C60和C60／C70的激光脱附飞行时间质谱分析

采用激光脱附并直接测量离子的方法对实验室提取的C_(60)/C_(70)以及进一步分离得到的纯C_(60)进行了飞行时间质谱分析,并讨论了质谱分析过程中实验条件对结果的影响.     

FORMATION OF A BURIED LAYER OF ALUMINIUM NITRIDE BY HIGH DOSE N2+ IMPLANTATION INTO ALUMINIUM

Aluminium films with various thickness between 700 nm and 1μm were deposited on Si (100) substrates, and 400 keV N₂⁺ ions with doses ranging from 4.3×10¹⁷ to 1.8×10¹⁸ N/cm² were implanted into the alu-minium films on silicon, Rutherford Backscattering (RBS) and channeling, secondary ion mass spectroscopy (SIMS), Fourier transform infrared spectra (FTIR), X-ray diffraction (XRD), transmission electron microscopy (TEM) and spreading resistance probes (SRP) were used to characterize the synthesized aluminium nitride. The experiments showed that when the implantation dose was higher than a critical dose N_c, a buried stoichiometric AlN layer with high resistance was formed, while no apparent AlN XRD peaks in the as-implanted samples were observed; however, there was a strong AlN(100) diffraction peak appearing after annealing at 500 ℃ for 1h. The computer program, Implantation of Reactive Ions into Silicon (IRIS), has been modified and used to simulate the formation of the buried AlN layer as N₂⁺ is implanted into aluminium. We find a good agreement between experimental measurements and IRIS simulation.     

STUDY ON PREPARATION OF UV CROSS-LINKING FILMS OF POLYURETHANE-LiClO4 COMPLEXES AND THEIR IONIC CONDUCTIVITY

The complexes of polyurethane containing double bonds with LiClO₄ were formed, and cross-linked films were produced by UV radiation, All of the films were uniform, transparent, flexible and smooth-faced with a considerable mechanical strength. The ionic conductivities of the films of several series of polymers with different molecule weights of PEG segment were measured, of which the highest is 8.09×10^-5S·cm^-1 at 300K under anhydrous atmosphere. Also the conductivity is deeply influenced by the molecule weight of the soft segment PEG of the polyurethane and the content of LiClO₄. The transport number of Li⁺ is about 0.57. Structure characteristic measurement much as DSC, XRD, IR etc., have been done and the conductive mechanism is discussed.     

Mg原子振子强度与能级寿命的势模型计算

本文用一种有解析形式的势模型波函数计算了Mg原子的振子强度和能级寿命,并与实验和其他理论计算结果作了比较。结果表明对于Mg原子大量组态混合程度很弱的态,用单组态波函数进行计算是完全可行的。     

非等强度,等脉冲相关技术测量甲酚紫染料的吸收恢复时间

利用非等强度、等脉冲相关技术测量甲酚紫染料吸收恢复时间。实验结果给出了甲酚紫染料吸收恢复时间为158ps。     

“干涉逼近法”测量液体折射率

提出了一种高精度测量液体折射率的新方法一“干涉逼近法”.这种方法可以在测量过程中监视被测液体温度不均匀性给测量带来的误差.由于受温度测量的限制,其测量液体折射率的不确定度在1×10~(-6)到4×10~(-5)(2σ)之间,具体值取决于液体折射率的温度系数.     

多位数序列全加器的光电混合实现

本文报道用光不双稳开关构成多位数序列全加器的方法，并用非线性干涉滤光片双稳开关进行了原理性实验演示，完成了四位二进制数的全加运算。     

相位共轭皮秒光脉冲的直接观察和记录

利用条纹照相机直接观察和记录了由全息相位共轭技术产生的相位共轭的皮秒光脉冲。实验结果与理论相符合。 关键词：     

基于随机效应Wiener退化模型的剩余寿命预测

针对退化率较高的产品具有不稳定的退化路径以及产品个体差异对退化过程的影响,建立了一种新的随机效应退化模型,即漂移参数和扩散参数均为随机变量且两者之间呈线性关系的Wiener退化过程模型.基于该模型获得了产品剩余寿命分布与可靠度函数,同时设计了估计模型参数的EM（expectation maximization）算法.最后,通过分析钛合金疲劳裂纹数据以及与现有模型结果的比较,验证了所建模型的有效性和准确性.     

CO_2激光边带光谱仪用于SF_6分子v_3带Q支吸收谱的研究

用绝对频率精度优于1.2MHz的CO_2激光边带光谱仪记录了SF_6分子v_3带Q支的多普勒受限吸收谱,光谱范围在CO_2激光10P(16)支线中心两侧,距支线中心8.0～12.4 GHz。用内插法以<6MHz的均方误差测量了百余条跃迁谱线的频率,并标识出Q_Z、Q_R、Q_X、Q_W、Q_A等亚支的谱线,量子数J从26到83。用最小二乘法拟合实验数据得到了v_3带的部分光谱常数。