An investigation of the Al2O3-CdSe interface in accumulation

The Al₂O₃−CdSe interface of a thin-film transistor is investigated in the frequency range 30 Hz-30 kHz under weak depletion and accumulation. The surface states are, most likely, located in the insulator Al₂O₃ with a concentration varying from 4·10¹⁸ to 10¹⁹ cm⁻³ eV⁻¹. The surface states have a negligible influence on the thin-film transistor operation.     

Issues in Managing Information Technology

This paper describes three case studies which investigated issues relating to the implementation and management of advanced information technology. The benefits derived from information technology were found to vary from one organization to another. These studies provide further evidence to support earlier research findings that senior management has an important role to play in the effective exploitation of information technology, and that the investment approach taken by an organization has a significant effect on the development of computer-based information systems. The effectiveness of a system depends not only on applying the appropriate technology, but also on how successfully technical and behavioural issues are resolved.     

准移动闭塞系统的元胞自动机模型及列车延迟传播规律的研究

在NaSch模型的基础上，针对铁路交通的特点提出一种用于模拟准移动闭塞系统的元胞自动机模型.应用该模型模拟了准移动闭塞系统列车延迟传播的交通现象，分析了准移动闭塞系统中的轨道定位单元长度、发车时间间隔、初始延迟时间等因素对列车延迟传播的影响. 关键词： 元胞自动机 交通流 准移动闭塞     

Yb3+掺杂KY(WO4)2激光晶体生长、结构与光谱分析

采用顶部籽晶提拉法(TSSG)生长出Yb:KY(WO₄)₂(Yb:KYW)激光晶体.对预烧后的原料及晶体进行了XRD分析，结果表明，分别在920℃和600℃预烧8h后的熔质和助熔剂基本上形成一相，抑止了实验中的挥发问题；所生长的晶体为β-Yb:KYW，计算其晶格常数为a=1.063nm，b=1.034nm，c=0.755nm，β=130.75°.测得不同厚度样品的吸收光谱，结果表明样品在933nm和981nm有较强的吸收峰，计算出主峰981nm的吸收截面σ关键词： Yb:KYW TSSG法 晶体结构 光谱参数     

Ni(111)表面一氧化碳和氢共吸附的密度泛函理论研究

本文用密度泛函理论(DFT)的总能计算研究了一氧化碳和氢原子在Ni(111)表面上p(2×2)共吸附系统的原子结构和电子态，结果表明CO和H原子分别被吸附于两个对角p(1×1)元胞的hcp和fcc位置.以氢分子和CO分子作为能量参考点，总吸附能为2.81 eV，相应的共吸附表面功函数φ为6.28 eV.计算得到的C—O，C—Ni和H—Ni的键长分别是1.19?, 1.96?和 1.71?，并且CO分子以C原子处于hcp的谷位与金属衬底原子结合.衬底Ni(111)的最外两层的晶面间距在吸附后的相对变化分别是 关键词： Fisher-Tropsch反应 催化作用 Ni(111) p(2×2)/(CO+H) 共吸附     

二氧化钒薄膜的低温制备及其性能研究

针对VO₂薄膜在微测辐射热计上的应用，采用射频反应溅射法，在室温下制备氧化钒薄膜；研究了氧分压对薄膜沉积速率、电学性质及成分的影响.通过调节氧分压，先获得成分接近VO₂的非晶化薄膜，再在400℃空气中氧化退火，便可制得高电阻温度系数，低电阻率的VO₂薄膜，电阻温度系数约为-4%/℃，薄膜方块电阻为R_□为100—300kΩ；薄膜在室温下沉积，400℃下退火的制备方法与微机电加工(micro electromechanic 关键词： 二氧化钒 电阻温度系数 氧分压 射频反应溅射法     

A warehouse-based design model for reverse logistics

In this paper, an MILP formulation is proposed for the design of a reverse logistics network based on a warehouse location–allocation model, which optimizes, simultaneously, the forward and reverse networks. A single product model with unlimited capacity is first defined. Subsequently, the model is extended to a multi-product capacitated recovery network model, where capacity limitations and a multi-product system can be considered. The proposed model is compared to published work in the field, where different model assumptions have been proposed. Two cases are described so as to gain a better insight into the model and allow a comparative analysis.     

Quadratic data envelopment analysis

Data Envelopment Analysis (DEA) offers a piece-wise linear approximation of the production frontier. The approximation tends to be poor if the true frontier is not concave, eg in case of economies of scale or of specialisation. To improve the flexibility of the DEA frontier and to gain in empirical fit, we propose to extend DEA towards a more general piece-wise quadratic approximation, called Quadratic Data Envelopment Analysis (QDEA). We show that QDEA gives statistically consistent estimates for all production frontiers with bounded Hessian eigenvalues. Our Monte-Carlo simulations suggest that QDEA can substantially improve efficiency estimation in finite samples relative to standard DEA models.     

Effective dimensionality approach to the RKKY interaction in multilayer systems

We consider RKKY interaction in a quasi 2D system with nonparabolic dispersion. In our paper we calculate the RKKY range function assuming the in-layer confinement via effective dimensionality approach. We show, that indirect magnetic exchange in our system can be modelled by the effective spectral dimension which equals one.     

All retraction operators on a complete lattice form a complete lattice

H. Crapo raised in 1982 the following problem: IfP is a complete lattice, is Retr (P) a complete lattice? here Retr (P) denotes the set of all retraction operators onP with the pointwise order, that is,f≤g in Retr (P) ifff(x)≤g(x) for everyx inP. An affirmative answer will be given in the present paper.