模拟退火法在吸收薄膜的椭偏反演算法中的应用

将一种广泛用于求解复杂系统优化问题的技术－－模拟退火法－－用来求解椭偏反演方程。首先假设一个薄膜模型，计算出其相应的椭偏参数（Ψ，Δ）的值，在这个计算值的基础上加入不同标准偏差的高斯噪声；然后将加入噪声后的值（Ψm,Δm)作为模拟的测量数据，采用模拟退火算法进行求解，验证得知这种方法求得的薄膜参数很接近于假设的薄膜模型参数的真值，与其他文献的报道结果一致，而且在扩大搜寻范围时，仍然可以得到准确解，从而证明了该方法的可行性以及有效性。     

一种非连续纳米氧化层自旋阀的显微结构研究

利用高分辨电子显微学方法(HREM)研究了纳米氧化层镜面反射自旋阀多层结构Ta(35nm)Ni80Fe20(2nm)Ir17Mn83(6nm)Co90Fe10(15nm)NOL1Co90Fe10(2nm)Cu(22nm)Co90Fe10(15nm)NOL2Ta(3nm).该自旋阀的巨磁电阻(GMR)效应高达15%,较无此镜面反射纳米氧化层(NOL)的自旋阀提高近1倍,同时交换偏置场亦有所增强.高分辨显微结构分析表明,介于钉扎层与被钉扎层之间的氧化层(NOL1)并未完全氧化,即除氧化过程生成的CoFe氧化物 关键词： 自旋阀 纳米氧化层 高分辨电子显微学 巨磁电阻效应     

First-principles investigation of the elastic and electronic properties of the binary intermetallics in the Al–La alloy system

The structural, elastic and electronic properties of Al₂La, AlLa₃ and Al₃La binary intermetallics in the Al–La alloy system were investigated using the first-principles method. The calculated lattice constants were consistent with the experimental values. Formation enthalpy and cohesive energy showed that the studied Al₂La, AlLa₃ and Al₃La all have a higher structural stability, and the alloying ability of Al₂La and Al₃La is stronger than that of AlLa₃. The single-crystal elastic constants (C_ij) as well as polycrystalline elastic parameters (bulk modulus B, shear modulus G, Young's modulus E, Poisson's ratio υ and anisotropy value A) were calculated by the Voigt–Reuss–Hill (V–R–H) approximations, and the relationship of these elastic parameters between Al₂La, AlLa₃ and Al₃La phases were discussed in detail. The results showed that Al₂La and Al₃La which are anisotropic materials are absolutely brittle, while the isotropic AlLa₃ is slightly ductile. Finally, the electronic density of states (DOS) was also calculated to reveal the underlying mechanism of structural stability.     

Electronic structure of PCBM

We have studied the electronic structure of [6,6]-phenyl-C₆₁-butyric-acid-methyl-ester (PCBM) using synchrotron radiation photoelectron spectroscopy (PES) measurements and first-principles calculations. The PES spectrum of the entire occupied valence band is reported, which exhibits abundant spectral features from the Fermi level to ～24 eV binding energy. All the spectral features are broadened as compared with the cases of C₆₀. The reasons for the broadening are analysed by comparing the experimental data with the calculated energy levels and density of states. Special attention is paid to the analysis of the C₆₀ highest occupied molecular orbital (HOMO)-1 derived states, which can play a crucial role in the bonding at the interfaces of PCBM/polymer blenders or PCBM/electrodes. Besides the well-known energy level splitting of the C₆₀ backbone caused by the lowered symmetry, C 2p states from the side chain mix or hybridize with the molecular orbitals of parent C₆₀. The contribution of the O 2p states can substantially modify the PES spectrum.     

用束流位置监测器测量上海光源束流寿命

通过理论分析研究了电磁耦合型束流位置探测器（BPM）用于束流寿命测量的可行性,并在上海光源储存环上进行了束流实验,对其性能进行了评估。实验结果表明,与目前常用的直流流强变压器（DCCT）系统相比,BPM给出的束流寿命具有更高的带宽和分辨力,有利于进行不同时间尺度的束流寿命评估,而且可以通过多个平均的方式来进一步提高测量精度。     

强激光能源系统的Marx触发器

针对强激光能源系统对Marx触发器的输出性能和可靠性要求,介绍了一种六级的Marx触发器。通过采用多级低电感脉冲形成电路获得了高幅值、陡前沿的输出脉冲,运用实验与概率分析相结合的方法,确定了它的工作参数。实验研究结果表明:这种Marx触发器的误触发率和触发气体开关成功率均符合两参数的威布尔概率分布;当欠压比为65%、工作电压为13.5 kV、工作气压（绝压）为0.35 MPa时,能输出幅值120 kV、前沿20 ns的电压脉冲;该触发器能同时满足误触发率低于0.000 1%,正常触发成功率高于99.999 9%的技术要求。经过长时间现场运行测试,Marx触发器工作良好,无异常现象。     

Design of a reentrant double staggered ladder circuit for V-band coupled-cavity traveling-wave tube

The reentrant double staggered ladder slow-wave structure is employed in a high-power V-band coupled-cavity traveling-wave tube. This structure has a wide bandwidth, a moderate interaction impedance, and excellent thermal dissipation properties, besides the easy fabrication. A well-matched waveguide coupler is proposed for the structure. Combining the design of attenuators, a full-scale three-dimensional circuit model for the V-band coupled-cavity traveling-wave tube is constructed. The electromagnetic characteristics and the beam--wave interaction of this structure are investigated. The beam current is set to be 100 mA, and the cathode voltage is tuned from 16.8 kV to 15.8 kV. The calculation results show that this tube can produce a saturated average output power over 100 W with an instantaneous bandwidth greater than 1.25 GHz in the frequency ranging from 58 GHz to 62 GHz. The corresponding gain and electronic efficiency can reach over 32 dB and 6.5%, respectively.     

FeAl(B2) 合金La, Ac, Sc 和 Y 元素微合金化的第一性原理研究

采用基于密度泛函理论的第一性原理计算方法, 研究了稀土元素(La, Ac, Sc 和 Y) 微合金化对FeAl (B2) 有序金属间化合物合金晶体结构、 弹性和电子性能的影响. 计算结果表明: 稀土元素Y 易于取代Fe位, 而Sc, La和Ac易于取代Al位, 其中Ac元素的加入使晶格点阵发生最大的变形. 弹性性能的计算表明La, Ac, Sc 和 Y 元素的加入可以改善FeAl (B2) 的塑性, 其中Fe₇Al₈Sc具有最好的塑性和硬度. 稀土元素对合金性能的影响, 主要是由于稀土原子的加入改变了Fe和Al电子之间的杂化作用. 计算结果与已有的试验结果和理论结果相一致.