Pitfalls in drying oils identification in art objects by gas chromatography

Drying oils identification in art objects is an important step in the scientific investigation of the artifact which provides conservators and art historians with valuable information concerning materials used and painting techniques applied. The present communication is devoted to pitfalls and troubleshooting in drying oils identification by means of GC-MS analysis of fatty acids composition in a microsample of an art object. We demonstrate that in the case of nonlinear instrument response the ratios of palmitic to stearic (P/S), distinctive for each oil type and used for drying oil identification, depend on sample dilution so that different dilutions of the same sample can give different P/S ratios. This phenomenon can hinder drying oil identification and lead to erroneous interpretations. This is an important observation as nowadays very often the P/S ratio is calculated from the corresponding peak area ratios or by the use of one-point calibration method. In these approaches, the linearity of the instrument response is not controlled and ensured. In the case analyzed, the nonlinear instrument response was attributed to incomplete sample evaporation in the injector. Packing of the glass liner with deactivated glass wool improved the sample evaporation and ensured the linearity of the instrument response and independence of the P/S ratio from sample dilution.     

Vacuum ultraviolet pulses of 11 fs from fifth-harmonic generation of a Ti:sapphire laser

We demonstrate that in a short Ar cell, generation of the fifth harmonic from 12 fs pulses at 810 nm directly results in ultrashort vacuum UV pulses at 162 nm. They have a spectral width of approximately 5 nm and a duration of 11+/-1 fs (1.4 times the transform limit), as measured by cross correlation with the fundamental pulses. Their energy (estimated to 4 nJ) turned out to be sufficient for use as a pump in time-resolved experiments.     

Detection of transgenes in soybean via a polymerase chain reaction and a simple bioluminometric assay based on a universal aequorin-labeled oligonucleotide probe

The recombinant photoprotein aequorin was used as a reporter in highly sensitive and automatable hybridization assays for the analysis of transgenic sequences in genetically modified organisms (GMO). The terminator of the nopaline synthase gene (NOS) from Agrobacterium tumefaciens and the 35S promoter sequence were detected in genetically modified soybean. The endogenous, soybean-specific, lectin gene was also detected for confirmation of the integrity of extracted DNA. A universal detection reagent was produced through conjugation of aequorin to the oligonucleotide (dA)₃₀. Biotinylated (through PCR) products for the three target sequences were captured onto streptavidin-coated wells, and one strand was removed by NaOH treatment. The immobilized single-stranded DNAs were then hybridized with oligonucleotide probes consisting of a target-specific segment and a poly(dT) tail. This allowed the subsequent determination of all hybrids through the use of the (dA)₃₀-aequorin conjugate as a universal reagent. The bound aequorin was measured by adding Ca²⁺ and integrating the light emission for 3 s. As low as 2 pM (100 amol per well) of amplified DNA was detectable for all three targets, with a signal-to-background ratio of about 2. The analytical range extended up to 2000 pM. As low as 0.05% GMO content in soybean can be detected with a signal-to-background ratio of 8.2. The overall repeatability of the proposed assay, including DNA extraction, PCR, and hybridization assay, ranged from 7.5–19.8%. The use of a (dA)₃₀-aequorin conjugate renders the assay configuration general for any target DNA, provided that the specific probe carries a poly(dT) tail.     

Advances in molecular techniques for the detection and quantification of genetically modified organisms

Progress in genetic engineering has led to the introduction of genetically modified organisms (GMOs) whose genomes have been altered by the integration of a novel sequence conferring a new trait. To allow consumers an informed choice, many countries require food products to be labeled if the GMO content exceeds a certain threshold. Consequently, the development of analytical methods for GMO screening and quantification is of great interest. Exponential amplification by the polymerase chain reaction (PCR) remains a central step in molecular methods of GMO detection and quantification. In order to meet the challenge posed by the continuously increasing number of GMOs, various multiplex assays have been developed for the simultaneous amplification and/or detection of several GMOs. Classical agarose gel electrophoresis is being replaced by capillary electrophoresis (CE) systems, including CE chips, for the rapid and automatable separation of amplified fragments. Microtiter well-based hybridization assays allow high-throughput analysis of many samples in a single plate. Microarrays have been introduced in GMO screening as a technique for the simultaneous multianalyte detection of amplified sequences. Various types of biosensors, including surface plasmon resonance sensors, quartz crystal microbalance piezoelectric sensors, thin-film optical sensors, dry-reagent dipstick-type sensors and electrochemical sensors were introduced in GMO screening because they offer simplicity and lower cost. GMO quantification is performed by real-time PCR (rt-QPCR) and competitive PCR. New endogenous reference genes have been validated. rt-QPCR is the most widely used approach. Multiplexing is another trend in this field. Strategies for high-throughput multiplex competitive quantitative PCR have been reported.     

Determination of fenthion and oxidation products in personal protection equipment by gas chromatography

A method for the co-extraction and simultaneous chromatographic determination of fenthion and its five oxidation products (or metabolites) fenoxon, fenoxon-sulfoxide, fenoxon-sulfone, fenthion-sulfoxide, and fenthion-sulfone in personal protection equipment (PPE) of pesticide applicators was developed and validated. Capillary gas chromatography-nitrogen-phosphorus detection was used for the analytical determination of all the aforementioned compounds over the concentration range of 0.1-0.5 microg/mL. All necessary validation criteria of the method were met. The method was found to be highly selective, accurate, and precise, gave satisfactory recovery (>70%) and RSD values (<20%) for fenthion and its metabolites in all tested specimens of personal protection equipment and in air samplers. The limit of quantification (LOQ) and linearity were determined for the most relevant PPE (i.e. inner coverall) for the parent compound and for the metabolites. The LOQ values ranged from 0.05 to 0.1 ppb while the linearity in the tested range of 0.1-0.5 ppm had r(2)>0.994 for all analytes.     

Occurrence of Disinfection By-Products in Swimming Pools in the Area of Thessaloniki,Northern Greece. Assessment of Multi-Pathway Exposure and Risk

This study investigated the occurrence of disinfection by-products (DBPs) (trihalomethanes (THMs), haloacetic acids (HAAs), halonitriles (HANs), halonitromethane (TCNM) and haloketones (HKs)) in different type of swimming pools in the area of Thessaloniki, northern Greece by employing the EPA methods 551.1 and 552.3. Moreover, general water quality parameters (pH, residual chlorine, dissolved organic carbon, UV₂₅₄ absorption, total nitrogen, alkalinity and conductivity) were also measured. The concentrations of DBPs showed great variability among swimming pools as well as within the same pool between sampling campaigns. HAAs exhibited the highest concentrations followed by THMs, HANs, TCNM and HKs. Exposure doses for four age groups (3–<6 y, 6–<11 y, 11–<16 y and adults) were calculated. Route-specific exposures varied among DBPs groups. Inhalation was the dominant exposure route to THMs and TCNM (up to 92–95%). Ingestion and dermal absorption were the main exposure routes to HAAs (40–82% and 18–59%, respectively), depending on the age of swimmers. HANs contributed up to 75% to the calculated cytotoxicity of pool water. Hazard indices for different exposure routes were <1, suggesting non-carcinogenic risk. Inhalation posed the higher carcinogenic risk for THMs, whereas risk via oral and dermal routes was low. Ingestion and dermal contact posed the higher risk for HAAs. Risk management strategies that minimise DBPs exposure without compromising disinfection efficiency in swimming pools are necessary.     

Measuring the effects of M&As on Eurozone bank efficiency: an innovative approach on concentration and credibility impacts

Annals of Operations Research - The present paper examines the Mergers and Acquisitions’ (M&amp;As’) effects on the European banking efficiency levels based on a sample of 43 listed...     

Functionalization of Biphenylcarbazole (CBP) with Siloxane-Hybrid Chains for Solvent-Free Liquid Materials

We report herein the synthesis of siloxane-functionalized CBP molecules (4,4′-bis(carbazole)-1,1′-biphenyl) for liquid optoelectronic applications. The room-temperature liquid state is obtained through a convenient functionalization of the molecules with heptamethyltrisiloxane chains via hydrosilylation of alkenyl spacers. The synthesis comprises screening of metal-catalyzed methodologies to introduce alkenyl linkers into carbazoles (Stille and Suzuki Miyaura cross-couplings), incorporate the alkenylcarbazoles to dihalobiphenyls (Ullmann coupling), and finally introduce the siloxane chains. The used conditions allowed the synthesis of the target compounds, despite the high reactivity of the alkenyl moieties bound to π-conjugated systems toward undesired side reactions such as polymerization, isomerization, and hydrogenation. The features of these solvent-free liquid CBP derivatives make them potentially interesting for fluidic optoelectronic applications.     

Per(6-guanidino-6-deoxy)cyclodextrins: synthesis, characterisation and binding behaviour toward selected small molecules and DNA

Per(6-guanidino-6-deoxy)-cyclodextrins , and are novel derivatives, resulting from homogeneous introduction of the guanidino group at the primary side of alpha-, beta- and gamma-cyclodextrins. The products were obtained from the corresponding amino derivatives, as direct guanidinylation of the known bromo-cyclodextrins provided mixtures. The new compounds were fully characterized by NMR spectroscopy and other analytical methods, and their interaction with guest molecules was studied. Strong complexation with 4-nitrophenyl phosphate () disodium salt was observed (K(binding) approximately 5 x 10(4) M(-1)), whereas the non-phosphorylated substrate nitrobenzene () formed a very weak complex. 2D ROESY spectra revealed cavity inclusion in both cases, however the orientation of was opposite to that of , such that the phosphate group is oriented toward the primary side facing the guanidine groups. The strong affinity of towards the phosphorylated guest suggested that interaction with DNA was possible. The new compounds were found to completely inhibit the migration of ultra pure calf thymus DNA during agarose gel electrophoresis, whereas no effects were observed with guanidine alone or with the plain cyclodextrins. Further, the condensation of DNA into nanoparticles in the presence of was demonstrated by atomic force microscopy, confirming strong electrostatic interaction between the biopolymer and the multicationic products . The strong guanidine-phosphate interactions between and DNA were therefore attributed to the clustering of the guanidine groups in the primary area of the cyclodextrin. Cavity effects could not be assessed.     

Styrene‐vinyl pyridine diblock copolymers: Achieving high molecular weights by the combination of anionic and reversible addition–fragmentation chain transfer polymerizations

Anionic and reversible addition–fragmentation chain transfer (RAFT) polymerizations were combined for the preparation of high molecular weight (MW) amphiphilic diblock copolymers based on the hydrophobic styrene (Sty) and the more polar 2‐vinyl pyridine (2VPy) or 4‐vinyl pyridine (4VPy). In particular, four amphiphilic Sty‐VPy diblock copolymers with MWs up to 271,000 g mol^–1 were prepared. For the polymer synthesis, first, living anionic polymerization of Sty using sec‐butyl‐lithium as initiator in tetrahydrofuran at ?70 °C, followed by termination with ethylene oxide were employed for the preparation of OH‐functionalized homopolyStys. Subsequently, a modification of the OH‐terminal group was performed by the attachment of a 4‐cyanopentanoic acid dithiobenzoate chain transfer agent (CTA) group, giving a polySty macroRAFT CTA, which was extended with 2VPy or 4VPy units using RAFT polymerization. Thus, the prepared diblock copolymers comprised a first block which was near‐monodisperse in size, and a second more heterogeneous block. All diblock copolymers were characterized in terms of their MWs and compositions by gel permeation chromatography and ¹H NMR spectroscopy, respectively, giving results close to the theoretically expected values. Films cast from chloroform solutions of the diblock copolymers were investigated in terms of their bulk morphologies using transmission electron microscopy, which indicated that the minority block consistently formed the discontinuous microphase, spherical or cylindrical. © 2012 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2013