Kinetics and Mechanism of the Photosensitized Oxidation of Furosemide*

Detection of O2(1δg) phosphorescence emission, γmax = 1270 nm, following laser excitation and steady-state competitive methods was employed to measure total rate constants, kT, for the reactions of the diuretic furosemide, 2-methylfurane and furfurylamine with singlet oxygen in several solvents. Correlation of kT values with solvent parameters and product identification shows that the reaction mechanism is strongly solvent dependent. In aliphatic alcohols, the dependence of kT on solvent parameters is similar to the one observed for triethylamine, suggesting a reaction mechanism involving partial charge transfer from the amino group to the singlet oxygen. In nonprotic solvents, the dependence of kT on solvent parameters resembles the behavior found for 2-methylfur-ane and furfurylamine, implying that mostly a 2 + 4 cy-cloaddition mechanism of singlet oxygen to furane ring of furosemide occurs in these solvents. These mechanistic differences are explained in terms of hydrogen-bonding interactions between the carboxylic group in the aromatic ring and the amino group of furosemide. Furthermore, direct generation of C2(1δg) by furosemide was detected. Quantum yields of 0.047 ± 0.003 and 0.078 ± 0.004 were determined in acetonitrile and benzene, respectively. This last result may be related, at least partially, to the photodynamic effects of this diuretic drug.     

Fabrication and characterization of high-temperature microreactors with thin film heater and sensor patterns in silicon nitride tubes

In this paper the fabrication and electrical characterization of a silicon microreactor for high-temperature catalytic gas phase reactions, like Rh-catalyzed catalytic partial oxidation of methane into synthesis gas, is presented. The microreactor, realized with micromachining technologies, contains silicon nitride tubes that are suspended in a flow channel. These tubes contain metal thin films that heat the gas mixture in the channel and sense its temperature. The metal patterns are defined by using the channel geometry as a shadow mask. Furthermore, a new method to obtain Pt thin films with good adhesive properties, also at elevated temperatures, without adhesion metal is implemented in the fabrication process. Based on different experiments, it is concluded that the electrical behaviour at high temperatures of Pt thin films without adhesion layer is better than that of Pt/Ta films. Furthermore, it is found that the temperature coefficient of resistance (TCR) and the resistivity of the thin films are stable for up to tens of hours when the temperature-range during operation of the microreactor is below the so-called "burn-in" temperature. Experiments showed that the presented suspended-tube microreactors with heaters and temperature sensors of Pt thin films can be operated safely and in a stable way at temperatures up to 700 degrees C for over 20 h. This type of microreactor solves the electrical breakdown problem that was previously reported by us in flat-membrane microreactors that were operated at temperatures above 600 degrees C.     

Total synthesis of (+)-aspidospermidine: a new strategy for the enantiospecific synthesis of aspidosperma alkaloids

A new strategy was developed for the enantiospecific synthesis of aspidosperma alkaloids. The key steps involve a novel ketene-lactonization reaction of a chiral vinyl sulfoxide to efficiently set up the quaternary carbon center, and a tandem Michael addition-alkylation reaction sequence to form the polycyclic core structure. This new strategy was employed in the total synthesis of natural product (+)-aspidospermidine.     

Excitation energies of pi-conjugated oligomers within time-dependent current-density-functional theory

We study the pi*<--pi singlet excitations of the pi-conjugated oligomers of polyacetylene, polydiacetylene, polybutatriene, polythiophene, poly(para-phenylene vinylene), and the lowest singlet excitations of the hydrogen chain. For this we used time-dependent current-density-functional theory within the Vignale-Kohn and adiabatic local density approximations. By studying the dependence of the excitation spectrum on the chain length we conclude that the reduction of the static polarizability when using the Vignale-Kohn functional has two origins. First, the excitation energies of transitions with a large transition dipole are shifted upward. Second, the character of the transition between the lowest occupied and highest unoccupied molecular orbitals and the oscillator strength of the lowest transition within the adiabatic local density approximation is transferred to higher transitions. The lowest transitions that have a considerable oscillator strength obtained with the Vignale-Kohn functional have excitation energies that are in most cases in better agreement with available reference data than the adiabatic local density approximation.     

Atomic weights and isotopic abundances of the elements: A future concern for the analytical chemist

Summary The recent evolution and present status of the atomic weights of the elements is reviewed. Attention is drawn upon a number of rather unknown characteristics of these values: the accuracy of a considerable number of atomic weights has been decreased due to lack of justification of the number of significant figures in published values. Furthermore geological and artificial variations in isotopic composition start to influence atomic weights of some elements being circulated in the reagents market; the analytical chemist should be aware of it.The concept of atomic weights and natural isotopic abundances being fundamental constants of nature should be abandoned.

---

Atomgewichte und Isotopenhäufigkeiten der Elemente: ein künftiges Problem für den Analytiker

Zusammenfassung Ein Überblick wird gegeben über die jüngste Entwicklung und den gegenwärtigen Stand. Auf eine Anzahl ziemlich unbekannter Charakteristica dieser Daten wird hingewiesen. So hat z.B. die Genauigkeit vieler Atomgewichte abgenommen, da die Angabe der in den Veröffentlichungen angegebenen Dezimalstellen nicht mehr gerechtfertigt ist. Außerdem beginnen geologische und künstliche Veränderungen in der Isotopenzusammensetzung die Atomgewichte einiger Elemente, die in Reagentien verwendet werden, zu beeinflussen. Der Analytiker sollte darauf achten. Die Vorstellung von Atomgewichten und natürlichen Isotopenhäufigkeiten als grundlegenden Naturkonstanten sollte aufgegeben werden.

Associate Member of the IUPAC International Commission on Atomic Weights.     

Effects of <Emphasis Type="Italic">L</Emphasis>-Carnitine on Sucrose-Induced Hyperlipidaemia

Summary. L-Carnitine, L-(−)-β-hydroxy-γ-trimethylaminobutyrate, plays an important role as a factor necessary for the transport of long-chain fatty acids into the mitochondria. In order to investigate the influence of L-carnitine on hyperlipidaemias, the experimental model of the sucrose-induced hypertriglyceridaemia of the rat was used. In these experiments L-carnitine in the dose of 11 mg per day and 100 g body weight (over the period of 1 week) was able to antagonize the sucrose-induced hypertriglyceridaemia and the increase of serum free fatty acid level in female rats of the Wistar strain. Carnitine administration did not change the activities of lipogenic enzymes and fatty acid synthesis in the liver. However, L-carnitine increases the rate of hepatic fatty acid oxidation. Our results indicate a hypotriglyceridemic and free fatty acid lowering effect of L-carnitine, and suggest the use of this compound in the therapy of hyperlipidaemias.     

Characterisation of fatty acids in biological oil samples using comprehensive multidimensional gas chromatography

Comprehensive multidimensional gas chromatography can adequately resolve very complex mixtures of analytes such as the fatty acid mixtures which are contained in, e.g., fish and vegetable oils. Well-ordered patterns are obtained in the two-dimensional separation plane which can be used to tentatively identify peaks when no standard is available. The technique which can also be used for quantification, i.e., quantitative ratio analysis, should be especially useful for fingerprinting purposes. Unravelling the composition of complex mixtures such as fish oils appears to be highly rewarding.     

Modified sampling and analysis method for large volatility range airborne polycyclic aromatic hydrocarbons (PAH) using gas chromatography-mass spectrometry

A sampling method has been developed for the measurement for polycyclic aromatic hydrocarbons in ambient air by gas chromatography isotope dilution mass spectrometry. The method has been designed to measure the largest possible volatility range of PAHs including the abundant naphthalenes. Sample volumes were approx. 500 m³ in size at a sampling rate of approx. 18 m³/h. The sampler contained three sorption stages for the simultaneous capturing of particle bound and low and high volatile gaseous PAH, respectivley. Recoveries of sampling spikes were on average 90%. The detection limit was approx. 5 pg/m³ for the high boiling range PAH. Results obtained showed a quite steady profile for most PAH in background air in The Netherlands. Comparison of abundance ratios with literature data indicate that traffic exhausts are the major source for the PAH in the area.     

PROFLAVINE MEDIATED PHOTOINACTIVATION OFBACTERIOPHAGE φX174 AND ITS ISOLATED DNA: EFFECTS OF AGENTS MODIFYING VARIOUS PHOTOCHEMICAL PATHWAYS

Abstract. Thiols and disulfides protect both φX174 phage and its isolated DNA from the lethal action of proflavine plus light. The protective ability of these compounds appears to be attributed to the -SH or the -S-S- group and the property to interact with the proflavine-phage DNA complex. The phage inactivation efficiency per proflavine bound to DNA is reduced by 50 to 30% upon addition of cysteine or cystamine. Substances that affect the lifetime of singlet oxygen modify the rate of phage photoinactivation in the presence of proflavine; the inactivation rate is decreased by N^-₃ and increased by D₂O. Irradiation under N₂ atmosphere markedly decreases the phage photosensitization by proflavine. Irradiation with monochromatic light of 440 nm is less efficient than irradiation with light of 440 nm plus 360 nm, and the difference is more pronounced in N₂ than in air. These results are discussed in relation to various possible photochemical pathways.     

Automated chemical separations in routine activation analysis

In recent years increased information is required about the distribution of elements at low concentration levels in the biosphere. Neutron activation analysis can play an important role if it can supply many data at relatively low cost. As some of the concentrations are too low for determination by non-destructive techniques, equipment for chemical separations on a routine basis is necessary. For environmental studies a separation scheme has been developed successfully for arsenic, antimony, cadmium, copper, mercury, selenium and zinc. It is based on a combination of distillation and ion-exchange. Special attention is paid to the prevention of interference from bromine and sodium. Additional information about chromium, cobalt, nickel and tungsten can easily be obtained. Experience gathered with an automated instrument for fifty samples a week is described.