Design and synthesis of Ru(II-bipyridyl-containing conjugated polymers

A series of novel π-conjugated polymers containing ruthenium bipyridine complexes was synthesized by a cross-coupling reaction and characterized. These polymers exhibit absorption maxima around 330–350 nm (π-π*) and 460–500 nm metal-to-ligand charge transfer (MLCT), respectively. They are soluble in common organic solvents, and all polymers can be converted into transparent films. We investigated the influence of different donating and acceptor diethynylarenes of the ultraviolet-visible spectra. The oxidation potential, which was measured by cyclic- and square-wave voltametry, showed a typical Ru^2+/3+ exhibited at 1.25 V versus the saturated calomel electrode. The polymers were further characterized with photoluminescence measurements. When excited at 442 nm ( 11a ), the polymer exhibited an emission peak at 690 nm. This peak was attributed to the MLCT states. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 722–732, 2004     

N-Vinyl as N-H protecting group. Synthesis of cyclic imines from N-vinyllactams and organolithium reagents

On reaction with organolithium reagents followed by hydrolysis and distillation, N-vinylpyrrolidone ( 1 ) gives five-membered ring imines 3-8 , whereas N-vinylcaprolactam ( 2 ) gives mixtures of seven-membered ring imines and the corresponding ∈-amino ketones.     

A new general-purpose isothermal microcalorimeter for use at temperatures up to 200 °C

The design and some properties of a new general-purpose isothermal microcalorimeter are reported. The instrument is a twin thermopile heat conduction calorimeter, which is designed for use up to 200 °C. The calorimetric units and surrounding heat sink are suspended inside a hollow aluminium construction, which is thermostated. Above that unit a second thermostated block is positioned and the whole assembly is suspended inside a Dewar vessel. When the instrument is used at room temperature and below, the thermostated units are cooled by use of an insertion Peltier effect cooler. The instrument can be used with a wide range of different reaction vessels (diameter 14 mm). Baseline experiments have been conducted in the temperature range 15-200 °C. Typical values obtained during 10 h periods at 200 °C are ±3 and ±10 nW for the baseline drift and baseline fluctuations, respectively. The heat detection limit, determined by release of electrical energy, is about 2 μJ. Preliminary stability measurements have been conducted at 100 °C on samples of stabilised and non-stabilised polyamide film.     

FLUORESCENCE PROPERTIES OF PORPHYRIN-GLOBIN FROM HUMAN HEMOGLOBIN

Fluorescence excitation and emission spectra, decays, and quantum yields are reported for the porphyrin-globin of hemoglobin (Hb^desFe) in aqueous solution of pH 8, at 4°C. A very weak fluorescence was observed in the UV (maximum at 334 nm), due to tryptophan and tyrosine residues, in addition to the strong porphyrin emission in the visible (maxima at 624 and 692 nm) reported previously. The absorption and fluorescence properties of the porphyrins of Hb^desFe were compared to those for free porphyrin in organic solvents and in aqueous solution. The close similarity of the fluorescence decays and quantum yields in Hb^desFe and in solution indicate the absence of stronger, specific porphyrin-protein interactions; however, slight spectral shifts point to the existence of water molecules in the Hb^desFe porphyrin environment. The fluorescence study also demonstrates the existence of efficient Trp-porphyrin energy transfer of Förster type. The extent of transfer is in satisfactory agreement with the value expected from crystallographic data for hemoglobin. The results are discussed and compared to previous fluorescence studies of hemoglobin and apohemoglobin. An improved method for the preparation of Hb^desFe is reported.     

Hopf algebroids and H-separable extensions

Since an H-separable extension is of depth two, we associate to it dual bialgebroids and over the centralizer as in Kadison-Szlachányi. We show that has an antipode and is a Hopf algebroid. is also Hopf algebroid under the condition that the centralizer is an Azumaya algebra over the center of . For depth two extension , we show that .

     

Gas-phase and catalytic combustion in heat-recirculating burners

An experimental study of a spiral counterflow “Swiss roll” burner was conducted, with emphasis on the determination of extinction limits and comparison of results with and without bare-metal Pt catalyst. A wide range of Reynolds numbers (Re) were tested using propane–air mixtures. Both lean and rich extinction limits were extended with the catalyst, though rich limits were extended much further. With the catalyst, combustion could be sustained at Re as low as 1.2 with peak temperatures as low as 350 K. A heat transfer parameter characterizing the thermal performance of both gas-phase and catalytic combustion at all Re was identified. At low Re, the “lean” extinction limit was actually rich of stoichiometric, and rich-limit had equivalence ratios exceeded 40 in some cases. No corresponding behavior was observed without the catalyst. Gas-phase combustion, in general, occurred in a “flameless” mode near the burner center. With or without catalyst, for sufficiently robust conditions (high Re, near-stoichiometric) not requiring heat recirculation, a visible flame would propagate out of the center, but this flame could only be re-centered if the catalyst were present. Gas chromatography indicated that at low Re, even in extremely rich mixtures, CO and non-propane hydrocarbons did not form. For higher Re, where both gas-phase and catalytic combustion could occur, catalytic limits were slightly broader but had much lower limit temperatures. At sufficiently high Re, catalytic and gas-phase limits merged. It is concluded that combustion at low Re in heat-recirculating burners greatly benefits from catalytic combustion with the proper choice of mixtures that are different from those preferred for gas-phase combustion. In particular, the importance of providing a reducing environment for the catalyst to enhance O₂ desorption, especially at low Re where heat losses are severe thus peak temperatures are low, is noted.     

Experimental determination of isotope shifts in Mg I

The isotope shift in the Mg l transitionsλλ 5167, 5172 and 5183Å (3s3p ³ P-3s4s ³ S) andλ 5528 Å (3s3p ¹ P 3s4d ¹ D) has been measured for the isotopes²⁴Mg,²⁵Mg and²⁶Mg. The hyperfine structure of theλ 5167 Å line has been studied and theA andB factors for the 3s4s ³ S ¹ level in²⁵Mg determined. The measurements were made with separated isotopes using a scanning Fabry-Perot interferometer.     

Programmable interferometry

The advent of automatic data-processing for interferometry greatly reduced the complexity of interferometric testing, thereby significantly increasing its usage both within and outside the optics community. A great many of these new applications require special data-processing and output data not normally used for testing lenses. To address these new measurement problems, many data-analysis programs were written, ranging from advanced analysis of wavefronts (i.e., Zernike polynominals, point-spread function, modulation-transfer function) to analysis of mechanical surfaces, such as Winchester-disk read/write heads. Some of these programs were very specific to a particular application, and some tried to be general and as such became cumbersome. Even with much of this software available for sale to the general public, most applications other than simple surface and lens measurements usually cannot be solved directly by using the available programs. In an attempt to solve this problem, we have developed software for interferometry that allows users to easily develop their own measurement routines. The solution was to take a version of the BASIC programming language and add the commands necessary to do interferometry. This software is resident in a processor that can easily be adapted to a large number of interferometry applications. By using this processor and its associated software with an appropriate interferometer, it is possible for the user to tailor the measurement to a particular application. This can be very useful in an optical-production shop, where each different testing application can have its own program. If the program is written properly, the operator will not have to set up any default conditions or format the output; the operation of the program can be reduced to the pushing of a single button, and the output will be formatted properly for that particular test. Examples of this system in actual optical shop-testing situations will be discussed.     

Non-perturbative approach to high-index-contrast variations in electromagnetic systems

We present a method that formally calculates exact frequency shifts of an electromagnetic field for arbitrary changes in the refractive index. The possible refractive index changes include both anisotropic changes and boundary shifts. Degenerate eigenmode frequencies pose no problems in the presented method. The approach relies on operator algebra to derive an equation for the frequency shifts, which eventually turn out in a simple and physically sound form. Numerically the equations are well-behaved, easy implementable, and can be solved very fast. Like in perturbation theory a reference system is first considered, which then subsequently is used to solve another related, but different system. For our method precision is only limited by the reference system basis functions and the error induced in frequency is of second order for first-order basis set error. As an example we apply our method to the problem of variations in the air-hole diameter in a photonic crystal fiber.