Numerical simulation of atomic diffraction in the Raman-Nath regime

The theory of atomic diffraction from a classical standing wave light field in the presence of spontaneous emission in the Raman-Nath regime was developed by Tanguy et al. [6]. We describe the basis of computationally efficient methods for performing calculations in this regime and show their agreement with recent experimental results of Gould et al. [4].     

等离子体全息干涉条纹的数据处理

本文介绍了用全息干涉法诊断爆炸丝等离子体的数据处理方法。在考虑等离子体区域为轴对称的情况下,给出了由折射率计算等离子体电子密度的计算公式。在爆炸丝能量为9.6J的情况下,拍摄到了延时3μs的爆炸丝等离子体干涉图。运用计算机图象处理技术对反拍后的干涉图进行了处理,获得了较为理想的干涉图。用微机控制的线阵CCD摄像机判读了干涉条纹漂移。给出了等离子体密度随径向分布的曲线,并得到相应的等离子体密度在中心处约为10¹⁶个/cm³。     

宽波段连续调谐全固态CW PPMgLN光学参量振荡器

利用半导体激光泵浦输出1064 nm波长的全固态连续Nd:YVO4激光器作为泵浦源,采用周期调谐和温度调谐组合调谐技术,对基于掺氧化镁周期性极化铌酸锂晶体（MgO:LiNbO3, PPMgLN）准相位匹配（QPM）的全固态连续波（CW）光学参量振荡器（OPO）宽波段无分立连续调谐输出特性进行研究。实验采用连续工作模式和外腔结构,基于多周期PPMgLN晶体的30.2,30.4和30.6 m周期,在改变晶体的极化周期的基础上,同时在30～100 ℃范围内调节晶体工作温度。实验结果表明:CW PPMgLN OPO的泵浦阈值仅为0.22 W;不同极化周期需要的温度调谐范围不同;信号光在1 559.8～1 597.2 nm近红外波段和闲频光在3 187.3~3 347.3 nm中红外波段连续调谐输出。实现了外腔式全固态CW OPO在信号光和闲频光波段的无分立连续调谐输出。     

Stable single longitudinal mode erbium-doped silica fiber laser based on an asymmetric linear three-cavity structure

We present a stable linear-cavity single longitudinal mode (SLM) erbium-doped silica fiber laser. It consists of four fiber Bragg gratings (FBGs) directly written in a section of photosensitive erbium-doped fiber (EDF) to form an asymmetric three-cavity structure. The stable SLM operation at a wavelength of 1545.112 nm with a 3-dB bandwidth of 0.012 nm and an optical signal-to-noise ratio (OSNR) of about 60 dB is verified experimentally. Under laboratory conditions, the performance of a power fluctuation of less than 0.05 dB observed from the power meter for 6 h and a wavelength variation of less than 0.01 nm obtained from the optical spectrum analyzer (OSA) for about 1.5 h are demonstrated. The gain fiber length is no longer limited to only several centimeters for SLM operation because of the excellent mode-selecting ability of the asymmetric three-cavity structure. The proposed scheme provides a simple and cost-effective approach to realizing a stable SLM fiber laser.     

非线性介质中强光对弱光聚焦的控制研究

从理论和实验上分析了强光控制弱光脉冲聚焦的方法, 该方法可以灵活地控制弱光的聚焦过程和特性. 通过研究两光束共同传输, 利用强抽运光在相互作用时为弱探测光提供诱导非线性效应, 从而使弱探测光发生聚焦. 得到了在抽运光保持不变情况下探测光的解析解, 并在实验上得到验证. 进一步研究了强抽运光对弱探测光焦点位置的影响. 结果显示: 通过改变抽运光功率、束宽能够有效地控制弱探测光的聚焦过程和焦点位置. 关键词： 诱导聚焦 自聚焦 非线性折射率     

Experimental study of the temperature and electron-irradiation effect on erbium-doped fiber amplifiers

We study the influence of temperature on the gain of 980 nm pumped erbium-doped fiber amplifier (EDFA) before and after the electron irradiation. Our experimental results indicate that in the irradiation process the EDFA gain at low temperatures is less than that at high temperatures, but after 7 days recovery, the EDFA gain at low temperatures is significantly higher than that at high temperatures. After 200 krad electron irradiation, the EDFA gain is more sensitive to temperature as compared to non-irradiated one.     

Quantum Memory with Natural Inhomogeneous Broadening in an Optical Cavity

We propose an efficient quantum memory scheme with natural inhomogeneous broadening in an asymmetric optical cavity. The scheme uses the strong rephasing pulses like traditional photon echo techniques rather than spectral holeburning, which enables us to have the potential implementation in a much broader range of material systems. In the condition of impedance matching to an optical cavity, we find that the input light pulse can be completely absorbed by an atomic ensemble. We also show that the quantum memory efficiency can be equal to unity even for a small optical depth of the atomic system.     

Laser drilling of thick material using femtosecond pulse with a focus of dual-frequency beam

Laser drilling is one of the basic, most frequently performed, material removal processes. The drilling aspect ratio is theoretically limited by the size and the focal depth of the machining laser spot. The aspect ratio can be improved by using dual focus. In this paper we describe a focus of two different frequencies based on the longitudinal chromatic aberration arisen when polychromatic collimated light is incident on a positive lens element. In the experiments, a Ti:Sapphire laser of 800 nm wavelength and 150 fs pulse duration was used as a source. Two tightly focused laser spots few hundred micrometers apart from each other were formed by focusing a combined collimated laser beam which contains the fundamental optic frequency and the second harmonic optic frequency. The focus of dual-frequency beam was used to drill a 3 mm thick PMMA plate. The drilling aspect ratio of a dual-frequency beam was compared to that of a focus of single frequency beam. Experimental results reveal that dual-frequency beam increases the aspect ratio and improves the drilling quality in terms of profile of the produced features.     

F-P半导体激光器实现多波长注入锁定

F-P半导体激光器中对于TE模比TM模有更大的束缚系数,并且在其反射面上有更高的反射率.当TE模和TM模同时注入F-P半导体激光器的谐振腔时,TE模方向的信号得到增长,TM模方向的信号受到抑制.F-P半导体激光器的这种特性使得它类似于一个偏振器,但是其优越之处在于经过F-P半导体激光器注入锁定之后的光信号没有功率损耗.采用F-P半导体激光器的注入锁定原理,使入射光信号没有功率损耗地由偏振光转换为部分偏振光,降低了通信系统中传输信号的偏振敏感性,使传输信号的质量得到提高,实现了F-P半导体激光器三波长和四波长注入锁定.     

An approach to achieve lateral superresolution for small probe confocal measurement system and its element

A shaped annular beam superresolution approach is proposed to improve a lateral resolution of a small probe laser confocal measurement system (LCMS). The approach proposed enables lateral superresolution measurement of LCMS to be achieved by using a binary optical diffractive element to shape a He–Ne Gaussian laser beam into an annular beam with an inner diameter of 0.87 mm and an outer diameter of 1.8 mm required for superresolution measurement, and shift the beam spatial frequency from low to high. And a binary optical element (BOE) with 16 phase levels is designed and fabricated to shape a Gaussian laser beam into an annular beam. Preliminary experimental results indicate that an intensity distribution of a shaped annular beam is in agreement with simulation results, the diffractive efficiency is 87.2%; LCMS lateral and axial resolutions of 0.2 μm and 3 nm are achieved, respectively, and its measurement range is expanded nearly to double, when BOE is used in LCMS and , NA=0.85.