Poly(butylene terephthalate)/poly(ε-caprolactone) blends: Influence of PCL molecular mass on PBT melting and crystallization behavior

The isothermal crystallization kinetics and melting behavior of poly(butylene terephthalate) (PBT) in binary blends with poly(ε-caprolactone) (PCL) was investigated as a function of PCL molecular mass by differential scanning calorimetry and optical microscopy. The components are miscible in the melt when oligomeric PCL (M_w = 1250) is blended with PBT, whereas only partial miscibility was found in mixtures with higher molecular mass (M_w = 10,000 and 50,000). The equilibrium melting point of PBT in the homopolymer and in blends with PCL was determined through a non-linear extrapolation of the T_m = f(T_c) curve. The PBT spherulitic growth rate and bulk crystallization rate were found to increase with respect to plain PBT in blends with PCL1250 and PCL10000, whereas addition of PCL50000 causes a reduction of PBT solidification rate. The crystallization induction times were determined by differential scanning calorimetry for all the mixtures through a blank subtraction procedure that allows precise estimation of the crystallization kinetics of fast crystallizing polymers. The results have been discussed on the basis of the Hoffman-Lauritzen crystallization theory and considerations on both the transport of chains towards the crystalline growth front and the energy barrier for the formation of critical nuclei in miscible and partially miscible PBT/PCL mixtures are widely debated.     

Hybrid fluorocarbon-hydrocarbon CO2-philic surfactants. 2. formation and properties of water-in-CO2 microemulsions

Hybrid fluorocarbon-hydrocarbon (F-H) sulfate surfactants are shown to be efficient stabilizers in water-in-CO2 (w/c) microemulsions. The chain structure and F-H ratio affect the regions of P-T phase stability and aggregation structure in these w/c phases. High-pressure near-infrared spectroscopy and small-angle neutron scattering measurements of microemulsified water provide evidence for the stabilization of w/c microemulsion droplets. The relative lengths of the two chains were found to influence the favored aggregation structure: for symmetric chain surfactants (F8H8, F7H7) spherical reverse micelles are present, but for asymmetric chain surfactants (F7H4, F8H4) extended cylinder aggregates form. These changes in aggregation are consistent with different surfactant packing parameters owing to the controlled variations in molecular structure. Furthermore, the general order of w/c phase transition pressures (F8H8 < F7H7 and F8H4 < F7H4) is in line with estimations of surfactant fractional free volume, as proposed by Johnston et al. (J. Phys. Chem. B 2004, 108, 1962-1966). Studies of adsorption at the poly(dimethylsiloxane)-water interface are shown to be valuable for assessing the CO2-philicity of new surfactants. All in all, the symmetric F8H8 and F7H7 analogues are seen to be the most efficient compounds from this class for applications in CO2.     

Capillary sodium dodecyl sulfate-DALT electrophoresis with laser-induced fluorescence detection for size-based analysis of proteins in human colon cancer cells

Capillary sodium dodecyl sulfate (SDS)-DALT electrophoresis (SDS-DALT-CE) refers to CE separation of proteins based on their size; DALT is the abbreviation for Dalton, the unit used to describe molecular weight. In this work, seven proteins from 18 to 116 kDa were denatured by SDS, labeled by 3-(2-furoyl) quinoline-2-carboxaldehyde, separated by SDS-DALT-CE in polyethylene oxide sieving matrix, and detected by laser-induced fluorescence (LIF) in a sheath flow cuvette. This method was combined with detergent differential fractionation, which is a protein fractionation method using a series of detergent-containing buffers to sequentially extract protein fractions from cells, to analyze the proteins in HT29 human colon adenocarcinoma cells. In addition, on-column labeling was demonstrated for protein analysis by SDS-DALT-CE with LIF, and applied to analysis of proteins in a single HT29 cancer cell. Most proteins had molecular masses from 10 to 120 kDa. Similar protein profiles were obtained for single cells and protein extract of a large cell population.     

Site-specific ligation of anthracene-1,8-dicarboxylates to an Mn12 core: a route to the controlled functionalisation of single-molecule magnets

A novel single-molecule magnet of the Mn12 family, [Mn12O12(O2CC6H5)8(L)4(H2O)4].8CH2Cl2, has been synthesised by site-specific ligand exchange using a tailor-made dicarboxylate (L2-), which leads to selective occupation of axial binding sites.     

Metal ion catalysis in the beta-elimination reactions of N-[2-(4-pyridyl)ethyl]quinuclidinium and N-[2-(2-pyridyl)ethyl]quinuclidinium in aqueous solution

Catalysis of the beta-elimination reaction of N-[2-(4-pyridyl)ethyl]quinuclidinium (1) and N-[2-(2-pyridyl)ethyl]quinuclidinium (2) by Zn(2+) and Cd(2+) in OH(-)/H(2)O (pH = 5.20-6.35, 50 degrees C, and mu = 1 M KCl) has been studied. In the presence of Zn(2+), the elimination reactions of both isomers occur from the Zn(2+)-complexed substrates (C). The equilibrium constants for the dissociation of the Zn(2+)-complexes are as follows: K(d) = 0.012 +/- 0.003 M (isomer 1) and K(d) = 0.065 +/- 0.020 M (isomer 2). The value of k(C)(H2O) for isomer 1 is 4.81 x 10(-6) s(-1). For isomer 2 both the rate constants for the "water" and OH(-)-induced reaction of the Zn(2+)-complexed substrate could be measured, despite the low concentration of OH(-) in the investigated reaction mixture [k(C)H2O)= 1.97 x 10(-6) s(-1) and k(C)(OH-)= 21.9 M(-1) s(-1), respectively]. The measured metal activating factor (MetAF), i.e., the reactivity ratio between the complexed and the uncomplexed substrate, is 8.1 x 10(4) for the OH(-)-induced elimination of 2. This high MetAF can be compared with the corresponding proton activating factor (Alunni, S.; Conti, A.; Palmizio Errico, R. J. Chem. Soc., Perkin Trans. 2 2000, 453), PAF = 1.5 x 10(6) and is in agreement with an E1cb irreversible mechanism (A(xh)D(E)* + D(N)) (Guthrie, R. D.; Jencks, W. P. Acc. Chem. Res. 1989, 22, 343). A value of k(C)(H2O)>or= 23 x 10(-7) s(-1) is estimated for the Cd(2+)-complexed isomer 2, while catalysis by Cd(2+) has not been observed for isomer 1.     

Fractionation of metals and metalloids by chemical bonding from particles accumulated by electrostatic precipitation in an Argentine thermal power plant

A study was undertaken to evaluate the distribution of Al, As, Cr, Cu, Fe, Mn, Ni, Pb, Ti, V and Zn in fly ashes collected in the electrostatic precipitator of a thermal power plant in San Nicolás (Argentina). Five samples were collected during one week of operation. For the fractionation, the scheme applied consisted in extracting the elements in four fractions namely (i) soluble and exchangeable elements; (ii) carbonates, oxides and reducible elements; (iii) bound to sulfidic metals; and (iv) residual elements. Metals and metalloids at μg g^− 1 level were determined in each fraction by inductively coupled plasma optical emission spectrometry (ICP OES). For validation, a standard reference material (SRM 1633 coal fly ash) from NIST was subjected to the same chemical sequential extraction procedure that the samples. X-ray diffraction powder (XRD) analysis and scanning electron microscopy (SEM) were used to characterize the major minerals present in the matrix. Total analyte concentration (in μg g^− 1) varied from 10.6 for Pb to 17,622 for Al. Minimum and maximum concentrations (in μg g^− 1) found in individual samples in the four fractions were: Al, 92.7–9668; As, < 0.3–143; Cr, 2.0–10.4; Cu, < 0.2–35.6; Fe, < 0.3–4992; Mn, < 0.1–128; Ni, < 0.3–139; Pb, < 0.5–9.1; Ti, < 0.3–2243; V, 17.0–112.9; and Zn, < 0.1–68.2. The leachability of the 11 elements under study proved to be different. Low percentages of Al (1%), V (7%) and Cr (8%) were detected in the most bioavailable fraction. Arsenic was found to be most abundant in the non-silicate phase, represented by the second and third fractions, while Cr, Fe, Ni, Pb and Zn were mostly associated to the residual fraction.     

CH...O and CH...F links form the cage structure of dioxane-trifluoromethane

The molecular beam Fourier transform microwave spectrum of 1,4-dioxane-trifluoromethane has been assigned and measured. The two subunits form a cage stabilized by one C-H...O and two C-H...F weak hydrogen bonds. The C-H...O link involves the axial lone pair of one of the two equivalent ring oxygens, while the two C-H...F bridges connect trifluoromethane to the two axial hydrogens in positions 3 and 5. The dissociation energy has been estimated from the D(J) centrifugal distortion parameter to be approximately 6.8 kJ/mol.     

On some incidence structures

In this paper,suggested by André's papers ([2), [3]), we construct geometrical structures (X,?,//}) where X is a finite set of points, ? is a set of lines, and // is an equivalence relation on ?. These constructions are made starting with a finite and not empty set X and a permutation group G which is 2-transitive on X and such that the stabilizer of two distinct points of X is different from the identical subgroup. We look for conditions such that the structure (X, ?) is a (3,q)-Steiner system. We remember that a (3,q)-Steiner system is a pair (X,B), where X is a set of elements (called points), B is a system of subsets of X (called blocks), such that:

1. every block contains q points exactly;
2. given three distinct points x,y,z of X, there is exactly one subset of X belonging to B and containing x,y,z.

At the end we construct such a system with the help of a nearskewfield (according to Zassenhaus [7], [8]).     

Metal-induced assembling/disassembling of fluorescent naphthalenediimide derivatives signalled by excimer emission

The new quadridentate bischelating ligands 2 and 3 display in solution the typical absorption and emission properties expected for naphthalenediimide derivatives. Spectrophotometric studies show that systems 2 and 3 interact with Zn(II), Cd(II) and Cu(I) in CHCl3 or MeCN according to an apparent 1:1 stoichiometry. Molecular modelling, ESI-MS and 1H NMR experiments indicate that the complex species formed in the presence of stoichiometric amounts of metal ion are nonhelical [2 + 2] adducts. The metal-induced self-assembling process is signalled by an intense excimer-type emission caused by the intramolecular interaction of two naphthalenediimide subunits that face each other in the [2 + 2] adduct, as shown by molecular modelling studies. In the presence of excess metal ion, a disassembling process takes place, leading to a dinuclear complex with a 2:1 metal/ligand stoichiometry, in which the intramolecular excimer is no longer allowed to form because the interaction between the naphthalenediimide subunits has been lost. Thus, the overall metal-induced assembling/disassembling process is signalled by the appearance and disappearance of the excimer band in the emission spectrum.