高比能高功率全石墨烯锂离子电容器

石墨烯由于拥有超高比表面积和超高电导率而被作为电化学电容器材料广泛研究.本文采用树脂为碳源,通过一种方便快捷的树脂交换法制备一种具有高比表面积的多级孔三维石墨烯（3DG）.经过此种方法的催化、造孔、热处理等主要工艺步骤后,可显著增加石墨烯材料的小、介孔数量,从而提高材料的电化学性能.通过BET测试表明,3DG的比表面积可达2400 m²/g,孔体积达到2.0 cm³/g.以3DG作为正负极材料制备高比能量高功率型锂离子电容器（3DG-LIC）,可使3DG-LIC的工作电压从传统超级电容器的2.5 V扩展到4.0 V,能量密度也从20 Wh/kg提高到105 Wh/kg.另外,相同的化学和微观结构能很好地平衡正负极的容量及速率,使高比能量高功率的3DG-LIC具有更宽阔的应用领域.     

Diffusion tensor parameters and principal eigenvector coherence: Relation to b-value intervals and field strength

Diffusion-weighted MRI images acquired at b-value greater than 1000 s mm^− 2 measure the diffusion of a restricted pool of water molecules. High b-value images are accompanied by a reduction in signal-to-noise ratio (SNR) due to the application of large diffusion gradients. By fitting the diffusion tensor model to data acquired at incremental b-value intervals, we determined the effect of SNR on tensor parameters in normal human brains, in vivo. In addition, we also investigated the impact of field strength on the diffusion tensor model. Data were acquired at 1.5 and 3 T, at b-values 0, 1000, 2000 and 3000 s mm^− 2 in twenty diffusion-sensitised directions. Fractional anisotropy (FA), mean diffusivity (MD) and principal eigenvector coherence (κ) were calculated from diffusion tensors fitted between datasets with b-values 0–1000, 0–2000, 0–3000, 1000–2000 and 2000–3000 s mm^− 2. Field strength and b-value effects on diffusion parameters were analysed in white and grey matter regions of interest. Decreases in FA, κ and MD were found with increasing b-value in white matter. Univariate analysis showed a significant increase in FA with increasing field strength in highly organised white matter. These results suggest there are significant differences in diffusion parameters at 1.5 and 3 T and that the optimal results, in terms of the highest values of FA in white matter, are obtained at 3 T with a maximum b = 1000 s mm^− 2.     

氟化氙(C-A蓝绿激光技术研究进展

 综述了XeF(C-A)激光的产生原理，表面放电光泵浦源的结构，激光器装置， XeF(C-A)激光实验研究以及XeF(C-A)激光理论模拟；介绍了XeF₂浓度的监测，以及表面放电光泵浦源技术研究的最新进展。     

锰(Ⅱ)-高碘酸钾-灿烂绿体系测定水中痕量锰

在 HAc- Na Ac环境中 ,锰 ( )对于高碘酸钾氧化灿烂绿的反应具有很强的催化作用。据此 ,建立了催化动力学光度法测定痕量锰 ( )的新方法。该方法的检出限为 2 .2 2× 10 -11g/ m L ,测定线性范围为0 .1— 12 ng/ m L。直接用于环境水样中锰的测定 ,获得满意的结果     

模式耦合理论在圆周对称长周期光纤光栅建模中的应用

长周期光纤光栅是不同于光纤Bragg光栅的一种光纤光栅器件 ,根据模式耦合理论 ,长周期光纤光栅表现为前向传播的纤芯导模和同向的各阶次包层模式之间的耦合。分析研究了长周期光纤光栅轴向的模场变化。忽略轴向的模式耦合以及包层模式之间的相互耦合作用 ,并认为折射率指数的调制只存在于纤芯中 ,建立了简化的长周期光纤光栅数学模型。对圆周对称轴向均匀型长周期光纤光栅谱特性进行了仿真 ,其结果与实验结果基本吻合 ,表明了简化的数学模型的合理性     

低密度稀土氧化物基气凝胶靶的研制

低密度的高原子序数元素氧化物气凝胶由于前驱体形成端基双键而易于收缩和开裂。通过调控配位环境结合无机分散溶胶凝胶法,制备了稀土氧化物气凝胶。氧化镧基气凝胶和氧化钇基气凝胶块体的成型性好,最低密度分别为0.05g·cm-3和0.06g·cm-3。其成分分别为六方相的La(OH)3和六方相的Y(OH)3,而聚丙烯酸中的羧基与稀土离子之间以桥接的方式进行配位。两种气凝胶均存在明显的多级结构,氧化镧基和氧化钇基气凝胶的初级粒子分别为纤维状和片/球混合形貌,而其二级粒子均为球形。两种气凝胶的比表面积分别为229.1m2·g-1和229.6m2·g-1。该方法制备的稀土氧化物气凝胶具有低的密度和纳米尺度的均匀性,在背光源中有潜在的应用。     

Structure and electrochemical performance of LiCoO2 cathode material in different voltage ranges

LiCoO₂ sample prepared by high-temperature solid state calcination shows a typical hexagonal structure with a single phase and fine particle size distribution. The high-voltage electrolyte with additive fluoroethylene carbonate (FEC) has been used. Electrochemical results show that the initial discharge capacities of the prepared LiCoO₂ cathode are 157.7, 169.5, 191.0, and 217.5 mAh g^?1 in the voltage ranges of 3.0–4.3, 3.0–4.4, 3.0–4.5, and 3.0–4.6 V, respectively. The capacity increases, while the initial coulombic efficiency and capacity retention decrease with increasing the charge cutoff voltage. The capacity retention is only 10.4 % after 200 cycles at 1C rate in the voltage range of 3.0–4.6 V. X-ray diffraction measurements confirm structural changes of the layered material in the different voltage ranges. A phase transition from the O3 to the H1-3 phase can be observed when LiCoO₂ is charged above 4.5 V. The AC impedance analysis indicates that the resistances (R _(sf+b), R _ct) of the prepared LiCoO₂ rapidly increase when the cell is charged to higher voltage. The amount of dissolved Co into the electrolyte also greatly increases with increasing the charge cutoff voltage.     

Kadison-Singer代数研究综述

回顾了建立KS-代数的研究背景,系统介绍了KS-代数的定义和性质以及超有限KS-代数、非超有限KS-代数、KS-格的构造和强KS-代数的研究结果,同时分析了KS-代数和经典的不变子空间、Kadison可迁代数、von Neumann代数生成元等问题之间的联系;讨论了非自伴代数的运算,给出了两种不同构造非自伴代数的运算法则;在此基础上,提出了未来学科发展有待研究的16个问题.     

广义KdV--BO方程的Cauchy问题的局部适定性的改进结果

In this paper we prove that the Cauchy problem associated with the generalized KdV-BO equation ut ＋ uxxx ＋ λH（uxx） ＋ u^2ux = 0, x ∈ R, t ≥ 0 is locally wellposed in Hr^s（R） for 4/3 〈r≤2, b〉1/r and s≥s（r）= 1/2- 1/2r. In particular, for r = 2, we reobtain the result in [3].     

Tumor‐Targeting W18O49 Nanoparticles for Dual‐Modality Imaging and Guided Heat‐Shock‐Response‐Inhibited Photothermal Therapy in Gastric Cancer

Photothermal therapy (PTT) is an emerging noninvasive and precise localized therapeutic modality; however, it is deeply limited by its poor tumor accumulation, inadequate photothermal conversion efficiency, and the thermoresistance of cancer cells. Aimed at these shortcomings, tumor‐targeting nanoparticles (iRGD‐W₁₈O₄₉‐17AAG) comprising carboxyl‐group‐functionalized W₁₈O₄₉ nanoparticles, integrin‐targeting peptide iRGD, and HSP90‐inhibitor 17AAG are developed. The W₁₈O₄₉ nanoparticles act as excellent PTT carriers and computed tomography (CT) imaging contrast agents. The ring type polypeptide iRGD promotes the accumulation of nanoparticles in the tumour and further penetration into cancer cells. The introduction of 17AAG can inhibit the heat‐shock response and overcome the thermoresistance, thus increasing the curative effect of PTT and reducing the chance of tumor recurrence. The W₁₈O₄₉ nanoparticles can also be used to monitor and guide the phototherapeutic through CT and near‐infrared fluorescence imaging after modification with Cy5.5. In addition, superior biosafety is also indicated in both preliminary in vitro and in vivo assessments. The potential of iRGD‐W₁₈O₄₉‐17AAG in tumor targeting, dual modality imaging‐guided and remarkable enhanced PTT of gastric cancer with ignorable side effect both in vitro and in vivo, which may be further applied in clinic, is highlighted.