The two spin states of an end-on copper(II)-superoxide mimic

The reaction of nitrosobenzene with copper(I) complexes of a tetradentate ligand led to two novel species that are best described as copper(II) complexes of an O-bonded nitrosobenzyl radical anion, in either the singlet or the triplet spin-state. Both states were characterized by crystal structures, magnetic measurements and DFT calculations.     

Sensitivity improvement of 1H-15N cross-polarization at high MAS frequency applied to NMR structural characterization of organic solids

(15)N CP/MAS solid state NMR should be a method of choice to obtain essential structural information on organic materials containing nitrogen atoms. However, the technique is generally not selected for the characterization of non-labelled chemical compounds, which represents the most common situation encountered by chemists. Actually, due to the poor sensitivity of (15)N the method is time-consuming and a very fine calibration is often a prerequisite to reach a sufficient signal/noise. The main drawback comes from the weakness of (15)N-(1)H dipolar couplings which leads to a splitting of the static Hartman Hahn condition into very narrow sideband conditions under MAS. Practically, it is more difficult to obtain a high enough CP transfer level on (15)N for the entire spectrum than on other more conventional nuclei like (13)C. An experimental investigation of the CP efficiency using the ramp and adiabatic CP transfer experiments is here proposed. Preliminary adjustments of experimental settings were first made on an (15)N-labeled substituted heterocyclic model system, and then applied to several other organic compounds. Particular attention was paid to the detection of non-protonated nitrogen atoms with a significant chemical shift anisotropy, which represented the least favourable case. It was experimentally demonstrated that, for these atoms, the adiabatic passage provided a much higher transfer level than the more conventional ramp sequence leading to an enhancement factor of up to 3.5 at a MAS frequency of 30 kHz. The resulting sensitivity rendered possible the detection of non-protonated nitrogen atoms at natural abundance with 2.5-mm rotors at 9.4 T.     

Gold bearing ore assays using 197Au(γ,n)196Au photonuclear reaction

We performed computational and experimental studies of the feasibility of the gold bearing ore assay utilizing the ¹⁹⁷Au(γ,n)¹⁹⁶Au photonuclear reaction. Gold bearing silicate samples were irradiated using bremsstrahlung produced by an electron accelerator with endpoint energies ranging from 25 to 40 MeV. ¹⁹⁶Au yield simulations were benchmarked and experimental results were in good agreement with the predictions. Optimum electron beam energy for photon activation analysis was found to be around 32 MeV which corresponded to a detection limit of 80 ppb. Two-hour gamma-spectroscopy measurements were repeated every 24 h and the optimum sample cooling time was found to be about 100–160 h.     

The anharmonic vibrational potential and relaxation pathways of the amide I and II modes of N-methylacetamide

We investigate the influence of isotopic substitution and solvation of N-methylacetamide (NMA) on anharmonic vibrational coupling and vibrational relaxation of the amide I and amide II modes. Differences in the anharmonic potential of isotopic derivatives of NMA in D2O and DMSO-d6 are quantified by extraction of the anharmonic parameters and the transition dipole moment angles from cross-peaks in the two-dimensional infrared (2D-IR) spectra. To interpret the effects of isotopic substitution and solvent interaction on the anharmonic potential, density functional theory and potential energy distribution calculations are performed. It is shown that the origin of anharmonic variation arises from differing local mode contributions to the normal modes of the NMA isotopologues, particularly in amide II. The time domain manifestation of the coupling is the coherent exchange of excitation between amide modes seen as the quantum beats in femtosecond pump-probes. The biphasic behavior of population relaxation of the pump-probe and 2D-IR experiments can be understood by the rapid exchange of strongly coupled modes within the peptide backbone, followed by picosecond dissipation into weakly coupled modes of the bath.     

Controlling the passage of light through metal microchannels by nanocoatings of phospholipids

The flow of polarized light through a metal film with an array of microchannels is controlled by the phase of an optically active, phospholipid nanocoating, even though the coating does not cover the open area of the microchannels. The molecular details of the assembly (DPPC phospholipid monolayer/bilayer on a hexadecanethiol monolayer on a copper- or nickel-coated microarray) were determined using the infrared, surface-plasmon-mediated, extraordinary transmission of the metal microarrays. Infrared absorption spectra with greatly enhanced absorptions by comparison to literature were recorded and used as a diagnostic for the phase, composition, and molecular geometry of these nanocoatings. This approach presents new tools for nanoscale construction in constricted microspaces, which may ultimately be useful with individual microchannels.     

Acetylene weak bands at 2.5 μm from intracavity Cr:ZnSe laser absorption observed with time-resolved Fourier transform spectroscopy

The spectral dynamics of a mid-infrared multimode Cr(2+):ZnSe laser located in a vacuum sealed chamber containing acetylene at low pressure is analyzed by a stepping-mode high-resolution time-resolved Fourier transform interferometer. Doppler-limited absorption spectra of C(2)H(2) in natural isotopic abundance are recorded around 4000 cm(-1) with kilometric absorption path lengths and sensitivities better than 3 10(-8) cm(-1). Two cold bands are newly identified and assigned to the ν(1)+ν(4) (1) and ν(3)+ν(5) (1) transitions of (12)C(13)CH(2). The ν(1)+ν(5) (1) band of (12)C(2)HD and fourteen (12)C(2)H(2) bands are observed, among which for the first time ν(2)+2ν(4) (2)+ν(5) (-1).     

Colloidal Nanocrystals of Lithiated Group 14 Elements

The synthesis of colloidal nanocrystals (NCs) of lithiated group 14 elements (Z=Si, Ge, and Sn) is reported, which are Li_4.4Si, Li_3.75Si, Li_4.4Ge, and Li_4.4Sn. Li_xZ compounds are highly reactive and cannot be synthesized by existing methods. The success relied on separating the surface protection from the crystal formation and using a unique passivating ligand. Bare Li_xZ crystals were first produced by milling elemental Li and Z in an argon‐filled jar. Then, under the assistance of additional milling, hexyllithium was added to passivate the freshly generated Li_xZ NCs. This ball‐milling‐assisted surface protection method may be generalized to similar systems, such as Na_xZ and K_xZ. Moreover, Li_4.4Si and Li_4.4Ge NCs were conformally encapsulated in carbon fibers, providing great opportunities for studying the potential of using Li_xZ to mitigate the volume‐fluctuation‐induced poor cyclability problem confronted by Z anodes in lithium‐ion batteries.     

The Formation of Imidazolium Salt Intimate (Contact) Ion Pairs in Solution

1‐n‐Butyl‐2,3‐dimethylimidazolium (BMMI) ionic liquids (ILs) associated with different anions undergo H/D exchange preferentially at 2‐Me group of the imidazolium in deuterated solvents. This process is mainly related to the existence of ion pairs rather than the anion basicity. The H/D exchange occurs in solvents (CDCl₃ and MeCN for instance) in which intimate contact ion pairs are present and the anion possesses a labile H in its structure, such as hydrogen carbonate and prolinate. In D₂O, separated ion pairs are formed and the H/D exchange does not occur. A plausible catalytic cycle is that the IL behaves as a neutral base in the course of all H/D exchange processes. NMR experiments, density functional calculations, and molecular dynamics simulations corroborate these hypotheses.     

A Supramolecular Sorting Hat: Stereocontrol in Metal–Ligand Self‐Assembly by Complementary Hydrogen Bonding

A combination of self‐complementary hydrogen bonding and metal–ligand interactions allows stereocontrol in the self‐assembly of prochiral ligand scaffolds. A unique, non‐tetrahedral M₄L₆ structure is observed upon multicomponent self‐assembly of 2,7‐diaminofluorenol with 2‐formylpyridine and Fe(ClO₄)₂. The stereochemical outcome of the assembly is controlled by self‐complementary hydrogen bonding between both individual ligands and a suitably sized counterion as template. This hydrogen‐bonding‐mediated stereoselective metal–ligand assembly allows the controlled formation of nonsymmetric discrete cage structures from previously unexploited ligand scaffolds.