Vibrationally resolved rate coefficients and branching fractions in the dissociative recombination of O2+

We have studied the dissociative recombination of the first three vibrational levels of O(2) (+) in its electronic ground X (2)Pi(g) state. Absolute rate coefficients, cross sections, quantum yields and branching fractions have been determined in a merged-beam experiment in the heavy-ion storage ring, CRYRING, employing fragment imaging for the reaction dynamics. We present the absolute total rate coefficients as function of collision energies up to 0.4 eV for five different vibrational populations of the ion beam, as well as the partial (vibrationally resolved) rate coefficients and the branching fractions near 0 eV collision energy for the vibrational levels v=0, 1, and 2. The vibrational populations used were produced in a modified electron impact ion source, which has been calibrated using Cs-O(2)(+) dissociative charge transfer reactions. The measurements indicate that at low collision energies, the total rate coefficient is weakly dependent on the vibrational excitation. The calculated thermal rate coefficient at 300 K decreases upon vibrational excitation. The partial rate coefficients as well as the partial branching fractions are found to be strongly dependent on the vibrational level. The partial rate coefficient is the fastest for v=0 and goes down by a factor of two or more for v=1 and 2. The O((1)S) quantum yield, linked to the green airglow, increases strongly upon increasing vibrational level. The effects of the dissociative recombination reactions and super elastic collisions on the vibrational populations are discussed.     

Determination of non-steroidal anti-inflammatory drugs in sewage sludge by direct hollow fiber supported liquid membrane extraction and liquid chromatography–mass spectrometry

In this study, a three-phase hollow fiber liquid-phase microextraction (HF-LPME) method combined with liquid chromatography–mass spectrometry was developed for direct determination of four non-steroidal anti-inflammatory drugs (ketoprofen, naproxen, diclofenac and ibuprofen) in sewage sludge. The drugs were extracted from non-spiked and spiked slurry samples with different amounts of sludge into an organic phase and then back-extracted into an aqueous phase held in the lumen of the hollow fiber. High enrichment factors ranging from 2761 to 3254 in pure water were achieved. In sludge samples, repeatability and inter-day precision were tested with relative standard deviation values between 10–18% and 7–15%, respectively. Average concentrations of 29 ± 9, 138 ± 2, 39 ± 5 and 122 ± 7 ng/g were determined in dried sludge from Källby sewage treatment plant (Sweden) for ketoprofen, naproxen, diclofenac and ibuprofen, respectively.     

Visualization of structural changes in cellulosic substrates during enzymatic hydrolysis using multimodal nonlinear microscopy

Enzymatic hydrolysis of cellulose provides a renewable source of monosaccharides for production of variety of biochemicals and biopolymers. Unfortunately, the enzymatic hydrolysis of cellulose is often incomplete, and the reasons are not fully understood. We have monitored enzymatic hydrolysis in terms of molecular density, ordering and autofluorescence of cellulose structures in real time using simultaneous CARS, SHG and MPEF microscopy with the aim of contributing to the understanding and optimization of the enzymatic hydrolysis of cellulose. Three cellulose-rich substrates with different supramolecular structures, pulp fibre, acid-treated pulp fibre and Avicel, were studied at microscopic level. The microscopy studies revealed that before enzymatic hydrolysis Avicel had the greatest carbon-hydrogen density, while pulp fibre and acid-treated fibre had similar density. Monitoring of the substrates during enzymatic hydrolysis revealed the double exponential SHG decay for pulp fibre and acid-treated fibre indicating two phases of the process. Acid-treated fibre was hydrolysed most rapidly and the hydrolysis of pulp fibre was spatially non-uniform leading to fractioning of the particles, while the hydrolysis of Avicel was more than an order of magnitude slower than that of both fibres.     

Determination of C1−C4 fatty acids as p-bromophenacyl esters using glass-capillary gas chromatography and electron-capture detection

Summary A method for the determination of low relative molecular mass carboxylic acids (C₁–C₄) in water is reported. The acids are converted to p-bromophenacyl esters prior to a glass-capillary gas chromatographic separation. By utilizing electron-caputre detection the detectability is substantially improved compared to flame-ionization detection. A comparison of three different ways to treat the water samples and to produce the derivatives is made. It is shown that the , p-dibromoacetophenone reagent decomposes to a small extent which limits the utility of the reagent. Nevertheless a detection limit for formic acid of approximately 2.5 mgl^–1 is obtained. The method is applied to the determination of formic and acetic acids in a paper kraft water sample.     

Effects of feedback from collimating, focusing, and spot-array generating outcoupler gratings in surface-emitting semiconductor lasers

We experimentally demonstrate that a grating outcoupler used for complex beam shaping (spot-array generation) can produce unintentional optical feedback that severely disturbs the integrated in-plane laser that illuminates the coupler. Simulations show that these outcouplers, in contrast to conventional collimating or focusing outcouplers, tend to produce high levels of feedback in spite of the detuning used to suppress feedback. Further, this feedback is focused to high intensity in the laser gain medium. This focused light acts as a seed for the nonlinear self-focusing that causes wave-front distortion and filamentation, which degrades the beam quality.     

Direct observation of a self-assembled monolayer of heptyl xanthate at the germanium/water interface: a polarized FTIR study

The adsorption of heptyl xanthate on germanium has been studied by the attenuated total reflection (ATR) technique. Polarized infrared light was used in situ to determine the average orientation of the alkyl chain in heptyl xanthate adsorbed at the germanium/solution interface. Spectra reveal the formation of closely packed xanthate ions with the alkyl chains in the all-trans conformation. The average tilt angle of the alkyl chains of heptyl xanthate was approximately 47 degrees from the surface normal.     

Subpicosecond hard x-ray streak camera using single-photon counting

We have developed and characterized a hard x-ray accumulating streak camera that achieves subpicosecond time resolution by using single-photon counting. A high repetition rate of 2 kHz was achieved by use of a readout camera with built-in image processing capabilities. The effects of sweep jitter were removed by using a UV timing reference. The use of single-photon counting allows the camera to reach a high quantum efficiency by not limiting the divergence of the photoelectrons.     

Hollow fiber liquid phase microextraction as a preconcentration and clean-up step after pressurized hot water extraction for the determination of non-steroidal anti-inflammatory drugs in sewage sludge

A method for the quantitative determination of non-steroidal anti-inflammatory drugs (NSAIDs) in sewage sludge was developed and validated. The target compounds were extracted using pressurized hot water extraction (PHWE) and then purified and preconcentrated by three-phase hollow fiber liquid phase microextraction (HF-LPME) followed by LC–ESI-MS analysis. The PHWE was optimized with regard to the pH of solvent as well as other operational parameters. The optimum conditions were 0.01 M NaOH as the extraction solvent, temperature of 120 °C, pressure of 100 bar, static time 5 min, 5 cycles, flush volume 90% and purge time 60 s. Spike recoveries for sludge samples spiked at 200 ng g⁻¹ were in the range of 101–109% but for the native drugs in non-spiked sludge samples, recoveries were 38.9%, 59.8%, 90.3% and 47.8% for ketoprofen, naproxen, diclofenac and ibuprofen, respectively. Donor phase pH, ionic strength and extraction time were optimized for HF-LPME after PHWE. The optimum conditions were 2 h extraction at pH 1.5 without salt addition. Enrichment factors in the range of 947–1213 times were achieved (extraction recoveries were 23.6–30.3%) for HF-LPME after PHWE. The matrix effect on the ionization of drugs in LC–ESI-MS was also investigated. The results show that there is a smaller matrix effect (−8.9% to +14.6%) in comparison with other published values obtained using solid phase extraction (SPE) for clean-up after pressurized liquid extraction (PLE). Method detection limits (MDLs) and method quantification limits (MQLs) for different drugs were in the range of 0.4–3.7 ng g⁻¹ and 1.5–12.2 ng g⁻¹ in dried sludge samples, respectively. The characteristics of the proposed method were compared with those of other published works. The considerably lower ion suppression/enhancement and minimum use of organic solvents (a few microliters of di-n-hexyl ether) in the sample preparation step are two highlighted advantages of the proposed method in comparison with previously published works. The method was applied to determine NSAIDs in sewage sludge from Källby wastewater treatment plant (Lund, Sweden) in April, June, August and October 2010. The highest concentration level was recorded for ibuprofen in the April sewage sludge sample (588 ng g⁻¹) and all of the selected NSAIDs were detected in all the samples analyzed.     

Topochemical acetylation of cellulose nanopaper structures for biocomposites: mechanisms for reduced water vapour sorption

Moisture sorption decreases dimensional stability and mechanical properties of polymer matrix biocomposites based on plant fibers. Cellulose nanofiber reinforcement may offer advantages in this respect. Here, wood-based nanofibrillated cellulose (NFC) and bacterial cellulose (BC) nanopaper structures, with different specific surface area (SSA), ranging from 0.03 to 173.3 m²/g, were topochemically acetylated and characterized by ATR-FTIR, XRD, solid-state CP/MAS ¹³C-NMR and moisture sorption studies. Polymer matrix nanocomposites based on NFC were also prepared as demonstrators. The surface degree of substitution (surface-DS) of the acetylated cellulose nanofibers is a key parameter, which increased with increasing SSA. Successful topochemical acetylation was confirmed and significantly reduced the moisture sorption in nanopaper structures, especially at RH = 53 %. BC nanopaper sorbed less moisture than the NFC counterpart, and mechanisms are discussed. Topochemical NFC nanopaper acetylation can be used to prepare moisture-stable nanocellulose biocomposites.     

Interpolation of coefficients and transformation of the dependent variable in finite element methods for the non-linear heat equation

Error estimates are shown for some spatially discrete Galerkin finite element methods for a non-linear heat equation. The approximation schemes studied are based on the introduction of the enthalpy as a new dependent variable, and also on the application of the Kirchhoff transformation and on interpolation of the non-linear coefficients into standard Lagrangian finite element spaces.