用于诊断纳秒脉冲电流的微分环现场标定技术

分析了用于纳秒脉冲电流测量的微分环标定难点,提出微分环现场标定方法。通过脉冲形成线脉冲充电以解决微分环标定中信噪比较低、可信度较差等问题;分析了脉冲形成线充电时间、充电电压及脉冲形成开关击穿电压等回路参数对标定结果的影响。基于闪光二号加速器,对测量二极管电流的微分环进行了现场标定,前级隔离开关平均击穿电压为25 kV时,微分环标定回路电流达到1.3 kA,微分环灵敏度为9.311010,方差为0.151010。     

超声波法提取啤酒花中总多糖的工艺

采用超声波法提取啤酒花中总多糖.采用正交试验设计,以总多糖含量为评价指标进行实验.最佳提取工艺为:超声提取2次,加12倍量的水,每次40min,超声功率为160W.本提取工艺合理,啤酒花中总多糖提取率较高.     

积分球内的铷原子激光冷却

研究了积分球内激光冷却原理,设计积分球时对积分球的反射率、尺寸及球上开孔大小对于激光冷却的影响进行了讨论. 进行了积分球冷却⁸⁷Rb实验,实验结果表明积分球有效的冷却了球腔中的铷原子,获得了积分球内冷原子的吸收信号以及冷原子随冷却光失谐的变化曲线. 关键词： 漫反射光场 积分球 全光冷却     

Implementation of a novel two-attractor grid multi-scroll chaotic system

This paper proposed a method of generating two attractors in a novel grid multi-scroll chaotic system.Based on a newly generated three-dimensional system,a two-attractor grid multi-scroll attractor system can be generated by adding two triangular waves and a sign function.Some basic dynamical properties,such as equilibrium points,bifurcations,and phase diagrams,were studied.Furthermore,the system was experimentally confirmed by an electronic circuit.The circuit simulation results and numerical simulation results verified the feasibility of this method.     

Interaction behaviours of solitoffs: fission, fusion, reconnection and annihilation

The interactions between solitoffs are extensively investigated. Besides the known solitoff fission and fusion interactions, two new types of solitoff interactions are discovered, named the solitoff reconnection and the solitoff annihilation. Taking the asymmetric Nizhnik--Novikov--Veselov equation as an illustrative system, five types of solitoff interactions are graphically revealed on the basis of the analytical solution obtained by the modified tanh function expansion method.     

Simple dose rate measurements for a very high synchrotron X‐ray flux

Dose measurements based on methylene blue (MB) bleaching, widely used for ultraviolet light, can also be applied to X‐rays including very high flux levels. This method has been tested by using both MB bleaching and Fricke dosimetry for a conventional monochromatic X‐ray source and then for `white‐beam' synchrotron radiation. The results show that MB bleaching dosimetry can easily measure X‐ray doses up to at least 10⁵ Gy s^?1, as long as the MB concentration is sufficiently high. This condition can be verified from the deviations from linearity of the bleaching versus exposure time.     

基于跳距修正L-M优化的WSN定位算法

针对DV-Hop定位算法在节点随机分布的网络拓扑环境下存在误差较大的问题,文中通过分析平均跳距估计、未知节点坐标估计区域求解对定位精度的影响,提出了一种基于跳距修正L-M优化的WSN定位算法CLDV-Hop(Correct L-M DV-Hop)。仿真结果表明,在不增加额外开销且仿真环境相同的条件下,CLDV-Hop算法比现有改进的算法具有更高的定位精度,与DV-Hop算法相比精度提高了约33%——41%。     

Luminescent properties of Sr5(PO4)3 Cl:Eu2+, Mn2+ as?a?potential phosphor for UV-LED-based white LEDs

Eu²⁺ and Mn²⁺ co-activated Sr₅(PO₄)₃Cl phosphors with blue and orange color double emission bands, under a broad-band excitation wavelength range of 340–400 nm, were synthesized by the solid-state reaction. It was found that the processing parameters, including the fluxes, annealing time and activators concentrations, affect the emission intensity and other luminescent properties. Energy transfer between Eu²⁺ and Mn²⁺ was discovered and the transfer efficiency was also estimated based on relative intensities of Eu²⁺ and Mn²⁺ emission. Thus the relative strength of blue and orange emission intensities could be tuned by varying the relative concentration of Eu²⁺ and Mn²⁺. Since the photoluminescence excitation spectra of the newly developed Sr₅(PO₄)₃Cl:Eu²⁺, Mn²⁺ phosphors exhibit a strong absorption in the range of 340–400 nm, they are promising for producing UV-LED-based white LEDs.     

基于粪便可见-近红外反射光谱的高山麝慢性肠炎诊断

提出了一种利用粪便可见-近红外反射光谱进行高山麝慢性肠炎诊断的新方法。以FieldSpec？3地物光谱仪采集了125份高山麝粪便（正常粪样70份,慢性肠炎患者粪样55份）的光谱数据,将其随机分成训练集（95份）和检验集（30份）。光谱经S.Golay平滑与一阶导数处理后以主成分分析法（PCA）降维。以前6个主成分（含原始光谱95.16%的特征信息）作为新变量,利用训练集样本,分别以模糊模式识别、BP-神经网络、Fisher线性判别以及Bayes逐步判别四种方法建立高山麝慢性肠炎的诊断模型。对检验集30个未知样的预测表明,Fisher线性判别的准确率为86.7%,模糊模式识别与BP-神经网络模型判别的准确率为90%,Bayes逐步判别的准确率最高,达93.3%。进一步分析发现所有误诊都源于将正常样误判为病样,四种方法对病样的检出率均达100%。说明利用粪便的可见-近红外反射光谱进行高山麝慢性肠炎的快速、非接触性诊断是可行的,且PCA 结合Bayes逐步判别是一种优选方法。     

立式螺旋管汽液两相流沸腾传热恶化实验研究

本文实验研究了低质量流速(500～800 kg·m~(-2)·s~(-1))下的立式螺旋管临界热负荷,对沸腾传热恶化壁温特性和螺旋管临界热负荷影响因素进行分析.并同前人工作汇总,以流量,压力和临界干度为参数,建立了基于局部条件假设的立式螺旋管临界热负荷查询表(Look-Up-Table),共272个点.压力范围6.5～21 MPa,质量流速范围500～1800 kg·m~(-2)·s~(-1).