Construction and cosmic-ray test of the new inner drift chamber for BESIII

A new inner drift chamber has been built which can replace the aged part of the BESIII drift chamber when needed. The design of the new inner drift chamber can minimize the ineffective area in the very forward and backward region and hence reduce the background event rate. With this design, the new inner drift chamber is expected to have a longer lifetime and improved performance due to the lower occupancy. The endplates and the cylinder were machined with high precision. Wire stringing was performed after the mechanical structure was assembled, and good quality of wire stringing was ensured by measurement of the tension and leakage current of the wires. After completion of the physical construction of the new chamber, a cosmic-ray test was carried out to test its performance. The results of the cosmic-ray test show that the new inner chamber achieves a spatial resolution of127 μm and a d E/dx resolution of 6.4%, which satisfies the design specifications.     

Spatial Chaos of Bose-Einstein Condensates in a Cigar-Shaped Trap

The spatial chaos of Bose-Einstein condensates in a cigar-shaped trap is studied. For a system with a steady current, we construct the general solution of the 1st-order equation. From the boundedness condition of the general solution, we obtain the Melnikov function predicting the onset of chaos. The unpredictability of the system's distribution of atom density is also theoretically analyzed. For a 23Na system meeting the perturbation condition, numerical simulations show the existence of chaos, which is in accordance with our analytical results. Numerical simulations of a 87 Rb system dissatisfying the perturbation condition also demonstrate that there exists chaos in the system. The case without a current is also investigated.     

Population transfer in multilevel system through modified stimulated Raman adiabatic passage

Stimulated Raman adiabatic passage (STIRAP) has been successfully extended to multilevel system. During the STIRAP process, the intermediate levels have notable population which is detrimental if these levels could decay to other levels through spontaneous emission. This paper proposes a novel method to reduce the intermediate level population during the STIRAP process. A complete population transfer can be achieved in this modified STIRAP even if the intermediate level decays to other levels.     

水平管段塞流持液率波动规律研究

以空气和水为工质,采用双平行电导探针,在水平多相流环道(d=50.00mm)中研究了段塞流持液率与压力波动的关系以及折算气速、折算液速变化对持液率的影响,并将持液率的试验值与预测模型进行了比较.结果表明:持液率波动能更真实地反映段塞流动特性,可以用来确定液塞频率;增加折算气速时,液塞持液率减小;增加折算液速时,持液率增大.     

米散射理论在新型导光板中的应用

根据米散射理论,提出了新型导光板的设计思路,计算并分析了对于一定波长的入射光,不同粒径的微粒的散射特性。总结了随着微粒粒径的变化,散射效率、消光效率与背向散射效率的变化规律,分析了散射过程中的偏振度随粒子粒径几散射角变化的情况,同时模拟计算了多个微粒对同一波长的入射光经过多次散射后的概率统计结果。     

裂缝性应力敏感油藏流固耦合的数值模拟

以裂缝各向异性全张量渗透率动态耦合渗流模型为基础,建立三维三相裂缝各向异性特低渗透油藏流固耦合数学模型,并运用模块化显示耦合迭代求解建立流固耦合渗流数值模拟方法,编制耦合求解程序.研究表明:对于裂缝性油藏,随着油藏开采过程中压力的变化,岩石变形和储层介质的各向异性应变特性使开发过程中多组裂缝的变形程度不同,引起裂缝渗透率的非线性变化,进而使油藏裂缝渗透率张量主值发生旋转,改变液流方向、影响油藏开发效果.     

基于遗传LM算法的涂层目标光谱偏振BRDF建模分析

通过比较测量方法测量得到绿漆涂层木板探测目标在400～720 nm的光谱偏振二向反射分布函数值,从获得的户外试验测量数据入手,分析与探测角、波长之间的关系,通过有限探测条件得到的光谱偏振二向反射分布函数值(BRDF)建立光谱偏振BRDF模型,来描述探测目标的偏振二向反射特性。其中利用基于小面元的模型建立光谱偏振BRDF模型,利用遗传算法和Levenberg-Marquardt(LM)算法相结合的优化算法来获得非线性模型参数。仿真实验结果表明采用的遗传LM优化算法具有较好的性能,能较快较准确得到非线性的模型参数。真实实验数据证明了基于小面元模型的正确性,表明光谱偏振二向反射分布函数建模方法结果的可靠性。最后与绿漆涂层铁板目标的模型反演参数进行比较得出：2种不同材质、相同颜色涂层的目标,具有较为接近的折射率,其较小差别可以理解为由涂层的厚度、均匀程度的不同导致,而非不同的材质所引起。     

Full utilization of a mass spectrometer using on-demand sharing with multiple LC units

The applicability of liquid chromatography-mass spectrometry (LC/MS) is often limited by throughput. The sharing of a mass spectrometer with multiple LCs significantly improves throughput; however, the reported systems have not been designed to fully utilize the MS duty cycle, and as a result to achieve maximum throughput. To fully utilize the mass spectrometer, the number of LC units that a MS will need to recruit is application dependent and could be significantly larger than the current commercial or published implementations. For the example of a single analyte, the number may approach the peak capacity to a first degree approximation. Here, the construction of a MS system that flexibly recruits any number of LC units demanded by the application is discussed, followed by the method to port a previously developed LC/MS method to the system to fully utilize a mass spectrometer. To demonstrate the performance and operation, a prototypical MS system of eight LC units was constructed. When 1-min chromatographic separations were performed in parallel on the eight LCs of the system, the average LC/MS analysis time per sample was 10.5 s when applied to the analysis of samples in 384-well plate format. This system has been successfully used to conduct large-volume biochemical assays with the analysis of a variety of molecular entities in support of drug discovery efforts. Allowing the recruitment of the number of LC units appropriate for a given application, this system has the potential to be a plug-and-play system to fully utilize a mass spectrometer. Copyright ? 2012 John Wiley & Sons, Ltd.     

高温超导薄膜在微波双工器上的应用

本文采用全波电磁仿真方法设计、制作并测试了一种工作于C波段的星载高温超导微波双工器,采用的材料是在厚度为0.5mm介电常数为23.5的LaAlO3衬底上用磁控溅射法制备而成的双面氧化物高温超导薄膜YBCO.利用在微波范围内,高温超导薄膜的Q值比常规导体高1～3个数量级的特点,实现了器件的小型化和低插损.     

高温超导窄带广义切比雪夫函数滤波器

提出了一种用于高温超导滤波器制作的新结构窄带广义切比雪夫函数高、低通滤波器级联方式.该方式利用高温超导低插损特性,可以有效地降低极陡峭广义切比雪夫函数低通、高通滤波器的带边频滚降.依靠高、低通滤波器级联方式构建新形式的窄带极陡峭低插损高温超导滤波器,并与已有高温超导滤波器进行了比较分析.