Synthesis,photophysical and electrochemical studies of di-2-pyridyl ketone complexes of rhodium(III)

Complexes of rhodium(III) with di-2-pyridyl ketone (dpk), Rh(dpk)(MeCN)Cl₃ (1) and cis-[Rh(dpk)₂Cl₂]⁺ (2), have been successfully prepared and characterized. At low temperature (77 K), complex (2) in EtOH/MeOH (4:1, v/v) shows a broad, symmetric and structureless red emission with a microsecond lifetime and, hence, is assigned as the dd* phosphorescence. Electrochemical data, including cyclic voltammetry, normal pulse voltammetry, triple pulse voltammetry and controlled potential electrolysis, have been obtained for the two dpk complexes of rhodium(III) in MeCN. On the basis of analysis of the electrochemical (1,2) and luminescence data (2), electron transfer mechanisms are proposed. For complex (1), two reduction processes occur at the metal-localized orbitals with elimination of chlorides during the first reduction step. This is followed by a one-electron reduction at the metal. For complex (2), three electrons are transferred to the metal in two successive reduction steps accompanied by elimination of two chlorides. After these two reduction steps another one-electron reduction occurs at the dpk ligand.     

Comparison of the volatile constituents of Artemisia capillaris from different locations by gas chromatography-mass spectrometry and projection method

The volatile chemical constituents of Artemisia capillaries (an important traditional Chinese medicine) were determined by gas chromatography-mass spectrometry (GC-MS) and sub-window factor analysis (SFA). Seventy-five components were separated and 43 of them were qualitatively and quantitatively determined, which represented about 89.03% of the total content. This profile was then used to identify and assess the consistency of the herb by using an orthogonal projection method. Four different sources of A. capillaries were analyzed and compared with each other. Among the components determined, there were 51 components coexisting in all samples although the relative peak areas of a few showed variations. It is the first time to apply orthogonal projection method to the comparison of different samples, and it reduces the burden of qualitative analysis as well as the subjectivity. The results showed a fair consistency in their GC-MS fingerprint. A. capillaris was distinguished from Artemisia sacrorum L., a possible substitute in traditional Chinese medicine by comparing the fingerprints with each other.     

Synthesis of 7,9-dideoxybaccatin IV analogs from sinenxan A

Sinenxan A, a taxoid isolated from callus tissue cultures of Taxus yunnanensis was converted into 13-oxo-7,9-dideoxy-2-debenzoyl-2-acetyl-baccatin IV and 7,9-dideoxy-2-debenzoyl-4-deacetyl-baccatin IV, a key framework of 1,7,9-trideoxypaclitaxel. Several special steps in this transformation are worthy of note: (1) deoxygenation by treatment with hypophosphorous acid at C-14 position; (2) a highly regioselective O-deacetylation of taxanes at C-5 position; and (3) stereoselective reduction of the 13-carbonyl group by transannular assistance from the C-4-hydroxyl.     

On the photoreactivity of diacetylene containing thermoplastic block copolymers

A group of block copolymers containing diacetylenes as chain extenders in their hard segments was prepared, based on urethanes, esters, ureas, and amides as hard segments and polybutadienes, polyethers, polyesters, and polysiloxanes as soft segments. Almost all block copolymers were photoreactive, but there was a wide range of sensitivities. The photoreactivity of the copolymers was found to depend on the reactivity of the monomer unit, on the width of the diacetylene stacks in the hard segments, and on the degree of phase separation in the solid films. To explore the range of monomer reactivities we prepared 15 crystalline monomers. Urethanes were in general the most reactive, and this was attributed in part to the specific effect of hydrogen bonding which brings about a shortening of the C₁ to C₄ distance between diacetylenes tend to reduce the photoreactivity. The behavior of identical diacetylene units in the monomer crystal, in the homopolymer, and in the block copolymer is discussed in this paper.     

Fuzzy Symmetries for Linear Molecules and their Molecular Orbitals

In this paper, the fuzzy symmetry of some prototypical linear molecules has been analyzed. The results show that some molecular orbitals (MOs) are less symmetrical but some others are more symmetrical than the molecular skeleton, which the MOs correspond to. The membership functions of space inversion for MOs are closely related to the chemical characteristics of the MOs. Sometimes, although the symmetry of a molecular skeleton is not obvious, however that of some MO is quite obvious. The membership functions of the fuzzy inversion symmetry depend on the choice of the position of the center of inversion. As compared to those of diatomic molecules and linear tri-atomic molecules, the linear polyatomic molecules in which a distinctive fuzzy symmetry of space translation may exist, and thus a significant effect on their properties can be expected.     

利用高炉水淬渣制备(Ca/Y)-α-Sialon陶瓷的组织与性能

以高炉水淬渣合成的Ca-α-Sialon粉体为原料采用无压烧结技术制备了（Ca/Y）-α-Sialon陶瓷。通过用排水法、三点弯曲实验法、金相显微镜法、XRD法等手段研究了（Ca/Y）-α-Sialon陶瓷的烧结致密化过程、材料的力学性能、显微组织、相组成和材料的断裂特征。结果表明,适量的Y2O3促进材料的烧结致密化和提高材料的力学性能,但Y2O3过量（大于10%）时对材料的烧结和力学性能不利。掺杂Y^3＋的（Ca/Y）-α-Sialon呈柱状晶,随着Y2O3含量的增加和烧结温度的提高,（Ca/Y）-α-Sialon呈柱状晶出现粗化和等轴化。含10%Y2O3的材料在1700℃烧结时可获得较高的力学性能。     

水相锌二次电池正极材料V2O5/C的电化学性能研究

采用溶胶－凝胶法合成了一种V₂O₅/C复合材料.扫描电镜（SEM）和红外光谱（FTIR）分析表明,这是一种外层V₂O₅胶体包覆内层乙炔分子的多孔复合材料.以V₂O₅/C作正极,锌片为负极,Zn(ClO₄)₂溶液为电解质组成水相锌二次电池,采用循环伏安（CV）和电化学阻抗谱（EIS）等方法研究发现:V₂O₅:C质量比为1:1时电极具有最好的电化学性能,电池开路电压达1.64 V; Zn^2＋能分别在1.01 V和1.26 V处分步嵌入V₂O₅/C结构中A、B两种位置,其嵌入电流密度峰值最高可达70 mA•g^－1,并且具有较好的循环充放电性能;在一定放电深度下,V₂O₅/C电极反应速率受Zn^2＋的扩散过程控制.     

INTROMISSION OF WATER-REPELLENT AND HYDROSCOPIC PROPERTIES SIMULTANEOUSLY TO PP BY PLASMA DISCHARGE METHOD

Plasma-induced surface graft copolymerization of acrylic acid on polypropylene non-woven fabric (PP-g-AA) and polypropylene membrane were reported. The extents of grafting were controlled by the plasma and polymerization condition. Hexadecyltrimethyl ammonium bromide was then coupled with the carboxyl group of PP-g-AA to obtain a polyion complex (PIC). At last, CF4 plasma was used to give PICs hydrophobic property. The moisture regain and water-repellency of the processed PICs was investigated. The surfaces were characterized using ATR FT-IR and XPS. The result indicates that the products have very high ability to adsorb moisture, even better than cotton fiber. At the same time, the products show excellent hydrophobic property, which can‘t be wetted by those reagents whose surface tensions were higher than 327mN/m.     

A Home-made Simple Set-up for Measurement of Electrochemical Surface Tension Spectrum on a Mercury Drop Electrode

A setup for recording surface tension curves at a mercury drop during potential scanning is designed based on photo-sensitive detection system. Surface tension spectrum at Hg drop can be recorded by voltammetric study. A Yb(III)-NO2- catalytic reduction system was used for characterization. The simple, sensitive technique can be expected to provide fresh information on molecular interactions at electrode surfaces.