锌试剂分光光度法测定壳聚糖含量

利用锌试剂与壳聚糖在一定酸度条件下的特异性显色反应，即其复合物在465nm处吸光度与壳聚糖含量在0～O．04g／L范围内呈现良好的线性关系(R=0．996)，基于此建立了一种简便快速的分光光度法。平均回收率为99．68％。     

甲烷部分氧化制合成气 Ⅰ．甲烷在过渡金属上的活化

文中用同位素交换（Ｄ_２─ＣＨ_４）反应来测量四种过渡金属负载型催化剂对甲烷的活化能力，并与Ｓｖｅｎｓｓｏｎ等从头算的计算结果作了比较，表明最有效活化甲烷分子的Ｃ─Ｈ键的金属是铑（Ｒｈ）．文中还测定了在甲烷部分氧化制合成气反应中，四个不同催化剂的催化活性与选择性，并与它们对甲烷的活化能力进行对比，可以看出甲烷部分氧化反应中，反应活性高的催化剂有效地活化甲烷，断裂Ｃ─Ｈ键，而且氘代甲烷产物分布以形成ＣＤ_４产物为主要成份．     

Investigation of shifts and interaction of signals in high-contrast transmission spectroscopy

In the recently introduced high-contrast transmission version of saturated absorption laser spectroscopy, narrow signals are obtained from dense atomic samples subject to strong pumping. A study of possible systematic shifts of the signals in this domain of rather extreme experimental conditions was performed in order to assess the validity of spectroscopic data obtained with this technique. Certain signal components were found to be slightly shifted while others were not. Further, a theoretical study of the behaviour of overlapping signals in the high-contrast regime is presented. In particular, the question of whether structures buried under the natural linewidth could be resolved is addressed.     

光谱复杂的稀土基体中稀土杂质ICP光谱测定的一些问题

ICP激发光源以其独特的功能使ICP/AES技术在稀土分析中的应用日益广泛,在一定程度上取代了经典的直流电弧光谱法,但应指出,由于常规雾化器的低雾化效率(≤5％)和试样的高倍稀释,ICP/AES技术的实际检测能力的改善并不明显,本文用ICP光谱法测定了     

Voltammetric sizing of a sphere.

The size of a glass sphere positioned in the center of a microdisk electrode is determined by using a simple electrochemical procedure and is confirmed, additionally, by a microscopical measurement of the sphere at the time of the electrochemical measurement. The cyclic voltammetric response of the naked electrode and of the electrode with the sphere positioned in its center is recorded over a wide range of scan rates (0.002-1.5 V s(-1)). The size of the sphere is then determined by comparison of the experimental voltammogram with simulations for each individual scan rate.     

2-三氰基乙烯基蒽及其旋转异构体的量子化学研究

用量子化学从头算方法 ,在RHF/STO - 3G水平上 ,对 2_三氰基乙烯基蒽 (2_TCVA)分子进行了理论计算 ,优化得到了它的平衡几何构型 ,并计算了它的谐振动频率 .结果表明 :2_TCVA存在两种旋转异构体 :2_TCVA(1)和 2_TCVA(2 ) ,2_TCVA(2 )的总能量比 2_TCVA(1)的略高 .在PM3/CIS水平上计算了它们的电子光谱 ,得到了由基态到各激发态的垂直跃迁能和相应的振子强度 .研究表明 :2_TCVA(1)和 2_TCVA(2 )的强度最大的吸收波长分别为 2 4 9.72nm和 2 89.4 1nm ,2_TCVA(2 )的强度最大的吸收波长比 2_TCVA(1)的要长 .计算结果与实验结果符合得较好     

Designed nanostructured pt film for electrocatalytic activities by underpotential deposition combined chemical replacement techniques

Multiple-deposited Pt overlayer modified Pt nanoparticle (MD-Pt overlayer/PtNPs) films were deliberately constructed on glassy carbon electrodes through alternately multiple underpotential deposition (UPD) of Ag followed redox replacement reaction by Pt (II) cations. The linear and regular growth of the films characterized by cyclic voltammetry was observed. Atomic force spectroscopy (AFM) provides the surface morphology of the nanostructured Pt films. Rotating disk electrode (RDE) voltammetry and rotating ring-disk electrode (RRDE) voltammetry demonstrate that the MD-Pt overlayer/PtNPs films can catalyze an almost four-electron reduction of O(2) to H(2)O in air-saturated 0.1 M H(2)SO(4). Thus-prepared Pt films behave as novel nanostructured electrocatalysts for dioxygen reduction and hydrogen evolution reaction (HER) with enhanced electrocatalytic activities, in terms of both reduction peak potential and peak current, when compared to that of the bulk polycrystalline Pt electrode. Additionally, it is noted that after multiple replacement cycles, the electrocatalytic activities improved remarkably, although the increased amount of Pt is very low in comparison to that of pre-modified PtNPs due to the intrinsic feature of the UPD-redox replacement technique. In other words, the electrocatalytic activities could be improved markedly without using very much Pt by the technique of tailoring the catalytic surface. These features may provide an interesting way to produce Pt catalysts with a reliable catalytic performance as well as a reduction in cost.     

Molar conductivity calculation of Li-ion battery electrolyte based on mode coupling theory

A method is proposed to calculate molar conductivity based on mode coupling theory in which the ion transference number is introduced into the theory. The molar conductivities of LiPF6, LiClO4, LiBF4, LiAsF6 in PC (propylene carbonate) are calculated based on this method. The results fit well to the literature data. This presents a potential way to calculate the conductivities of Li-ion battery electrolytes.