An optical bridge reflectometer for sensitive measurement of ion implantation dose

An instrument is described that can be used to monitor, with unprecedented sensitivity, changes in the optical reflectivity due to crystailine damage incurred during ion implantation. It is shown that at the shot-noise limit, changes in the optical reflectivity of silicon as small as 5·10^–7 can be measured in a 10 Hz bandwidth with a signal-to-noise ratio of 100, corresponding to an extrapolated uniform implantation dose of 5·10⁸ cm^–2 for ¹¹B⁺ at 50 keV in silicon.     

Quantum wire heterostructure for optoelectronic applications

Quantum wire (QWR) heterostructures suitable for optoelectronic applications should meet a number of requirements, including defect free interfaces, large subband separation, long carrier lifetime, efficient carrier capture. The structural and opticl properties of GaAs/AlGaAs and InGaAs/GaAs quantum wire (QWR) heterostructures grown by organometallic chemical vapor deposition on nonplanr substrates, which satisfy many of these criteria, are described. These crescent-shaped QWRs are formed in situ during epitaxial growth resulting in virtually defect free interfaces. Effective wire widths as small as 10nm have been achieved, corresponding to electron subband separations greater than K_BT at room temperature. The enhanced density of states at the QWR subbands manifests itself in higher optical absorption and emission as visualized in photoluminescence (PL), PL excitation, amplified spontaneous emission and lasing spectra of these structures. Effective carrier capture into the wires via connected quantum well regions, which is important for enhancing the otherwise extremely small capture cross section of these wires, has also been observed. Room temperature operation of GaAs/AlGaAs and strained InGaAs/GaAs QWR lasers with threshold currents as low as 0.6mA has been demonstrated.     

Supersymmetric Dirichlet operators

A canonical supersymmetric extension of classical Dirichlet forms and operators given by measures on linear spaces is considered. In the case of log-concave measures, the supersymmetric Dirichlet operator generates a hypercontractive semigroup. This setting is appropriate for infinite-dimensional geometry and quantum field theory.Dedicated to Yu. M. Berezanskii on the occasion of his seventieth birthdayPublished in Ukrainskii Matematicheskii Zhurnal, Vol. 47, No. 5, pp. 583–592, May, 1995.The present work was supported by the DFG.     

Thermal Equilibrium Between Radiation and Matter

In 1916, Einstein rederived the blackbody radiation law of Planck that originated the idea of quantized energy one hundred years ago. For this purpose, Einstein introduced the concept of transition probability, which had a profound influence on the development of quantum theory. In this article, we adopt Einstein's assumptions with two exceptions and seek the statistical condition for the thermal equilibrium of matter without referring to the inner details of either statistical thermodynamics or quantum theory. It is shown that the conditions of thermodynamic equilibrium of electromagnetic radiation and the energy balance of thermal radiation by the matter, between any of its two energy-states, not only result in Planck's radiation law and the Bohr frequency condition, but they remarkably yield the law of the statistical thermal equilibrium of matter: the Maxwell–Boltzmann distribution. Since the transition probabilities of the modern quantum theory of radiation coincide with their definition in Einstein's theory of blackbody radiation, the presented deduction of the Maxwell–Boltzmann distribution is equally valid within the bounds of modern quantum theory. Consequently, within the framework of the fundamental assumptions, the Maxwell–Boltzmann distribution of energy-states is not only a sufficient, but a necessary condition for thermal equilibrium between the matter and radiation.     

Investigation of anode and cathode jets influence on electric arc properties with current up to 500 kA

A number of phenomena connected with the formation of electrode jets in discharges in hydrogen at a current of 10/sup 5/-10/sup 6/ A, a current growth rate of 10/sup 10/ A/s, an initial pressure 0.1-4.0 MPa, and a discharge gap length of 5-40 mm were studied. After the secondary breakdown, the jets are observed through a discharge semitransparent channel, widening with velocity (4-7) /spl middot/ 10/sup 2/ m/s. Shockwave formation was detected at the interaction of jets with the surrounding gas and the opposite electrode. Plasma vapor pressure of metal near the end of the tungsten cathode 70 /spl mu/s after initiation of a discharge was 180 MPa. Thus, magnitude of brightness temperature was 59 /spl middot/ 10/sup 3/ K, with an average charge of ions-m~=3.1, and a concentration of metal vapors n=5.3/spl middot/10/sup 19/ cm/sup -3/. While those at the end of the anode 90 /spl mu/s after initiation of discharge: m~=2.6, n=7.4/spl middot/10/sup 19/ cm/sup -3/. Probable reasons of high-voltage drops near the electrodes (the summarized magnitude of which is /spl sim/1 kV) are discussed on the basis of experimental data. For the first time, the shadow method registered symmetric ejection of material from the all-cathode surface the maximum discharge current was observed.     

Use of anion-exchange high-performance liquid chromatography for the study of smooth muscle myosin light-chain kinase and its catalytic domain

Avian myosin light-chain kinase from smooth muscle of the gizzard and its catalytic domain, derived from the intact enzyme by trypsin digestion, was purified within 30-40 min by both analytical and preparative anion-exchange high-performance liquid chromatography. The proteins obtained were more than 95% pure and retained their biological activity. The high-performance anion-exchange chromatography protocols represent a significant decrease in purification time when compared with conventional ion-exchange chromatography.     

Diffraction in a cylindrically orthotropic elastic solid containing a stress free crack

A cylindrically orthotropic elastic solid is excited by a point impulsive body force. The solid contains a semi-infinite stress free crack. The resulting anti-plane wave motion problem has been solved in the form of a finite series representing the incident and reflected pulses plus an integral representing the diffraction pulse. The series part of the solution has been previously treated. In the present investigation the diffraction integral is integrated when λ (which measures the anisotropy of the solid) is an odd integer number. The diffraction integral is also integrated when λ is half an odd integer, for the special case in which the source lies in the plane of the crack and parallel to the crack edge. The displacement jump across the circular diffraction wave front is given for unrestricted (positive) values of λ.     

A second order numerical scheme for the solution of the one-dimensional Boussinesq equation

A predictor–corrector (P-C) scheme is applied successfully to a nonlinear method arising from the use of rational approximants to the matrix-exponential term in a three-time level recurrence relation. The resulting nonlinear finite-difference scheme, which is analyzed for local truncation error and stability, is solved using a P-C scheme, in which the predictor and the corrector are explicit schemes of order 2. This scheme is accelerated by using a modification (MPC) in which the already evaluated values are used for the corrector. The behaviour of the P-C/MPC schemes is tested numerically on the Boussinesq equation already known from the bibliography free of boundary conditions. The numerical results are derived for both the bad and the good Boussinesq equation and conclusions from the relevant known results are derived.