C under well-controlled conditions. The influences of reaction temperature and duration were carefully investigated in this paper. All of the nanostructures were characterized by Xray powder diffraction (XRD), transmission electron microscopy (TEM), and high-resolution transmission electron microscopy (HRTEM). A stepwise reaction model and rolling mechanism were proposed based on the experimental results.