Novel fixed‐site–carrier polyvinylamine membrane for carbon dioxide capture

Fixed‐site–carrier membranes were prepared for the facilitated transport of CO₂ by casting polyvinylamine (PVAm) on various supports, such as poly(ether sulfone) (PES), polyacrylonitrile (PAN), cellulose acetate (CA), and polysulfone (PSO). The cast PVAm on the support was crosslinked by various methods with glutaraldehyde, hydrochloric acid, sulfuric acid, and ammonium fluoride. Among the membranes tested, the PVAm cast on polysulfone and crosslinked by ammonium fluoride showed the highest selectivity of CO₂ over CH₄ (>1000). The permeance of CO₂ was then measured to be 0.014 m³ (STP)/(m² bar h) for a 20 μm thick membrane. The effect of the molecular weight of PVAm and feed pressure on the permeance was also investigated. The selectivity increased remarkably with increasing molecular weight and decreased slightly with increased pressure in the range of 1 to 4 bar. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4326–4336, 2004     

Pressure and temperature dependence of the gas‐transport properties of dense poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] membranes

The gas‐transport properties of poly[2,6‐toluene‐2,2‐bis(3,4‐dicarboxylphenyl)hexafluoropropane diimide] (6FDA‐2,6‐DAT) have been investigated. The sorption behavior of dense 6FDA‐2,6‐DAT membranes is well described by the dual‐mode sorption model and has certain relationships with the critical temperatures of the penetrants. The solubility coefficient decreases with an increase in either the pressure or temperature. The temperature dependence of the diffusivity coefficient increases with an increase in the penetrant size, as the order of the activation energy for the diffusion jump is CH₄ > N₂ > O₂ > CO₂. Also, the average diffusion coefficient increases with increasing pressure for all the gases tested. As a combined contribution from sorption and diffusion, permeability decreases with increases in the pressure and the kinetic diameter of the penetrant molecules. Even up to 32.7 atm, no plasticization phenomenon can be observed on flat dense 6FDA‐2,6‐DAT membranes from their permeability–pressure curves. However, just as for other gases, the absolute value of the heat of sorption of CO₂ decreases with increasing pressure at a low‐pressure range, but the trend changes when the feed pressure is greater than 10 atm. This implies that CO₂‐induced plasticization may occur and reduce the positive enthalpy required to create a site into which a penetrant can be sorbed. Therefore, a better diagnosis of the inherent threshold pressure for the plasticization of a glassy polymer membrane may involve examining the absolute value of the heat of sorption as a function of pressure and identifying the turning point at which the gradient of the absolute value of the heat of sorption against pressure turns from a negative value to a positive one. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 354–364, 2004     

Relationship between the dynamic softening transition and wet sliding friction of elastomer compounds

For properly chosen elastomer compounds, thermorheological characterization is combined with an examination of the variation of the wet sliding friction with temperature. A conceptual argument leads to the assumption that the wet sliding friction should maximize at the energy dissipation peak associated with the dynamic softening transition at a characteristic frequency determined by the sliding speed and the effective smallest surface asperity scale. The dynamic softening transition is characterized with the peak in tan δ/G′ⁿ, where tan δ is the loss tangent, G′ is the elastic modulus, and n is a constant between 0 and 1. The William–Landel–Ferry transform is uncritically applied for extrapolating the position of the peak in tan δ/G′ⁿ at high frequencies. Even based on the criterion of tan δ, the results obtained on a concrete surface indicate that the effective smallest asperity scale is of order of 100 μm. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2467–2478, 2004     

Differential scanning calorimetry and thermogravimetric analysis investigation of the thermal properties and degradation of some radiation‐grafted films and membranes

The influence of irradiation and grafting on the crystallinity of three base polymers has been investigated with differential scanning calorimetry. Grafting has the largest effect on the base polymer crystallinity and results in a reduction of the crystallinity. The thermal degradation of the base polymers and grafted films has been investigated with thermogravimetric analysis. The extent of the fluorination of the base polymer, the irradiation method, and the graft level all influence the thermal degradation and its activation energy. It is proposed that the variation of the chain lengths of the grafted polystyrene chains is actually a primary underlying factor responsible for the influence of these various parameters on the degradation process. The first results of a comparative thermal analysis of some fuel‐cell membranes are also presented, and the promise and shortcomings of this method are discussed. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2612–2624, 2004     

Concentrations of hazardous heavy metals in environmental samples collected in Xiamen, China, as determined by vapor generation non-dispersive atomic fluorescence spectrometry.

Non-dispersive atomic fluorescence spectrometry (NDAFS) coupled with vapor generation (VG) sample introduction was applied to the determination of the concentrations of hazardous heavy metals, such as arsenic, cadmium, lead and mercury, in seawater, soils and total airborne particulate matter (PM) collected around the Xiamen area in China. Almost 100% sample introduction efficiency was achieved by using thiourea and ascorbic acid for the pre-reduction of As(V) to As(III), K3Fe(CN)6 and tartaric acid for pre-oxidation of Pb(II) to Pb(IV), and masking the interferences arising from the co-existing transition metals to As, Cd, Hg and Pb during their vapor generation process. Moreover, a novel sample pretreatment device was developed to avoid the loss of mercury, lead, cadmium and arsenic during sample pretreatment. With such methods, the detection limit (DL) of arsenic, cadmium, lead and mercury was down to 0.08, 0.03, 0.05, 0.01 ng mL(-1) (3sigma), respectively. The relative standard deviations (RSD, n = 11) for arsenic, cadmium, lead and mercury at 10 ng mL(-1) were 0.9%, 1.6%, 1.3% and 2.0%, respectively. The concentrations of hazardous heavy metals in the environmental samples collected in Xiamen, China are in the range from 0.02 +/- 0.001 ng mL(-1) in seawater to 15.3 +/- 0.2 microg g(-1) in soils. Besides flame/GF-AAS and ICP-AES/MS, VG-NDAFS should be another choice for the determination of hazardous heavy metals in environmental samples.     

掺杂偶氮苯聚合物光致异构Z扫描测量及其理论解释

用He_Ne激光对掺有偶氮苯聚合物DR 13的PMMA薄膜样品进行Z扫描研究 ,发现其折射率改变量与光强的关系存在着饱和效应 ,且线偏振光引起的折射率改变明显大于圆偏振光引起的折射率改变 .对于这些现象 ,用光致异构的角烧孔机理进行解释     

Kirchhoff方程的相对常值特解及其Lyapunov稳定性

对于超细长弹性杆静力学的Kirchhoff方程，用动力学的概念和方法研究其常值特解 和稳定性问题.计算了Kirchhoff方程相对固定坐标系、截面主轴坐标系以及中心线Frenet 坐标系的常值特解，进行了Kirchhoff动力学比拟，用一次近似理论分别讨论了它们的Lyapu nov稳定性，导出了若干稳定性判据，并在参数平面上绘出了稳定域. 关键词： 超细长弹性杆 Kirchhoff方程 常值特解 Lyapunov稳定性     

双阳极磁控注入枪束流特性的研究

 介绍了用于34GHz基波回旋速调管的双阳极磁控注入枪的结构特点，为了准确分析磁控注入枪的束流特性，建立了阴极表面理论模型，用新编制的程序模拟了电子轨迹。模拟和测量结果显示磁场对磁控注入枪的束流有影响，磁控注入枪的束流也与阴极温度和空间电荷效应有关系。     

The Crystal Structure of N-Benzoyl-N''-(2-hydroxyethyl)-thiourea

Thiourea compounds are excellent agents of bioactive substance. A number of biological activities are associated with substituted thiourea derivatives. A survey of literature reveals that some work has been reported on benzoylthiourea, which has found plenty of applications as a facile and simple ligand in determination of trances of the transition metal and as an available starting material in preparation of a wide variety of metal complexes. In recent years,N-benzoyl-N'-(2-hydroxyethyl)-thiourea has attracted considerable attention as selective reagents for the liquid-liquid extraction and preconcentration of platinum group metals and its antifungle activity.As a part of our works in studying coordination behaviours of N-benzoyl-N'-(2-hydroxyethyl)-thiourea and its bioactivity, in view of these observations and in continuation of our previous works on it, the present work was reported on the crystal structure of N-benzoyl-N'-( 2-hydroxyethyl)-thiourea.The crystals structure in the monoclinic system and space group of P21/c of N-benzoyl-N'-(2-hydroxyethyl)- thiourea (C10H12N2O2S) was determined from single-crystal X-ray diffraction analysis, a = 17.083 (3) A, b = 4.5490 (10) A, c = 14.279 (3)A, a = 90.00°, a = 102.44(3)°, a = 90.00 °, Ⅴ = 1083.6 (4)A3, Z = 4, Dc = 1.375 Mg/m3, i (Mo Ka)= 0.280 mm-1, F(000) =472. The final R and u R are 0.0399 and 0.0881 for 783 observed reflections [Ⅰ＞26(Ⅰ)].Fig. 1 shows the molecular crystal structure of N-benzoyl-N'-(2-hydroxyethyl)thiourea indicating that the carbonyl and thiocarbonyl moieties are pointing in approximate opposite directions. The six atoms in the ring structure hydrogen bonded are almost in one plane. The N(2)-H proton pendant arm extends to the carbonyl oxygen atom, forms hydrogen bond between them.The existence of hydrogen bond in benzoyl-thiourea molecular six-membered ring structure has significant implications on coordination properties, suggest the possibility of intramolecular hydrogen bond controlled coordination behaviors of these potentially bidentate ligands. In the coordination compound reported by Bourne et al.,cis-bis(N-benzoyl-N'-propylthiourea)dichloroplatinum(Ⅱ), the two ligand molecules bind to Pt(Ⅱ)via the sulfur atoms only, the carbonyl oxygen atom being locked into hydrogen bond similar to that in the free ligands.     

Baker＇s Yeast Mediated Reduction of Optically Active Diketone

Baker‘s yeast mediated reduction of optically active diketone is described. The two keto groups are efficiently differentiated and the ee value of the recovered material is considerably raised. It affords highly optically active key intermediates efficiently for the synthesis of natural polyhydroxylated agarofuran products.