Comparative Study of Tribological Properties of Polyphenylene Sulfide (PPS), Polyethersulfone (PES), and Polysulfone (PSU)

The tribological properties of polyphenylene sulfide (PPS), polyethersulfone (PES) and polysulfone (PSU), which have similar molecular structures, were investigated using an end-face contact tribometer and a reciprocating tribometer. The thermomechanical behavior of the polymers was analyzed using dynamic mechanical analysis (DMA). PPS exhibited a maximum friction coefficient with increasing load and sliding speed, while the friction coefficients of PES and PSU decreased only slightly. The wear rate of PPS was much lower than that of PES and PSU under high loads and speeds. It is suggested that the main factors influencing the friction and wear properties of the neat polymers are their condensed state and heat resistance. Amorphous PES and PSU showed liquid-like behavior and very low friction when the frictional surface was in the molten-flow state. The macromolecular crystals of crystallizable PPS give it some solid-like behavior and load-carrying capacity; hence PPS exhibited lower wear than PES and PSU.     

Reduced field-of-view diffusion-weighted imaging of the brain at 7 T

Ventral and rostral regions of the brain are of emerging importance for the MRI characterization of early dementia, traumatic brain injury and epilepsy. Unfortunately, standard single-shot echo planar diffusion-weighted imaging of these regions at high fields is contaminated by severe imaging artifacts in the vicinity of air–tissue interfaces. To mitigate these artifacts and improve visualization of the temporal and frontal lobes at 7 T, we applied a reduced field-of-view strategy, enabled by outer volume suppression (OVS) with novel quadratic phase radiofrequency (RF) pulses, combined with partial Fourier and parallel imaging methods. The new acquisition greatly reduced the level of artifacts in six human subjects (including four patients with early symptoms of dementia).     

High performance 1689-nm quantum well diode lasers

1689-nm diode lasers used in medical apparatus have been fabricated and characterized. The lasers had pnpn InP current confinement structure, and the active region consisted of 5 pairs of InGaAs quantum wells and InGaAsP barriers.     

On characteristics of sheath damping near a dielectric wall with secondary electron emission

A preliminary investigation is conducted to study the characteristics of sheath damping near a dielectric wall with secondary electron emission (SEE). Making use of the linear analysis of the sheath stability, we have found two major contributions to the sheath damping, one similar to the Landau damping in uniform plasmas and another determined by local electric field and electron density of the steady-state sheath. It indicates that in a classical sheath regime the damping in the sheath region monotonically increases towards the wall and decreases with the enhancement of SEE effect. In order to verify the theoretical analysis, sheath oscillation processes induced by an initial disturbance are simulated with a time-dependent one-dimensional (1D) sheath model. Numerical results obtained are consistent with the theoretical analysis qualitatively.     

X射线荧光光谱研究粮食中生命有机碳与碳化学循环

采用X射线荧光光谱(XRF)方法测定六种粮食:稻谷(大米)、小麦(面粉)、黄豆、小米、高粱和玉米中生命有机碳含量和化学元素组成,建立一种新方法测定它们的蛋白质含量.粮食中生命有机碳平均含量约为44%.黄豆中的蛋白质含量最高(42.74%),小米蛋白质含量28.56%,麦子蛋白质含量27.57%,玉米蛋白质含量24.99...     

γ-MnO2/polyaniline composites: Preparation, characterization, and applications in microwave absorption

MnO₂/doped polyaniline (PANI) is prepared by an in situ polymerization method using γ-MnO₂ as the addition agent and hydrochloric acid as the doping agent. Products are characterized by FT-IR, UV-vis, XRD, and TEM. Conductivity, electromagnetic properties, and microwave absorption properties are first discussed on the basis of structural characterization. The as-prepared products of MnO₂/PANI are partially crystalline in nature and spherical in pattern with grain sizes of 50-70 nm. MnO₂ particles are successfully decorated with doped PANI. MnO₂/PANI displays moderate electric conduction, excellent dielectric losses, and microwave absorption capabilities. Compared to pure MnO₂, the dielectric and reflection loss properties of MnO₂/PANI composites exhibit significant improvements, with an effective absorption band at 5 GHz under −10 dB and maximum reflection loss of −21 dB at 13.56 GHz. Pure MnO₂ shows an effective absorption band of 3 GHz under −10 dB and a maximum reflection loss of −14.20 dB at 11.5 GHz. Thus, MnO₂/PANI composites are found to be a promising microwave absorption material.     

基于折反射原理的层去反求技术研究

为了克服传统层去反求测量中图像衬比度较低的缺陷,提出一种新的基于棱镜反射原理的层去反求图像摄取方法。该方法利用棱镜的全发射和折射作用提高图像衬比度,根据物体反射率的高低可分别采用垂直照明和倾斜照明,分别可获得高衬比度的亮目标暗背景和暗目标亮背景图像,为了校正由于折反射引入的几何变形,推出了相应的数学变换模型。该研究已成功投入实际产品校正的应用中,研究表明这种新的层去法比起传统的层去法不仅在于图像衬比度高,而且物体截面图像的轮廓更清晰可靠、无需填充反差材料,有望在零件及模型的反求测量中发挥较大的作用。